Question about 2007 Toyota Yaris
I love my Vitz / Yaris in every way, shape, handling, feel, facilities, economy etc. There is ONE loud snag only. Its engine 'roars', and I found it has 3 cylinders, compared to 4 cylinders on older Vitz 990cc. The noise and vibrations coupled together are irritating me. A friend had an extra MUFLER installed; the workshop I go to recommend removing Catalytic Converter and installation of a mufler instead. They say this will improve pick up, which is not bad already. Its just the noise, which is like a 'diesel' car. Please help or comment.
recommend headers, with 2 1/2 inch true duel pipes, feed it to an aftermarket
cat, a must have, with all O2 sensors, then run Your pipes into some cherry
bomb glasspacks, then run it out to either comming out just in front of or
just behind the tires, with a turndown right before the quarterpanel wall.
Posted on May 14, 2008
caster,camber and, wheel bearings
have your car 4 wheel aligned this will adjust your rear caster and, camber.
have your wheel bearings checked
Posted on Sep 06, 2009
NO, a cat only cleans up pollutants. It has no effect on engine performance unless you have a misfire and the cat works overtime and melts and cloggs the exhaust system. If your blowing grey smoke out the tailpipe then you indeed may have a bad engine. What I would want to know from the mechanic is what is the compression and why he thinks its a lower engine issue rather than a leaking valve on the head which would be alot less expensive to repair. Then again you could get a second opinion from another shop. Mechanic shops are known for gouging customers wallets, Not that i'm implying anything here.
Posted on Jul 31, 2010
Testimonial: "thank you for your quick reply!"
SOURCE: Looking for the OBDll connector
Look under the dash near where the steering wheel is usually located (on the driver's side).
Was this vehicle marketed in the U.S.?
1996-97 MODELS NOTE: These models require the use of the Toyota's hand held scan tool or an equivalent OBD II compliant scan tool.
NOTE: When the diagnosis system is switched from the normal mode to the check mode, it erases all Diagnostic Trouble Codes (DTC) and freeze frame data recorded. Before switching modes, always check the DTC and freeze frame data and write them down.
Posted on Oct 05, 2010
Tips for a great answer:
Oct 24, 2015 | 2008 Toyota Yaris 1.5
Apr 17, 2013 | 2007 Toyota Yaris
Feb 11, 2011 | Toyota Yaris Cars & Trucks
Oct 06, 2010 | 2007 Toyota Yaris
Jun 06, 2010 | Toyota Yaris Cars & Trucks
Feb 05, 2010 | 2007 Toyota Yaris
Jun 09, 2009 | 2007 Toyota Yaris
Sep 30, 2008 | 2007 Toyota Yaris
334 people viewed this question
Usually answered in minutes!