Question about Chevrolet S 10

1 Answer

I have a 1995 chev S-10....when i turn on my lights on i have no tail lights. But when i turn on my turn signal both tail lights flash untill i cut my headlights on then they go out?????????????????

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Not saying this is the answer but i had same proble,s when i plug in my trailer lights and it turned out to be my harnes on truck as it was a hanger of a plug and caused a short i would look at your plug

Posted on Jan 20, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76118 Answers

SOURCE: 1995 Dodge Dakota headlight problems

I will assume you have tested the bulbs, if so replace the head light switch, make sure the connector is not melted or burnt, if it is you will need to buy a kit from Dodge and repair the wiring harness.

Posted on Dec 03, 2008

  • 3 Answers

SOURCE: tail lights and brake lights not working with headlights on

We had the same problem with ours, that is a Saturn recall items. Check with your Saturn dealer to see if it is still in effect. It use to make our headlight switch get hot. I think it was a poor ground in the taillight housing, I use to wiggle the bulb plug-ins and that helped for a while, but after the recall was fixed it never did it again.

Posted on Dec 25, 2008

  • 1118 Answers

SOURCE: Brake lights dont work, Turn Signals all goofy

First thing i would do is chg. the break light switch, and make sure to chk. all grounds around tailights, sometimes if there is a ground problem it will travel back thru the hot wire to get a ground, witch in turn makes everything go wackey.

Posted on Mar 10, 2009

  • 10 Answers

SOURCE: brake lights/rear turn signals not working

chk ur fuses

Posted on Mar 18, 2009

  • 88 Answers

SOURCE: 98 jeep wrangler headlights wont turn on

I would check your headlight relay switch that is located in your steering colum

Posted on May 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi i got a n reg ford transit recovery truck someone cut the back light wires now i cant find where they go could you help ?


Use a 12v test light, test the wires on the left side.
One at a time turn on head lights and locate tail light
wire and mark it. do the same thing for the brake light
and turn signals. Now measure out enough wire to go
the left light assy. and across to the right, plus 6". If
you wan't backup lights, turn the key to the on position(don't start engine) block the wheel and put in
reverse, locate wire the same way. After you hook up
the left socket, splice in the brake-backup and tail
lights, to go across to the right. Splice the plate light
in to the tail light 1/2 way across. The right turn signal wire should already be there. Hook up your
sockets, and thats it. Hope this helps. Good luck.

Jan 25, 2010 | 1995 Ford F150 Styleside Regular Cab

2 Answers

Tail lights work on both sides. turn signal and


Sounds like you need to replace the drivers brake/tail light.

Dec 14, 2009 | 1998 GMC Sierra

1 Answer

I hav break and turn signal but no tail lights on


its a fuse! the fuse should say tail lights

Nov 25, 2009 | 1995 Geo Metro

1 Answer

2000 chevrolet venture when lights are one turn


sounds like a short in wire to tail light, remove tail light and check ground first, if still problem then use wire probe and traces wires until u find problem

Jul 14, 2009 | Chevrolet Venture Cars & Trucks

2 Answers

Left rear turn signal light on my 1999 chev. s10 is not working


any increase in bink speed is direcly related to a bulb being burt out.

Jun 12, 2009 | 1999 Chevrolet S-10 Pickup

2 Answers

No turn signals, no tail lights and fuses are good


Replace the non-working tail light bulb. Try replacing the bulbs for the turn signals. If that doesn't work, replace the relay.

May 24, 2009 | 1995 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...