Question about 2000 Jaguar S-Type

1 Answer

Locating the trunk level switch for license plate lights

My license plate lights are not working

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 183 Answers

Check the wiring by the trunk hinge sometimes the wires snap should be in a black conduit may have to pull the trunk liner i know its common on vw audi have had it happen around six times

Posted on Jan 19, 2013

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76109 Answers

SOURCE: 2000 Jaguar SK8 Cant open trunk...batteries dead.

you can charge the battery from the engine compartment. check your owners manual that is the correct place to jump and to charge the battery.

Posted on Apr 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No ac no heat no power to the to or maybe from the dash control panel


There are 6 bolts that hold the rear trunk panel on the trunk itself: 4 behind the license plate on the outside of the trunk and two inside the trunk panel trim.
1. Remove the license place from the DeVille rear trunk panel.
2. Remove the 4 bolts located below the license plate.
3. Remove the trunk panel (felt) trim inside the trunk.
4. There is a small bolt on each side of inside trunk panel (4mm I believe). Remove them. Each will have a rubber washer on them so you'll know you are removing the correct bolt.
5. From the outside of the trunk, lift out the rear trunk panel. The license plate light (and reverse lights) are removed by turning the light assemblies counter clockwise.

Aug 27, 2013 | 1997 Cadillac DeVille

1 Answer

Spring Switch above key and tumbler controls alarm, auto door lock, clock, license plate lamp.


In your situation I would take to a Hyundai dealer as amateurs have messed it up.

Jul 04, 2017 | 2006 Hyundai Sonata

1 Answer

Trying to locate the trunk light switch.


The trunl light switch is more than likely along the edge of the trunk......below the license plate. Look along this edge to locate the switch. Good luck

Feb 11, 2011 | 2007 Toyota Camry

1 Answer

How to replace license plate lights


    Follow the Steps on how to replace license plate light on your car.

    1. Open the trunk and locate the trunk liner retainer clips.Use the Phillips head screwdriver to loosen the center plastic screw of the retainer clip about 1/4 turn, just enough to raise the head of the screw from the base of the clip. Pull the screw up, and lift the clip out of the liner. Use a flathead screwdriver to help pry it out. Remove enough of the clips to allow access to the license plate light sockets. Pull the liner back.

    2. Remove the emergency trunk release handle by popping off the top cover of the handle. Use the needle nose pliers to gently squeeze the prongs on the shaft, while removing the handle.

    3. Unplug the wire harness from the license plate light bulb socket the release clip on the side of the outlet.Twist the license plate light bulb socket 1/4 turn counterclockwise, using the needle nose pliers again. Do not apply too much pressure to the pliers; you may damage the socket.

    4. Remove the bulb from the socket, and replace it with a new one.

    5. Replace the socket into the socket assembly, and plug the wire harness back in. Test the bulb by turning on the lights of the Corolla, then turn them off again.

    6. Replace the trunk emergency release handle, and replace the hood liner and the retainer clips. Remove the old bulb and tools, and close the trunk.

Dec 22, 2010 | 1995 Toyota Corolla

1 Answer

How do I change the light bulb above the rear license plate?


YOU HAVE TO OPEN THE TRUNK LID REMOVE THE BLACK PLASTIC COVER FOR THE TRUNK LID LATCH.REMOVE THE LICENSE PLATE LIGHT HOUSING FROM THE TRUNK LID.REMOVE THE BULB SOCKET FROM THE LICENSE PLATE LIGHT HOUSING.TO REMOVE BULB FROM THE SOCKET SIMPLY PULL IT STRAIGHT OUT OF THE SOCKET.

May 15, 2010 | 2008 Chevrolet Malibu

2 Answers

License plate and trunk lights not working


check your ground side of the light circuit

Oct 13, 2009 | 2004 Honda Civic

1 Answer

Having problems getting access to my license plate bulbs to replace them


  • well for this you will have to remove the whole license plate holder, first you will need to remove the licence plate and locate & remove the four screws that are holding the part after that you will have to locate about five other screws located inside the trunk then you can remove the part bottom first and you will have acces to the license plate lights and reverse lights.

Apr 26, 2009 | 1995 Cadillac DeVille

2 Answers

License plate bulb on 1997 Cadillac deville


this is straight out of the book ok



  1. Open the rear compartment lid.
  2. Remove the rear compartment lid trim.
  3. Pull back on the rear compartment trim panel.
  4. Unplug the lamp connector from the rear compartment lid wiring harness.
  5. Press the grommet out of the rear compartment lid.
  6. Remove the nuts retaining the lamp assembly to the rear compartment lid.
  7. Remove the bulb.

Mar 07, 2009 | 1997 Cadillac DeVille

1 Answer

Dome light/license plate light out


check the fuse panel and make sure you dont have a blown fuse. If one looks black replace it. Check your owners manual for fuse panel location and for specific fuse.

Dec 20, 2008 | 2003 Pontiac Bonneville

Not finding what you are looking for?
2000 Jaguar S-Type Logo

102 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76109 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...