Question about 2002 Chevrolet Silverado 1500

1 Answer

2002 chevy truck 5 speed 1st,2nd an 3rd gear grinds or rough, 4th an 5th are fine

Could it be beraings syncranizers or just trashed

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Chevrolet Expert
  • 284 Answers

Either your syncro's are out or your clutch and throwout bearing need to be replaced. Normally higher gears will shipt easier. You need to chech for a grinding sound or howling when you engage the clutch.

Posted on Jan 19, 2013

  • rick Jan 21, 2013

    without the clutch pushed in a lil noisy when clitch is pushed in not noisy. it shifts fine just has a grinding sound an a lil vibration in 1st,2nd an 3rd.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Transmission has no high gears


syncranizer is bad but it aint high your welcome.

May 07, 2013 | 2000 Chevrolet Silverado 1500

1 Answer

Remove/Install front beraings


In almost all cases with a front wheel drive but really need to know the make model year and engine size of the vehicle...

Oct 28, 2012 | Mitsubishi Diamante Cars & Trucks

2 Answers

Noisy differential


Fill it lucas oil treatment or replace the beraings

Aug 11, 2012 | 1995 Jeep Grand Cherokee

1 Answer

MY 04 sunfire grinds when i switch to 5th gear!!


hi there
when you shift into 5th gear take it real slow and easy on it this is a result of the syncranizer in fifth gear going out if you take it gentle this will last a while without having to replace it hope this helps you have a great day

Aug 20, 2011 | 2004 Pontiac Sunfire

1 Answer

I replaced the idle air control valve i drove for 34 miles everything was fine but, then i had to stop to get some gas and then the light turn back on......why is that? how do i correct the problem?


iac needs to be syncranized to computer reve engine to just below rev limiter where engine goes up and down hold for two minutes (sounds like engine is blowing up but isnt ) do this twice for two minutes with the light out

May 28, 2011 | 1997 Chevrolet Malibu

1 Answer

How diffficult is it to fix the front seal on a rear axle on a 3500 4x4 dually?


not difficult, but you have to know what you are doing. you will need to check the rotation torque of the pinion beraings before and after, to set the proper preload,

Dec 03, 2010 | 1996 Chevrolet C/K 3500

1 Answer

Could it be the water pump or timing chain that whines on the right side of engime


It could be any of the beraings on one of your pulleys. The altenator, water pump, tensioner pully, power steering, any of thse can cause a squeel when the bearings go bad. timinag chains usuaaly won;t squeel, they just break.

Nov 26, 2010 | 1999 Saturn SL

1 Answer

Engine knocks cold ok hot


if its at the top end its pistion slap
if its at the bottem end(of your engine) its a crank shaft bearing.

with out going into extream detail,

a ting sound at the top is a pistion slap.... replace all your pistions posibly over hual the engine.

a dubble knock that gose with rpm but sounds 2 knocks very every fireing of the pistion is a crank bearing..... replace your crank shaft bearings.... all of them b/c metal gose threw an engine extreamly fast and will destroy other beraings. this knock on start up will turn into a knock all the time, then a very louad knock that will end your engines life.

unfortunetly the answer is engine rebuild and fast.

May 30, 2009 | 2003 GMC Envoy

Not finding what you are looking for?
Cars & Trucks Logo

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...