Question about Honda Cars & Trucks

1 Answer

My car keeps makn a tickin noise when i turn leftd but had cvs done please help what ths might be

Posted by on

  • sharmaine doyle Jan 20, 2013

    un it at the front leftd side of the car



1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.


    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

That could be your leftside axle..the boot pn the axle could be broken and.all the grease came out.

Posted on Jan 20, 2013

  • sharmaine doyle Jan 20, 2013

    um it the front of the car an every time go left it does it



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 06 Sonata it makin a real bad tickin noise its a 2.4 4 cylinder how could i make that tickin go away

Usually indicates low oil pressure. Changed oil lately? Use manufacturer recommended oil only.

Jul 16, 2014 | Cars & Trucks

1 Answer

The catalyst may b messed up. car shootin out oil, and making a loud tickin noise

SHOOTING OIL OUT??? from where?
ticking noise is most deffinately rocker arm sound/lifter tap.

Apr 06, 2012 | 2002 Dodge Stratus

2 Answers

Making ticking nosies and does not start

If it makes ticking noises and does not turn over the engine it usually means the battery is either low, defective or the battery terminals need cleaning.

Nov 23, 2010 | Audi A4 Cars & Trucks

1 Answer

Car makes noise like a dry wheel bearing only when turning right-rotating tires makes less noise for a while but is still there and steadily gets worse. Nothing is loose in the front end-noise has been...

Look again under the car. Check the CV joints on the side making the noise.

CVs are cover in a rubber "boot" and contain grease the lubricates the joint. Look to see if the boot is torn. If so the grease is lost and the joint will wear and make the exact noise you describe.

Start there as it is a simple and likely issue from your description.

Hope this helps

Feb 27, 2010 | 2004 Volkswagen Jetta

1 Answer

Tickin noise after i use my directionals...

It appears you have a failing flasher module. I hope this helps.
Thank You,

Aug 06, 2009 | 2000 Pontiac Grand Am GT

1 Answer

Type of gas used in a/c and does it need oiling up because of ticking noise when compresser is on

Freon is not used. It should be R134-A Suva. It would only need more oil if it was leaking. Has it been serviced recently?

May 21, 2009 | 1999 BMW 318 ti

1 Answer

Theirs a tickin noise when i put the shoe down it could be da tappeds but can thez be tightend

Well it can probably be tightened ,but it is an overhead cam engine ( i have the same car) so unless you,ve done it before i would suggest taking to a pro.You could simply be too many miles on your oil .Once the oil loses viscosity it doesn,t lube the top of the engine very well .Do an oil change and use an oil additive for sticky/noisey lifters.

May 01, 2009 | Honda Civic Cars & Trucks

1 Answer

Starting problem

Sounds like starter motor or there is a switch for the gearbox this does fail

Apr 12, 2009 | 1987 Mitsubishi Passenger

2 Answers

Fiat Multipla

This could be your water pump. The faster your engine turns, the worse the noise gets. Check the water pump for leeks. Turn the engine by hand (put a spanner on the crackshaft holding nut and turn) and listen for the noise. This will point the faulty componant. As for the square, if it is on any metal part it may need a welding repair. Without seeing the hole, I can be no clearer in my advice on the hole.

Nov 07, 2008 | Fiat 124 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides