Question about GMC C1500
Posted by Anonymous on
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 2007 gmc sierra 2500 IAT sensor
Well, the IAT (Intake Air Temperature) sensor is located on the air intake duct between the filter and the throttle body (Assuming you have the 6L motor). The wires are easily visible at the plug that connects the sensor to the wiring harness. That's the easiest place to access them.
Posted on May 18, 2008
SOURCE: spark plug wiring diagram
I dont understand why you would need that unless you took off all the wires and took out all the plugs and forgot how the wires were.I have the same truck and I always do the plugs and wires one at time to make sure I make a mistake.If this is your ploblem let me know because i might be able to walk you though it.
Posted on Jan 22, 2009
remove cover.take off back wheels and calipers (or drums).turn differential to where you see small bolt/pin (5/16) horizontally (same direction as axles)on right side of differential.remove bolt/pin.A large pin (about 5"long 3/4"diameter) should slide out differential with ease ( you may have to tap one side of the large pin).turn differential to completely remove large pin.turn differential so you can see in the view window.push each axles in (they'll go in about 1 1/2"each) You may hear one of the axle C-clips fall.If not use a small telescoping magnet to remove the C-clips from the axles through the differential window.pull each axle out about 10"so they are out of the diff.Now remove the cap bolts(4-5/8"bolts) and remove the caps(mark the caps so they go in excactly the way they came out.be careful the diff might fall out.If not you may have to use a long bar or 2x4 to wedge and pry the differential out. Have a basket/crate w/rags in it to catch the diff.TIP:If you are removing the ring gear from the diff, the bolts are left handed bolts meaning you have to turn them clockwise to loosen and counter clockwise to tighten ; )
Posted on Sep 15, 2009
Testimonial: "thank you helped ALOT perfect instructions "
The switch or the wire harness at the blower motor has gone bad. The highest setting 5 has no resistor, so the blower runs on high but the high current flow ends up burning up the switch's contact on that setting or the resistor wire harness at the blower motor has gone bad. Common would be the switch it self, if the switch is good. Then it's going to be the wire leads at the speed resistor by the blower motor under the glove box by the passenger leg compartment. Keep me posted, be glad to help you get your Sierra running 100% again soon.
Posted on Jan 06, 2010
Tips for a great answer:
Jul 26, 2015 | 2004 GMC Sierra
Jun 09, 2011 | 2003 GMC Sierra 1500
Jun 09, 2011 | 2004 GMC Sierra 1500 Crew Cab
Mar 13, 2010 | 2008 GMC Sierra 3500HD 2WD
Apr 22, 2009 | 2007 GMC Sierra 1500
Dec 15, 2008 | 1993 GMC Sierra K1500
81 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: