Question about Ford Escape

Open Question

Engine code P144a for 2010 Escape? how to fix?

Engine light on, code P144a?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 181 Answers

SOURCE: I have a 2003 ford escape. Check engine light came

On alot of cars you must erase the code after repairs,the code is pending in the memory and can still run bad till cleared.try clearing the code

Posted on Mar 06, 2010

Ad
  • 143 Answers

SOURCE: Error Code PO 456

vacuum leak in the evaporative emission system hard one to solve without the vehicle but could be as easy as a loose or faulty fuel cap just think the fuel tank breaths as well

Posted on Jun 08, 2010

  • 93 Answers

SOURCE: ford escape 2001 ,engine light

P1633 - Keep Alive Power Voltage Too Low Indicates that the Keep Alive Power (KAPWR) circuit has experienced a power interrupt.

  • Open KAPWR circuit
  • Damaged PCM
  • Intermittent KAPWR Circuit

QB1 CHECK BATTERY TERMINALS
    Note: If KAPWR is interrupted to the PCM (that is, when a breakout box is installed or the battery is disconnected), DTC P0603/P1605 can be generated on the first power-up.
  • Inspect the battery cables for loose connections, corrosion.
Are the battery terminal connections in good condition? Yes No KEY OFF. Battery terminals are OK. GO to QB2 . REPAIR battery terminals as necessary. QB2 INSPECT ENGINE COMPARTMENT FOR PROPER WIRE ROUTING
  • Inspect Electronic Engine Control (EC) System wiring for proximity to ignition components or wires.
Is wiring too close to ignition components or wires? Yes No REROUTE as necessary. Engine compartment wire routing is OK. GO to QB3 . QB3 CHECK KEEP ALIVE POWER (KAPWR) TO PCM
    Note: Refer to the PCM connector pin numbers in the beginning of this pinpoint test.
  • Disconnect PCM.
  • Measure voltage between KAPWR circuit at the PCM harness connector and ground.
  • While observing digital multimeter, grasp the Electronic EC harness and wiggle, shake or bend a small section while working from the PCM to the dash panel.
Does the voltage reading indicate less than 10.5 volts? Yes No ISOLATE and REPAIR open circuit. No open in KAPWR harness circuit detected. GO to QB4 . QB4 CHECK FOR REPEAT OF DTC P0603/P1605/P1633
  • Reconnect PCM.
  • Start engine and allow it to reach operating temperature.
  • Run Key On Engine Off Self-Test.
  • Retrieve Continuous Memory DTCs.
Is DTC P0603, P1605 or P1633 present? Yes No REPLACE the PCM. REPAIR other DTCs as necessary. If none, testing is complete.

Posted on Jul 02, 2011

  • 117 Answers

SOURCE: i have 2001 ford escape the engine light is on

Something to do with Auxillary outputs, Assuming it's the power ports that you use to run cellphone, gps so on.

Posted on Jul 12, 2011

rgflo64
  • 209 Answers

SOURCE: P144A and P1296 code on a 2010 Ford Escape

Code p144a 02 sensor circuit high voltage(bank 1 sensor 3
code p1296 multi-faults-bank2-with low side shorts

Posted on Nov 10, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I ne to know what trouble code P144A means


Codes greater than P0800 are always MANUFACTERER specific code, which means we would need the year, make, model, and engine to decipher that for you.

Oct 10, 2017 | Cars & Trucks

1 Answer

How serious is p2196 and p2198?


P2196 O2 Sensor Signal Biased/Stuck Rich (Bank 2 Sensor 1) Code

Feb 03, 2016 | 2010 Ford Escape XLT

1 Answer

Malfunction light on. rapping sound in engine when stepping on or letting off gas.


Oil filter caused check engine light? - Kia Forte Forum : Sedan ...

www.forteforums.com/.../4315-oil-filter-caused-check-engine-light.html

Dec 16, 2010 - 14 posts - ‎7 authors
I'll start out by saying I recently bought my 2010 Kia Forte Sedan with 20000 miles already on it. The other day the check engine light came on ... Malfunction indicator light!! Please Help!
11 posts
Aug 1, 2013
KIA Check Engine Light (CEL) Codes
15 posts
May 19, 2012
Malfunction Light ON!
15 posts
May 19, 2012
Check Engine Light + P200A code on new 2011 SX
15 posts
Jun 7, 2011
More results from www.forteforums.com

Nov 15, 2015 | 2010 Kia Forte

1 Answer

Ford engine codes


Could be throttle body.

Jul 29, 2014 | 2010 Ford Escape

1 Answer

Why does the 2012 kia forte engine light turn on?


Engine Light Is On: 2010-2013 Kia Forte - What to Do - 2010 ...

www.carcarekiosk.com/...Kia_Forte_EX...engine_light/diagnose
A check engine light can indicate a broad spectrum of problems with your 2010 Kia Forte. ... The video above shows how to locate the on board diagnostics (OBD) plug on your 2010 Forte, how to read the trouble codes and how to reset or clear the checkengine light using a scanner on ...

KIA Check Engine Light (CEL) Codes - Kia Forte Forum : Sedan ...

www.forteforums.com/.../11832-kia-check-engine-light-cel-codes.html

May 20, 2012 - 15 posts - ‎8 authors
Old 05-19-2012, 08:42 PM Thread Starter. SketchedOut ... KIA Check Engine Light(CEL) Codes ... P0115 Engine Coolant Temperature Circuit Malfunction. 2012 Forte Koup: Check Engine light
13 posts
Jun 29, 2015
Automatic Transmission Shifting Harder Than Usual
13 posts
Apr 27, 2014
Check Engine Light + P200A code on new 2011 SX
15 posts
Jun 7, 2011
Oil filter caused check engine light?

Jul 05, 2014 | 2011 Kia Forte

1 Answer

2010 ford escape limited edtion should it have a gas capp


Every car needs a gas cap or the service engine lite will come on and generate a code telling you there is a fuel tank problem

Jan 10, 2014 | 2005 Ford Escape

1 Answer

P144A and P1296 code on a 2010 Ford Escape


Code p144a 02 sensor circuit high voltage(bank 1 sensor 3
code p1296 multi-faults-bank2-with low side shorts

Nov 09, 2013 | Ford Cars & Trucks

1 Answer

Hi my names Jay I have a 2010 Ford f150 and I ran my card md on it and it gave me these codes p1450, P2195,P144A, P2195 can someone please tell me what these codes mean thanks


Here is what I found for code explanations:
P1450 Self test detected excessive fuel tank vacuum
P2195 O2 sensor signal stuck
P144a possible canister purge valve problem

Hope this helps you out.

Nov 06, 2013 | Cars & Trucks

1 Answer

My check engine light is coming on and my truck is slightly jerking. when I plug the code machine into the car it said P144A auxiliary emissions control. can someone tell me what this is?


This is a high reading on the last sensor on Bank 1. It is monitoring the end of the Catalytic exhaust flow heading towards the muffler.

A leak may develop and cause this reading to generate. The O2 sensor may be bad. Or the wiring to the sensor is damaged.

Oct 18, 2013 | 2010 Mercury Mariner

1 Answer

Escape won't go over 5 mph and dash is all lit up


your vehicle sounds like in limp mode [



























































the vehicle sounds like its in limp mode [ this allows you to limp the vehicle safely off the road or to a service station ] their are multi reasons that would cause this from low oil pressure , bad emissions sensor to internal engine malfunction .its a 2010 should still be under warranty if not need to have vehicle scanned for trouble code that will give you a start point

Aug 23, 2013 | 2010 Ford Escape

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

634 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...