Question about 1999 Dodge Stratus

1 Answer

I want locate the fuel pump reset button on my 1999 dodge stratus

Locate fuel pump reset button

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 3,904 Answers

I don't know exactly on this vehicle but a lot of them are behind the kick panel on the passenger front side under the dash. These panels pull off with a bit of force.

Posted on Jan 20, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 79851 Answers

SOURCE: 2004 Dodge Stratus 2.7 thermostat location

Finding the thermostat: Follow the LOWER radiator hose to where it meets the engine. It's in there. Most cars that I've worked on have the thermostat at the end of the upper radiator hose, but not this car. Replacing the thermostat: You need to remove the thermostat housing. (It's the piece that the lower radiator hose connects to.) - You do not need to remove the radiator hose from the housing. - First remove the bolt that is holding a bracket. This bracket just holds some wires in place. - Now remove the three bolts that hold the housing to the engine block. These bolts can be fairly hard to turn, but just keep trying. - Gently pry the housing away from the engine block. You can use a flat-head screwdriver to help pry, but do not scratch the mating surfaces of the housing and the block. - Pull out the thermostat, noting that the spring end goes into the engine. - When you put the new thermostat in, you probably want to use a new black rubber gasket, but you might be able to use the old one if you have no choice. Also, I didn't add any permatex or anything and it seems fine. - I tightened the bolts to 22foot pounds, but this might be a little high. Whatever you do, DO NOT overtighten the bolts. Couple other notes: I first removed the air cleaner cover and tubes to get a little more working room. I also unplugged one wiring harness to make more room. Otherwise, I was able to get my big hands in there. A new thermostat did not fix my problem. Here is a description of the problem I was having and the solution: Problem: The temperature gauge was spiking occasionally, all the way into the red. It would spike up and come back to normal. It would spike usually while in idle, but sometimes while driving. Usually about once every twenty minutes. Things I checked first: - The plastic reservior for the radiator was full to the top. - The electric fans were running, and running on high speed. - The car had working heat. - Replaced the thermostat. Did nothing to help the problem. Problem Found: - Vapor lock. Even though the reservior was full of fluid, it had previously gotten too low and the system sucked in some air. Once that happens, it doesn't matter if the reservior is full, the cooling system will not draw in the coolant. This is because filling the plastic reservior does not pour coolant directly into the cooling system. The coolant is sucked into the cooling system through a tube, like drinking soda through a straw. So the reservior, where they tell you to add coolant, was full but the cooling system (radiator, engine, pump, etc.) was almost out of coolant and wasn't able to draw in any more. Solution: When the engine is cool, open the metal radiator cap that's sticking right up out of the engine. It can be found by following the upper radiator hose to the engine. There is a tall metal tube with a metal cap on it. Pull that cap off (when it not hot) and fill it up with radiator fluid. (I use radiator fluid that's pre-diluted and designed for all makes and models of cars). Idle the car, in park, for about thirty seconds. Stop the engine and put the cap back on. If you're lucky, all the air bubbles are out of the system and you're all set.

Posted on Dec 02, 2008

  • 92 Answers

SOURCE: 2004 dodge stratus won't start

sorry but ford is the only vehicle with a fuel pump reset,

Posted on Mar 15, 2009

  • 13 Answers

SOURCE: Fuel filter location 1999 dodge durango

the fuel filter is located on the iner driver or pasenger side frame railing inbetween the front and rear doors. yes it has filter in the tank which is more comely know as the sock or straner. the filter will look like a metal canister .

Posted on Jul 29, 2009

  • 1857 Answers

SOURCE: 1999 dodge stratus won't stay running, replaced

security, did you check for codes ??

Posted on Aug 24, 2010

  • 1252 Answers

SOURCE: fuel pump location dodge stratus

Fuel pump in the gas tank....relay under hood in junction box..

Posted on Jun 04, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the inertial fuel shutoff located on a 1999 Mercury villager van?


