Question about 2000 Chevrolet Tracker

2 Answers

I have a 2000 Chevrolet Tracker and there is a leak in the manifold coming from a part number 64BOO and I do not know what this part is or what it does.

The full part number seems to be 64BOO OAF or it may be 64B00 OAF

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Probably a factory installed PCV valve. I changed mine awhile ago and it has a similar part number, except the last 3 digits are OJ6. Mine also had the spray of oil around where it mounted in the intake manifold. It may have gone bad like ours and needs replaced. It's very easy and the part is very cheap. Wouldn't hurt to replace, or at least spray out the hose with some carb cleaner too. Do that and you should get another 100k or about 15years out of it like ours when we replaced it.

Posted on Jun 18, 2016

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 660 Answers

It looks like an oxygen sensor.... but being in the intake, it's going to relate to your emission system. I found a link and I hops this helps you.
http://www.lambdapower.co.uk/partsearch/az2.asp?IDlist=LC-8118

You can click the image to enlarge and see if it's the same part.


You can also try removing the one on your intake and wrapping some teflon tape around the threads and resealing it.


Good luck

Posted on Jan 19, 2013

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Shouldibuyit
  • 44 Answers

SOURCE: oxygen sensor 2000 2 liter Tracker

You have an heated Oxygen sensor. 2 of the wires heat up the sensor and keep it at a certain temperature, it is turned on and off by the computer. The other 2 are use to send a very low voltage reading back to the computer to tell the computer if the engine is running rich or lean. I don't have a diagram to tell you which wire does what but you can get a manual and that should give you the information that you need and tell you how to trouble shoot it to tell if the sensor is bad or not, you may want to look for a wire laying on the exhaust, I have found wires burnt and lay on the metal.

Posted on Oct 31, 2008

  • 701 Answers

SOURCE: Fluid Capacity for Transmission

Hello paige farrar: Depending on the transmission the fluid and capacity is as follows. Automatic to drain and refill using Dexron type 3 fluid. Is 2.46 us quarts of oil. On a overhaul the amount is 7.3 us quarts. If you have a standard transmission the fluid to use is GL 4 gear oil. Should hold 2.64 us quarts of oil. Thank You for using FixYa. If you need further assistance please just ask. Roger

Posted on Apr 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 Impala high pitched squeal, not a pulley


It could be a vacuum leak on the inlet manifold or pipes Start engine and allow it to idle, spray some wd 40 or similar around the inlet manifold & vacuum pipes, if you notice a change in engine speed when you spray you will have found the area of the leak

Mar 02, 2013 | 2000 Chevrolet Impala

1 Answer

Oil sending unit location on 2000 chevy tracker


It is behind the manifold on the left side of the engine

Feb 26, 2013 | 2000 Chevrolet Tracker

1 Answer

I HAVE ANITFREEZE LEAKS FROM MY 2000 CHEVY S10 BLAZER. IT'S HARD TO TELL BUT THE LEAK SEEMS TO BE COMING FROM UNDER THE MOTOR RATHER THAN FROM THE RADIATOR OR ANY HOSE I CAN SEE.


a common V6 failure is the intake manifold gasket. coolant will usually leak behind the water pump on the drivers side, however it can leak at other locations on the intake manifold gasket.

coolant leaks from other areas include the heater core, hoses, expansion plugs, trans cooler, and coolant overflow tank.

Jan 03, 2011 | 2000 Chevrolet Blazer

2 Answers

Where is fuel filter located on 2000 chevy tracker


I have a 2000 Chevy Tracker and I would like to know the location of the fuel filter .

May 29, 2010 | 2000 Chevrolet Tracker

1 Answer

I need a serpentine belt/routing diagram 2000 chevy tracker.


For the 2000 Chevrolet Tracker:

Most modern vehicles have the Belt Routing Diagrams on the undeside of the Hood. But the sometimes disappear.

I do not know if you have the 1.6L In-Line 4-Cylinder, or the 2.0L DOHC In-Line 4-Cylinder. Nor what Engine Options you have (AC/No AC, etc.).

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

http://www.2carpros.com/car_repair_information/year/2000/make/chevrolet/model/tracker/2000_chevrolet_tracker_drive_belt_routing_diagram.htm



Mar 27, 2010 | 2000 Chevrolet Tracker

1 Answer

2002 Chevy Tracker 4wd 2.0 has a whistling sound coming from belt area? Belt is ok, all pulleys working, no engine light on... Been told it could be an idle pulley, vacuum hose leak, resonation from intake...


Try removeing the serpent belt ...take idler pulley...if it lose in any way ..before doing all this just listen to the front of it ...look care fully at idler ...if it looks kind of cocky in any way change it ...check your belt too ...and all fluid levels for power steering ect ....good luck

Jan 02, 2010 | 2002 Chevrolet Tracker

1 Answer

2000 4wheel drive Chevorlet Tracker. Has leak at passenger side differental where axle enters . How big a jobe to replace seal.


You have to take the lower controll arm free to be able to pull the axle to get to the seal.Not that big of job but you will need some specialized tools that you can get on the loan a tool program at Autozone.

Nov 04, 2009 | 2000 Chevrolet Tracker

1 Answer

2000 chevy tracker egr gone bad what are opitons to fix


usually egr sensor goes bad sometimes tube best to use new parts old ones may not work andwork short time

Jul 06, 2009 | 2000 Chevrolet Tracker

1 Answer

Thumping noise in chevy tracker 2000model


this noise sounds like your right cv axle. wou might want to have that checked out, they can do great damage if broken while

Feb 20, 2009 | 2000 Chevrolet Tracker

Not finding what you are looking for?
2000 Chevrolet Tracker Logo

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...