Question about 2011 Ford Fiesta

Open Question

Window Washer jets arent spraying on my ford fiesta 2011.

When i pull the stalk back i CANT hear the pump trying to work yet the wipers work.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
pakis
  • 86 Answers

SOURCE: Window washer not working. Ford focus diesel 2001

check under your washer reservoir.

Posted on Nov 25, 2008

Ad
chrischronic
  • 235 Answers

SOURCE: windshield washer will not work even though the wipers do on a fo

check the fuse, if its ok youre gonna need a new pump.

Posted on Jan 15, 2009

  • 1 Answer

SOURCE: Windshield washer Pump doesn't run, but the pump checks out good

there is another small relay box just below the windshield washer reservoir about 11/2" wide x about 4" long the washer pump relay is in there



Posted on Jan 21, 2009

  • 811 Answers

SOURCE: 2002 Ford Explorer back drivers side window will not go up

check for worn, broken or disconnected  linkage between motor and window, take door panel off 

Posted on Sep 29, 2009

dmftrucker
  • 1922 Answers

SOURCE: Washer wiper not working, possibly used when

the fuse is the same as for the wipers and push on washer switch and see if you can hear washer pump run,otherwise try this (unless the motor pump has been dry run too long and ruined pump assy) and can't pump any longer go to a garage that has compressed air and at the wiper nozzles first gently blow air into each nozzle, then go to reservoir and remove supply hose to wiper nozzles and blow air gently and see if there's an obstruction in the line, you can use say 30 lbs max,reason being if any hoses where you cant get to them they can blow off fittings, also take air hose and on top of reservoir blow into hole on top of reservoir to push product thru lines and help pump (same as removing hose) on reservoir, I bet its unprimed itself or blocked with dirt,try this first

Posted on Oct 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When starting wipers came on and stay on no matter of position of control, washer fluid over head dome light won't turn on, rear washer and whiper won't work.


Wipers won't turn off......sometimes! - Ford Truck Enthusiasts Forums

www.ford-trucks.com > ... > Diesel > 6.7L Power Stroke Diesel
Feb 3, 2014 - Starting around 25,000 miles my wipers stayed on the slowest intermittent setting even when ... They only two that come to mind is the switch inside the cab or the wiper motor control board. ... The wipers do not park at the correctposition ... It doesn't really matter what steps need to be taken to fix the issue.

Window washer fluid put in window washer won't work now.

www.cargurus.com > Questions > Kia > Sorento

CarGurusAug 31, 2015 - Window washer fluid put in window washer won't work now. ... 4 answers. wipers working, not the washer though, pulled pump, intake screen clean. 2011 Kia Sorento Base ... Interior lights do not work when door is opened 7 answers. At first the back seat overhead light stopped working. Kia said it would ...

Nov 26, 2015 | 2011 Dodge Durango RT

1 Answer

Hi My windscreen washer doesn't work. I pull the stalk and nothing happens. The wiper action does work but the jet function doesnt. I have a 2003 aero. The washers were working and then stopped on my way...


Assuming the washer fluid is topped up, can you hear the washer motor buzzing? If you can then could be jets blocked or pipe come off! Is there water leaking under car?

Jan 24, 2015 | Cars & Trucks

1 Answer

My windshield wipers wont shut off on my 2011 Ford Transit Connect


Usually the problem is inside the wiper motor. If you can see any contact points or can spray a little WD40 on what you see, it may help. Sometimes backing off the mounting screws and retightening them will allow the grounds to be reestablished.

Feb 26, 2014 | 2011 Ford Transit Connect

2 Answers

Window washing fluid pump isn't working. Hums and runs, but no fluid comes out. Any ideas?


1. the washer fluid jets are plugged possibly and will not allow fluid to discharge. Take a small wire or needle and stick into the jet end where the fluid comes out and it should spray after that if that is the issue.
2. the lines coming from the washer pump could be broken or cut open. Remove the line at the back of the spray jet either at the hood or at the wiper arm, then attempt to spray the wiper fluid. If it does not spray then there is an open/broken line coming from the washer pump or the pump may have a problem. If fluid is coming out of the line, the jet again is plugged up. Also check to see that fluid is going into the washer pump (locating the pump and getting to it is sometimes not so easy depending on where the mfg put the pump).

Jan 18, 2013 | 1986 Buick Century

4 Answers

My 2004 Ford Expedition will not spray windshield wiper when the button is pushed. The wipers do turn on, but no spray. Would this be caused by a fuse (the wipers do turn on) or is the motor bad?


Can you hear the washer pump running when you operate the washer switch? The washer pump is in the bottom (side) of the washer fluid reservoir. You should hear it running. If not, you can disconnect the wire connector at the pump and use a test light to check to see if there is power and ground at the connector when you operate the switch. If there is power and ground, replace the washer pump motor. If there is no power or ground, you most likely have a bad washer control switch. (You have to replace the entire Multifunction Switch)

If you can hear the pump running, check for washer fluid pouring on the ground. If this is the case, you have a broken hose between the washer pump and the jets that spray on your windshield.

Also note that there is no way possible that your problem could be CAUSED by a fuse!
For more information on this subject, please review this article: Where's The Fuse?

May 17, 2011 | 2004 Ford Expedition

1 Answer

Wipers working when you pull on stalk to wash


while someone is pulling the stalk, use a meter or test light to check for voltage at the washer pump, located on the bottom of the washer fluid reservoir. if there is voltage, the pump is bad. if no voltage, it may be a fuse, bad switch or a break in the wiring.

Feb 05, 2010 | 2003 Volkswagen Passat

1 Answer

Washer wiper not working, possibly used when


the fuse is the same as for the wipers and push on washer switch and see if you can hear washer pump run,otherwise try this (unless the motor pump has been dry run too long and ruined pump assy) and can't pump any longer go to a garage that has compressed air and at the wiper nozzles first gently blow air into each nozzle, then go to reservoir and remove supply hose to wiper nozzles and blow air gently and see if there's an obstruction in the line, you can use say 30 lbs max,reason being if any hoses where you cant get to them they can blow off fittings, also take air hose and on top of reservoir blow into hole on top of reservoir to push product thru lines and help pump (same as removing hose) on reservoir, I bet its unprimed itself or blocked with dirt,try this first

Oct 13, 2009 | 2006 Ford Focus

1 Answer

No wiper fluid is spraying out when I activate the wiper wash


WHEN YOU TURN ON WASHERS CAN U HEAR THE PUMP WORKING IF YOU CAN IT WILL BE
BLOCKED WASHER JETS OR LINE OR WASHER PUMP IS FAULTY.

Dec 17, 2008 | 2003 Honda Civic

2 Answers

Wiper washer


You didn't mention any lost fluids so we can assume that no hapless mechanic has accidentally pulled any tubing loose from the supply. 
If, as in many cars, the path of the tubing connecting the washer fluid bottle to the jets on the cowl are visible, carefully pull one the tubes loose and have someone operate the washer to see if the pump is doing anything any more. You may be able to find the 'Y' junction where the tubes split off to feed the two jets.
The rear window washer has its own fluid supply and pump so is completely independent of the front.
If you find the pump working, then you will have to carefully poke a soft, small gauge wire, preferably copper, to try to clean the jets themselves. You probably have some small bits of something clogging the jets and it can help if someone is keeping the washer pump running while you try to clear them as the pressure will aid you.     
Worst case, the jets can often be replaced fairly easy and at a cost of a few dollars. 

Sep 21, 2008 | 1997 Ford Escort

Not finding what you are looking for?
2011 Ford Fiesta Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...