Question about 2003 Nissan Sentra

Open Question

2003 nissan sentra inertia switch location - 2003 Nissan Sentra

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
chiquititas
  • 1010 Answers

SOURCE: 1996 nissan sentra

Find the big hose that comes out of the top of the radiator and follow it to the engine and that is where the thermostat is located. My advice is to be sure to get a factory thermostat and rubber gasket as it makes installation much easier. I have done it both ways and the factory one is easier to install.

Posted on Jun 29, 2008

Ad

SOURCE: need to bypass ignition switch on nissan sentra

it should be underneath your car in between the firewall and the engine. Now you don't want to supply direct power to your starter because you'll end up frying it. However to just start the car once you've located the starter, get a long screwdriver with a plastic handle and connect the two wires with the screwdriver.

As for a long term fix, without investing the money to replace the necessary parts. You will need to attach a wire that can handle 12v to both wires on your starter separately. Then connect the other ends of both wires to a switch that can handle 12v, and mount that in your car somewhere. Then whenever you need to start your car just flip the switch on until the car starts then once it is started flip it back off.
I know this sounds like a lot but it is very doable with about $5 and a little bit of time.

Posted on Jan 30, 2009

bitchn65cuda
  • 70 Answers

SOURCE: locate fuel filter on 2007 nissan sentra 2.0 liter engine

its in the gas tank but it doesnt have to be changed!!!YAY

Posted on Apr 25, 2009

  • 752 Answers

SOURCE: I have a 2003 Nissan Sentra SE-R Spec V. o2 sensor location?!?1

theres always one on the intake manifold working its way down to catalytic convertor is the oxygen sensor 1 heater circuit(pre cat conv) signal while terminal #25 is oxygen sensor 2 heater circuit (post cat conv)

Posted on Feb 12, 2010

johnjohn2
  • 5763 Answers

SOURCE: i need a fuse diagram for a 2002 nissan sentra

this is all i could find,the fusebox locations and fuse location #, but nothing about which fuse is which, i hope this will help,9064463.gifb2bc6d0.gif4587b25.giffac1af0.gifb6b500c.gif

Posted on Feb 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is the emergency inertia fuel switch located on a 2002 Nissan Sentra L.E. 2.5L


Nissan doesn't use this switch, that is Ford and Mazda. They use a Fuel pump opening relay. See picture. it will be under the hood in most Nissan's
26257957-gf4yqb5khmtclcrc2423q10o-4-0.jpg

Aug 12, 2016 | Nissan Cars & Trucks

1 Answer

Location of inertia for 2006 Nissan sentra


if you are referring to the fuel inertia switch there is not one. FORD is the only manufacturer that uses a resetable inertia switch for the fuel pump.

Jan 03, 2016 | Nissan Cars & Trucks

1 Answer

Switch inertia localizaci?n Nissan sentra 1993


Only Ford products use an inertia switch for the fuel pump.

Dec 19, 2015 | Nissan Cars & Trucks

1 Answer

96 Sentra wont crank fuel pump won't work where is inertia switch?


Usually located inside trunk. There will be a small access panel that needs to be removed to see the switch.

Apr 12, 2015 | 1996 Nissan Sentra

2 Answers

Where is fuel pump reset switch for 1998 sentra


Only Ford products have an inertia switch.
You would need to check voltage at the pump relay.

Sep 01, 2012 | 1998 Nissan Sentra

1 Answer

Got in a wreck and hit the front passenger side and now the car wont start.. engine isnt locked up and starter and batter are good. just asking what could be wrong?


Your problem is the inertia fuel shut off valve. Check your owners manuel and it will tell you where it is located reset the switch and your car should start. I hope my advise helps you.

Aug 10, 2010 | 2003 Nissan Sentra

2 Answers

2003 Nissan Sentra SE-R Spec V


I have the same car and I know there was a TSB for the ECM . I know the ECM issue has cause some cars to stall while driving

Jan 22, 2009 | 2002 Nissan Sentra

Not finding what you are looking for?
2003 Nissan Sentra Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...