It is called the inertia switch or fuel pump cut-off switch

The fuel pump shut-off switch is

located in the driver's foot well,

behind the kick panel. The reset

button for the fuel pump shut-off

switch is accessible through an

opening in the kick panel.

Use the following procedure to reset the fuel pump shut-off switch.

1. Turn the ignition to the OFF position.

2. Check the fuel system for leaks.

3. If no fuel leak is apparent, reset the fuel pump shut-off switch by

pushing in on the reset button.

4. Turn the ignition to the RUN position. Pause for a few seconds and

return the key to the OFF position.
5. Make a further check for leaks in the fuel system.

Jun 26, 2017 | Mercury Cars & Trucks

1 Answer

Is there a fuel reset button on a 1984 ferrio fuel pump qiut after we blew air threw the injector was plugged now fuel pump wont kick in


Do not know about a 'reset button' but there is a 'fuel fuse'. should be located in the engine compartment.

Mar 11, 2016 | Cars & Trucks

1 Answer

Where is the fuel pump reset button located,


Most fuel reset buttons are located in the trunk of the vehicle, feel around the edges, I have found them in different locations of the truck in various cars...
Hope that helps?

Mar 17, 2015 | Cars & Trucks

1 Answer

Where is the reset button to the fuel pump on a 2002 mercury cougar v6 duratec 2.5 L V6 24 valve dohc located at?


The fuel pump shut-off switch is located in the driver's foot well, behind the kick panel. Thereset button for the fuel pump shut-off switch is accessible through an opening in the kick panel.
Reset the fuel pump shut-off switch by pushing in on the reset button.

http://www.fordservicecontent.com/Ford_Content/catalog/owner_guides/02cgrog2e.pdf

Page 136

May 04, 2014 | 2002 Mercury Cougar

1 Answer

Location of fuel pump reset button on 2002 lincoln towncar cariter


The fuel pump reset button is commonly located in the passenger compartment behind a panel near the foot boards...passenger side and looks like a relay. The red button may be protruding and simply needs to be pushed back.

Dec 30, 2012 | Cars & Trucks

3 Answers

2006 Ford Expedition blowing Fuel Pump Relay fuse


Try resetting fuel pump. I do believe the reset button is on the forward passengers side of vehicle. The button is behind the plastic shield. Reset once or twice. This hopefully will fix your problem. Look in your manual for exact placement of fuel pump reset button

Mar 25, 2012 | 2006 Ford Expedition XLT

1 Answer

2000 expedition changed fuel pump an fuel filter what else could it be is there a fuel reset button if so were is it located


The fuel pump shut-off switch is
located in the passenger's foot well,
by the kick panel.

Use the following procedure to reset the fuel pump shut-off switch.

1. Turn the ignition to the OFF position.

2. Check the fuel system for leaks.

3. If no fuel leak is apparent, reset the fuel pump shut-off switch by

pushing in on the reset button.

4. Turn the ignition to the ON position. Pause for a few seconds and

return the key to the OFF position.
5. Make a further check for leaks in the fuel system.

It should be in your owners manual. I hope this helped and good luck.

Jan 30, 2011 | 2000 Ford Expedition

1 Answer

Is there a fuel reset button for the fuel pump on my 1992 Nissan Maxima? If so where is located.


There is no fuel pump reset button on the 1992 Maxima. Check your fuel pump fuse under the dash. If it's not blown, check for current at the fuel pump connections. If you have current at the pump, then you probably have a bad fuel pump.

Sep 22, 2010 | 1992 Nissan Maxima

1 Answer

Need location of fuel pump reset button on a 1993


There is no reset button on General Motors vehicles.If your vehicle does not start you have to find out what your vehicle is not getting.Fuel or spark.

Dec 01, 2009 | 1993 Pontiac Grand Prix

1 Answer

Fuel pump reset button


Never heard of a reset button.
Look under the hood for a fuse and relay center. There might be a Maxi fuse for the fuel pump.

Nov 05, 2008 | 1991 Toyota Camry

Not finding what you are looking for?
1999 Dodge Stratus Logo

300 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

79847 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...