Dont know where to put the screen wash in my smart car

You can get guide from many sites.. i know few
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassemb ly, complete refurbish, repair, installation every single thing is covered
within seconds u can get the access and it's totally illustrative complete

DONT KNOW

put a pin into the jet in case it is blocked.

its ok...its water based,but if you want to remove it,under the radiator there should be a purge valve remove it let the liquid exit,replace the valve fill the radiator with coolant,start the engine,turn heater to max,turn ac to max on heat,allow it to reach normal running temp and refill if necessary

i dont now

its a smart car luv,just ask it. if both handles do not work you have to get a slim jim and go between the window and door. you know,the crook way... watch out for the wires dont pull any.

I would not recommend putting water on any part of the engine. Unless you know what your doing. Could cost big bucks.

dont know much about them cars but if the fuse is good its most likely the wiper motor

screenwash is at the front and coolant at the rear??? under the engine cover in teh boot(trunk)

Hi.

The oil reservoir access is hidden below a panel, see the procedure here: Smart Car Oil Change