Question about 1995 Ford Mustang

Open Question

Glove box won't close - 1995 Ford Mustang

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sunroof not closing isuzu bighorn


OK given that this won\'t help the original enquirer but for all those who like me have had this prob and found themselves here well here\'s a solution that\'s not complex on all isuzu trooper/bighorns mk 2s ( as far as I know) early 90s have a manual over ride . You need a coin or flat head screwdriver and a 6mm Alan key. Now look above the the back seats in the middle you will find a little bung use coin / screwdriver to turn it out don\'t dig it out. Inside you will find a small Alan bolt turn with Alan key to open or close sunroof (Isuzu hand book 1992 page 4_17) PS there is a tool for the job located in the glove box if you still have it!!

Nov 16, 2013 | Cars & Trucks

1 Answer

How can i remove my 2005 honda element glove box , it won't open at all


Remove side clips holding the glove compartment into the console and unhook the elastic string that guides the compartment. -------------------------------------------------------------------------------
Super VAG K+CAN V4.8

Apr 03, 2013 | 2005 Honda Element

1 Answer

How do i remove the glove box in a saturn ion?


Here are instructions on how to remove a glove box on a Honda Accord: 1. Remove these items: Dashboard center lower cover and Passenger's dashboard lower cover. 2. Remove the screws from bottom of the glove box. 3. Wrap a flat-tip screwdriver with protective tape, and apply protective tape around the related parts, to prevent damage. Insert a flat-tip screwdriver in the notch of the cap, and release the hooks by prying up the cap. 4. Remove the screws. 5. Release the hooks, then pull down on the-------------------------------------------------------------------------------------
VVDI VAG Vehicle Diagnostic

Mar 23, 2013 | Cars & Trucks

2 Answers

Glove box light won't turn off


Check around the area that the glove bx contact when you closed.
There is a tiny switch there (spring load kind push in and out).
-If you find it, push or press in by hands to see if it off or not.
-If off.>>> You need to adjust the glove bx door to push in when it in closed position.
-If it's not.>>> Replace the switch.

Mai Lor

Feb 24, 2013 | 1988 Dodge Dakota

2 Answers

Car won't start if glovebox is closed


It's hard to say but sounds as if you got a short somewhere. I'd start by seeing what wires are running behind the glove box and go from there.

Jul 11, 2012 | 2002 Chrysler PT Cruiser

1 Answer

Fuel door won't open


Fixed. In the glove box there is a vallet button. I pushed it and now my trunk and fuel door work. and what this has to do with my trunk and fuel door not functioning , I have no idea. Hope this helps someone else.

Apr 05, 2012 | 1998 Cadillac DeVille

1 Answer

2009 toyota corrolla glove box wont close


First thing is first, remove the lightbulb in your glovebox before you kill your battery. On the door of the glovebox, where it locks onto the piece sticking out of the glovebox, wiggle that whole piece, and see if it's loose. If it is, take a screwdriver, and tighten it. It may have just loosened itself from regular use. If it's loose, it won't lock onto the piece because it's just moving up or down when you try to slam it shut. Hopefully this works! Either that, or go to a junk yard, and get that peice out of another car. Simple fix for little money.

Mar 25, 2012 | 2000 Toyota Corolla

2 Answers

Location of cabin filter of 1998 mercury marquis.web site won't let me enter the proper year???


usually behind the glove box. see if the glove box can be tilted forward to be removed. if so, the filter is behind it. if not, could be outside of car, passenger side, under the plastic piece between windshield wiper and windshield.

Jul 24, 2011 | 1998 Mercury Grand Marquis

2 Answers

How does glove box come off to replace air cabin filter ?


First, take a good look at what you’re doing.
Look on the right side of open glove box and locate a plastic lever. You will see grooves on the end connected to the glove box. The grooved area is the spot to place the thumb in order to press this lever off the glove box when it comes time to do that.
Look up under the glove box. You will see two brass colored screws one on each side of the bottom of the glove box. These screws go up through two square plastic hinges that are attached to the glove box and into the the dash frame.
Okay, with the glove box closed remove the two brass colored screws, and put them aside so you won’t lose them..
Open the glove box and hold the glove box with your left hand and press on the plastic lever (grooved area) located on the right side of the glove box. This lever (the lever already mentioned above) is slotted and will pop off the glove box.
Put the glove box carefully aside.
Look straight in behind the glove box. You will see a rectangular black plastic cover approximately 1.5 inches wide by 8 inches long. On the right and left side are arrows pointing in. Press the arrows and pull out on the cover. This will slide out the tray that holds the filter. Remove old filter and insert the new one, flow arrows pointing down.
Retrieve glove box, hold in place, and attach plastic plastic lever to the right side of the glove box. The reverse of removal.
Next, the two plastic hinges located on the bottom of the glove box fit underneath the dash frame.
While holding the glove box in place (the glove box latch may hold glove box in place while installing screws) re-install the two screws through the plastic hinges into the frame and tighten.
Hope this helps you.

Oct 30, 2009 | 2004 Honda Accord

1 Answer

Lower Glove Box Won't Close


I fixed this in a 2010 Rav4 by lowering the glovebox all the way and finding that the cover to the cabin air filter had fallen off and was jamming the hinge of the glove box. To lower the glove box, pull the glove box side walls inward until the lock tabs clear the sides of the opening and you can rotate it all the way down. Clear whatever is jamming the hinge and rotate the glove box back into position. Be sure the hinge is pushed all the way forward onto the corresponding pin before closing the glove box, otherwise there will be misalignment. There is also a plastic air piston on the right side of the glove box assembly that damps the movement of the glove box. Be sure the piston assembly is secured into the two corresponding locking pins (one on the glove box, the other on the glove box opening) before closing the glove box.

Jul 08, 2009 | 2007 Toyota RAV4

Not finding what you are looking for?
1995 Ford Mustang Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...