Question about Cars & Trucks

Open Question

Replace water pump on 07 gran prix - Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

CMV9
  • 594 Answers

SOURCE: replace water pump 93 grand prix

here is a step by step instruction on how to replace your water pump. please do not forget to rate and comment about your experience today with fixya.

  1. Disconnect the negative battery cable.
  2. Remove the air cleaner assembly.
  3. If necessary for access, remove the coolant recovery reservoir.
  4. Partially drain the coolant, into a suitable container, to a level below the water pump.
  5. If equipped, remove the serpentine belt guard/cover.
  6. Remove the serpentine belt.
  7. Remove the retaining bolts, then remove the water pump pulley.
  8. Unfasten the 5 water pump attaching bolts, then remove the water pump and gasket. Discard the gasket.
To install:
  1. Thoroughly clean the water pump mounting surfaces.
  2. Position a new gasket, then install the water pump.
  3. Install the attaching bolts and tighten them to 89 inch lbs. (10 Nm).
  4. Install the water pump pulley.
  5. Install the serpentine belt and belt cover/guard (if equipped).
  6. Refill the cooling system with the specified type and amount amount of engine coolant.
  7. Install the air cleaner assembly.
  8. Connect the negative battery cable, then start the engine and check for coolant leaks.

Posted on Apr 17, 2009

  • 451 Answers

SOURCE: How do replace heater core in 2002 Pontiac Gran Prix

i do believe you have to take the passengers side dash apart behind the glove compartment. go to autozone and get a manual or go to the library and check the chiltons manual. this is not an easy job. how bad is the leak? if its not bad these heater cores are made of all aluminum. i would buy a bottle of that radiator additive and see if that takes care of the problem first. it only cost about 5 bucks a bottle and it may permanantly fix your problem.

Posted on Aug 13, 2009

motor1258
  • 6674 Answers

SOURCE: labor time to replace a faulty water pump in 05 Gran Caravan 3.8

Try (repairpal.com) for estimate for your particular area. You may have to enter Grand Caravan to get the 3.8L engine .
I'm thinking 2 hrs.

Posted on Oct 05, 2009

  • 18 Answers

SOURCE: 2008 Pontiac Gran Prix,Radio MP3 line-in/aux-in

The upscale model is the only that i know of that has one. What model do you have?

Posted on Oct 16, 2009

BCAS1298
  • 3092 Answers

SOURCE: leaking water from heater core 1999 gran prix

If leaking coolant under dash on passenger side floor broad it's your heater core. Call's for 2.8 labor flat time to remove heater core, in some case's you'll have to recover, evacuate and recharge your A/C system to remove your heater core.Sit under dash on passenger side.

Posted on Dec 28, 2009

Testimonial: "thank you for the info appriciate very much"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 97 gran prix super charged GTP I have water leaking from under the water pump area and spits a little water from the top is it my water pump


Yes.. it probably is your water pump.. There is a small hole under the shaft that is meant to leak when the seal/bearing goes bad.. you cannot fix this.. it requires replacement.

Jun 07, 2014 | Cars & Trucks

1 Answer

On a '06 Pontaic Gran Prix - I cannot get the bottom right bolt out to remove water pump. How do i move idler pulley?


To get that last bolt out you need to move the power steering pump out of the way. Just remove the two bolts holding the PS pump and push it aside. You don't have to remove the pump hoses you just need to move it an inch towards the firewall.

Apr 09, 2014 | 2006 Pontiac Grand Prix

1 Answer

My 2000 gran prix gt is dieing while driving it


replace fuel filter if that doesn't fix problem pressure check fuel pump replace if needed

Sep 01, 2013 | 2002 Pontiac Grand Prix

1 Answer

2002 gran prix sunroof leak


Drop the headliner & put drain hose back on

Nov 20, 2012 | Cars & Trucks

2 Answers

Trying to replace water pump can get to last bolt at power steering pump pulley interference 2004 pontiac gran prix gt 3.8


Check this procedure for Pontiac 3.8L Engine - Water Pump
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Drain the engine coolant.
  3. Remove or disconnect the following:
    Negative battery cable. Drive belt Water pump pulley Power steering pump and move it aside Water pump

    zjlimited_668.gif

    Fig. Exploded view of the water pump assembly mounting-3.8L engine

To install:
  1. Install or connect the following:
    Water pump using a new gasket and torque the long bolts to 25 ft. lbs. (34 Nm) and the short bolts to 16 ft. lbs. (22 Nm) Water pump pulley and torque the bolts to 115 inch lbs. (13 Nm) Power steering pump and torque the bolts to 25 ft. lbs. (34 Nm) Drive belt Negative battery cable
  2. Fill the cooling system.
  3. Start the vehicle and check for leaks, repair if necessary.
Hope helps.

Sep 02, 2011 | 2004 Pontiac Grand Prix

2 Answers

THE THERMOSTAT HAS BEEN REPLACED VEHICLE STILL DOES NOT WARM UP/2006 pONTIAC GRAN PRIX



Are the fans running all the time. If so there is a control problem

Nov 30, 2010 | 2006 Pontiac Grand Prix

1 Answer

Leaking water from heater core 1999 gran prix


If leaking coolant under dash on passenger side floor broad it's your heater core. Call's for 2.8 labor flat time to remove heater core, in some case's you'll have to recover, evacuate and recharge your A/C system to remove your heater core.Sit under dash on passenger side.

Dec 28, 2009 | 1999 Pontiac Grand Prix

1 Answer

Have 94 gran prix 3100 car would run by spraying gas in intake reaplaced engine crank sensor in back now acts out of time checked plug wires ok firing order ok help?


first i would replace fuel filter if this dont do it.
. fuel pump may not be good check fuse for pump
you should hear the pump running when key is on

Apr 19, 2009 | 1994 Pontiac Grand Prix

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...