Question about 2007 Ford Escape Hybrid FWD

1 Answer

My Acer(Aspire)RC415T has no beep & has it IDE led on

When you power it on the processor fan goes so fast which is not normal hence makes o march noise and also the IDE led (red) becomes on and there is no beep at all.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I cant find my on board drivers to acer aspire mother board

Posted on Aug 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When i push the remote start my 2009 Ford Escape beeps and the lights flash and the horn beeps as normal but then the truck does not start but the lights all flash and then the horn goes 4 times but i


Troubleshooting Gen 2 Remote Start Systems (Ford Factory Installed Remote Start)
• 2 beeps - hood open, or brake pressed
• 3 beeps - door open (Gen 2 systems monitor the door ajar
wire)
• 4 beeps - Tach not programmed (if running tachless, make
sure the tachless feature is enabled)
• 5 beeps - Key In Sense (thinks key is in the ignition
• 6 beeps - Service mode (the LED will give you a blink,
blink, pause pattern.)

You can bring it to a dealer to reprogram.

Jan 07, 2015 | 2009 Ford Escape

4 Answers

LED's hyper flashing


Make sure LEDs are fitted with correct polarity direction.
An L.E.D. is a special type of diode and is similar to a transistor. Diodes and transistors are "solid state" devices that are made from semiconductors such as silicon. The semiconductor is made to contain two types of special impurities. The first type of impurity, calL.E.D. "N" for negative, is a material with an excess of electrons. The other type of impurity, calL.E.D. "P" for positive, has a deficiency of electrons in "holes." These two kinds of impurities are dispersed into the semiconductor at different regions, so that a "P-N junction," or active layer, is created at the border.

d4cf585.gif

Jul 27, 2008 | 2007 Mercury Grand Marquis GS Sedan

1 Answer

When failed trun signal bulb, Jeep turning signal is fastly blinking. I changed rear turn signal bulb with LED bulb, but turn signal blinking speed doesn't go to normal, At first couple of seconds it is...


Try replacing with the same bulb type as was failed. Flasher unit isusually reliant on resistence from the bulbs to what speed that side will flash at when powered.Some of these led type have less resistence and that equates to a faster flash speed.That is why when one bulb blows that side will flash faster or may even stay on without flashing.You could even swap the led to the other side( to confirm.Check with the bulb retailer to whether they have those bulbs with a higher rated resistence in led.If this vehicle has leds as standard,you may need to get the correct type from dealer. Hope this helps or get back with findings if it still has fault after replacing bulb.

Mar 29, 2011 | 2009 Jeep Patriot

2 Answers

I have bought a Ford Fiesta Zetec 1.25 ( Model May 2010 ). Have noticed that the fan switches on and off frequently - even after a short drive in cool ambient temperatures. Is this normal ?


Hello,
The problem you are experiencing with your car is as a result of the fact that the fuse which supplies power to the fan from the main source(battery) is working eppileptically which means its failing in discharging power.

1.The solution is to open the fuse box and replace the fuse which controls the fan.
2.If the problem persists it means the problem is from the relay switch,which means the relay switch has to be replaced.

Problem solved.

Thank you for using fixya.





Mar 14, 2011 | Ford Fiesta Cars & Trucks

1 Answer

Cooling Fan Spinning Fast On A Cold Start


most fans are clutch fans and they work or are engaged by temp.most all will spin under really cold conditions.this is normal.but to be sure, with the motor off and key in your pocket grab the fan and see if it wiggles or has any slop. if not alls good

Dec 20, 2009 | 2007 Chevrolet Colorado (Extended Cab) New...

1 Answer

My Acer Aspire laptop needs service in Delft


Sounds like the CPU is overheating. Try cleaning with canned air. On the bottem of the laptop you can see a fan with laptop off and battery removed use a whole can of air to clean it. wait 5 min. replace battery and try normal start up. listen for the fan to come on if it doesn't the fan is bad and needs to be replaced
Hope this helps
Please leave feed back

Dec 03, 2009 | Cars & Trucks

1 Answer

1997 ford explorer overheating but no gurgling and cools back down when heater is turned on . not loosing any coolant. does not seem to do it at idle but as soon as you start moving it goes up and when it...


Make sure the cooling fans are working when the engine reaches above normal temp,if they are not ,turn the ac on,and see if the cooling fans come on,if so,replace the coolant temp sensor,if it has a clutch fan,then replace it,for it is not staying engaged ,and is not turning fast enough to cool the radiator.

Nov 29, 2009 | 1997 Ford Explorer AWD

1 Answer

Humming noise from engine fan


the trailblazers have a issue with the fan clutch. it normally has to be replaced. ide take it to a dealership. its not a easy task to replace the fan clutch if thats the problem.

Jun 18, 2009 | 2007 Chevrolet TrailBlazer SS

1 Answer

Overheat, and running fan


check your oil and coolant level to be on the safe side but it sounds like everything is normal if there is no airflow across the radiator the fan will operate when the engine gets hot even with the engine off

May 01, 2009 | 2003 Mini Cooper

Not finding what you are looking for?
2007 Ford Escape Hybrid FWD Logo

Related Topics:

654 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...