Question about 1990 Chevrolet C2500

1 Answer

Won't start truck ran out of gas. replaced gas; wouldn't start. new distributor module, fuel pump, sending unit, pump relay, pump fuse, filter. spark from the plugs. truck simply won't start please help.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Well lxmccarthy, since you put a new fuel pump in, check a hose after the pump and see if any gas is being delivered. You can also try some starting fluid in the carb to get something going. There probably is just some air in the fuel line.

Posted on Mar 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Crown vic 2005 no start replaced fuel pump


check your crankshaft position sensor. fuel+spark+compression+timing=ignition.

Mar 13, 2014 | Cars & Trucks

2 Answers

I have a 1994 chevy s-10 pick-up. I just replaced the gas tank, sending unit and fuel pump. Still won't start Prior to doing this I tried to drive it last week. It started and ran for about 2 minutes and...


Check the distributor cap and rotor.... If they look originial or if there's any moisture inside the cap, replace both of them.
Make sure that if you do replace them that theres no moisture in the distributor before putting new parts in.

Oct 21, 2013 | Cars & Trucks

1 Answer

2000 blazer will not start did a manifold gasket job, replaced plugs, wires, distributor cap,new fuel filter. Cranked and ran really good for 2 days then will not crank


Check you starter, maybe you have a loose connection. Try to give direct power to the starter and see what's happening. I nothing happens, you have a bad starter.

Mar 16, 2013 | 2000 Chevrolet Blazer

2 Answers

94 chevy 1500 4.3 no spark no fuel


Sounds like you replaced alot of parts for nothing.
The pickup coil in the distributor "fires" the module which grounds the coil and the injectors.
Those components would need to be tested. The coil fires the plugs when the ground is removed by the module or the key switch.

Jan 08, 2013 | GMC C1500 Cars & Trucks

1 Answer

2002 chevy 3500 duramax 6.6 ran hot now cranks but won't start


Check spark plugs, leads, distributor cap & rotor arm, fuel pump, fuel filter, coil pack(s), relays, replace any items that are suspect IE Fuel filter which has probably not been changed since new even though they should be changed on all vehicles every 18 months, all of this can be done at home & will save you a lot of bucks in mechanic/garage fees,

Sep 21, 2012 | 2002 Chevrolet Silverado 3500

2 Answers

1994 honda civic will not start. New spark plugs and new fuel filter. The car will turn but not start. I have replaced clutch safety switch as well. lots of good gas on the tank. main relay and fuel...


REPLACE DISTRIBUTOR CAP AND ROTOR.AND PLUGS WIRES.IF GETTING NO SPARK TO PLUGS.CHECK SEE IF IGNITION COIL GETTING POWER.IF NOT CHECK IGNITION FUSE.IF POWER GOING TO COIL.FAULT EITHER COIL IS OPEN OR FAULT IN THE IGNITION MODULE IN THE DISTRIBUTOR.

Aug 23, 2011 | 1994 Honda Civic

2 Answers

My 95 s10 blazer w/4.3 vortex wont start again... 1st time last month coil went out ,i changed it ,start right up run for 2 weeks then quit running coasted to a stop in a parking lot thought i ran out of...


it could also be the fuel pressure regulator or fuel filter that is in line or mabey the fuel injection relay i no it will not start if that blows well i hope this help please give a good rating that you

Jul 08, 2011 | 1995 Chevrolet Blazer

1 Answer

My 2001 GMC Sierra just made a 600 mile trip. The next morning, the truck wouldn't start (full tank of gas). Replaced the fuel filter, banged on the gas tank. Tried to start the engine again, engine...


When your replaced the pump did you replace the fuel filter? You may have a fuel pump relay causing you some grief. I believe it is located in the engine compartment in the fuse center on the left inner fender. Check the relay and any related fuses. Check the electrical connection at the pump. They had problems with some of them and they would get kind of hot and distort and corrode. They have new updated ones that can be easily installed.

May 14, 2011 | 2002 GMC Sierra 1500

1 Answer

Xterra car quit running. had no spark @ distributor. replaced crank sensor and got spark. no gas pressure. replaced fuel pump, new one do not work. no power to it. checked fuses/relays, no luck. ran...


the fuel pump fuse is fuse #1 15amp in the inside fuse box ( left side of dash behind fuse box cover ) the fuel pump relay is behind left side of dash ------- cavity #2 & #5 at the relay should have battery voltage in start and run cavity # 3 is the power out to fuel pump and cavity #1 is the ground that is turned on by the on board commputer.

Jan 15, 2011 | Nissan Xterra Cars & Trucks

1 Answer

Xterra car quit running. had no spark @ distributor. replaced crank sensor and got spark. no gas pressure. replaced fuel pump, new one do not work. no power to it. checked fuses/relays, no luck. ran...


Yes, there is fuel pump relay, which is generally located on the passenger side kick panel. But in your case, the fuel pump relay on 2002 model Xterra is indeed located under the dash around the steering wheel, but no you don't need to remove the cover just lay in floor and you can see it, it will slide off a bracket and you can remove and replace it.
Good Luck!

Jan 15, 2011 | 2002 Nissan Xterra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

163 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...