Question about 2008 Chevrolet Suburban LTZ

Open Question

Remote starter not working on 2008 chevy suburban.

When i lock the car and push the remote start button on my key controller, the lights flash, as if it receives the signal, but then doesn't start. inside on the dash, the remote start is on

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 120 Answers

SOURCE: 2007 Chevy Equinox - with

believe it or not you need to take it to the dealer. There is a software reprogram for the remote control door lock receiver to fix the probelm - really common on tahoes and suburbans. Go to the dealer and tell them about bulletin #06-08-52-002g. It probably will need new remotes also. Try and get the dealer to warranty it since its a known product defect and a known problem

Posted on May 03, 2009

psds4
  • 293 Answers

SOURCE: no turn signals or side brake lights on 94 chevy suburban

the problen is probably the turn signal switch with a test light check for power at brake switch if no power check for power at turn signal switch the brake lights are incorperated through the turn signal switch

Posted on Oct 18, 2008

  • 3 Answers

SOURCE: 2006 chevy cobalt woulnt start lock light is on

Are you using the original key that came with the car? The chip in that key may have gone bad. Try using the spare key that should have come with the purchase of the car. You may also be having battery issues. If all else fails....call the people who really know how to rape you...DUM Dum dummmmm....the dealer

Posted on Dec 31, 2008

  • 28 Answers

SOURCE: Theft lock 2005 Cobalt

If the BCM has been replaced, the BCM has to be reprogrammed by a dealer as it control many car functions.

Posted on Jul 22, 2009

MECP Guy
  • 344 Answers

SOURCE: Remote starter / keyless entry does not work

Start the car with the key, wait 15 seconds, then press startbutton on the remote while the car is already running, you may need to do this 2 times inorder to reprogram the remote

Posted on Sep 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Remote control has stopped working. Have tried changing the battery of the remote control but that did not work.


Does the red light on the remote light up when you push any of the button
if no, replace remote
if yes, then try repograming the remote to the car again.
-Have remotes' ready. if you have two then fob#1 and fob#2 (doesn't matter which one is #1 or #2)
-each step has to be done within 5 sec or it will not work, but don't do it super fast.
1.turn key just to the "on" position (not starting) and push "lock button " on fob#1 once and release
2.turn key off
3.turn key just to the "on" position (not starting)and push "lock button " on fob#1 once and release
4.turn key off
5.turn key just to the "on" position (not starting)and push "lock button " on fob#1 once and release
6turn key off
7.turn key just to the "on" position (not starting) and push "lock button " on fob#1 twice (if you only have one fob, then stop here and go to step 8)and push the "lock button" on fob#2 twice.
8.turn key off and remove key from ignition.
if you did it right, remotes' should work again.
good luck

Dec 17, 2010 | 2003 Honda Accord

1 Answer

We have a 2008 Saturn Vue with a remote car starter that won't work. Installed a new battery(In remote) and everything works in the process up until the engine starting.(Locks doors then hold down starter...


have vehicle scanned if their are any codes pending or active remote start wont work --also may have lost program with fob which a dealer will need to flash

Jul 11, 2017 | Saturn Vue Cars & Trucks

1 Answer

Factory remote starter on my 2006 impala LT does not work had it to the dealership a few months ago and the replaced the two key chain remotes, doors will lock and lights will flash when trying but no...


there should be a red reset button under kick panel on driver side press in for 30 sec and release, that should take car of problem , also could be mount on dash on driver

Nov 16, 2010 | 2008 Chevrolet Impala

1 Answer

Remote auto start will not start a 2007 chevy suburban ltz


If the keyless remote works to unlock and lock the doors, then it should start the engine. In order to use this feature, you have to lock the doors (make sure that all door lock by pushing the lock button twice) with the remote by pushing the lock button, then you hold down the start button on the remote for 2 to 3 seconds and it should start. You can start and stop the engine with the remote 2 or 3 times with the remote, after that it will no longer let you use the remote start until you physically get in the car and start the engine to reset the system. Check your driver information center options using the steering wheel controls. There is an option to enable and disable the remote start option.

May 10, 2010 | Cars & Trucks

1 Answer

I bought a new Keyless remote for a 2007 Forester from a Subaru Dealer to replace an original one that went bad after 2 years. I have followed the directions in the owner's manual to program it, but can't...


IMPREZA: 2005, 2006, 2007 and
FORESTER: 2005, 2006, 2007, 2008
Check for Immobilizer key on Forester XT models only.
information is always subject to change and correction imp05keylessremote1.jpg
new remote for 2005 Imprezas.
This is not the same remote as the 05 Legacy/Outback remote which also has truck/gate release on the front and a red panic button on the back.
Lock: press Lock button for 2 seconds or so to lock car, and arm optional security system. The car with chirp once and turn signals flash for locked, 5 short chirps and signal flashes if any door is not fully closed. The dome light goes on for 15 seconds and ignition key ring (if present) will light for 30 seconds when unlocked.
Unlock: press unlock one time for driver's door, press again within 5 seconds to unlock all doors inkling rear gate (wagon). The system does not open the trunk.
Panic mode: press and hold lock button for approx. 3-4 seconds to activate Panic mode. I panic model the horn honks and turn signals flash until either the lock or unlock button is pushed again.
Finder mode: Press lock button 3 times within 5 seconds to activate Vehicle Finder mode. The horn will honk once and the turn signals will flash 3 times
Distance: works within approx. 30 feet depending on battery strength, nearby concrete walls and etc.
Audible Chirp On-Off: the system will chirp when locked or unlocked. To turn OFF the chirps, unlock the door and then push both lock and unlock buttons at the exact same time for 2+ seconds. There will be 2 chirps indicating the the audible is off. To turn the chirp back on, repeat the process and the system will chirp one time when it is back on.
Battery: as the battery ages it will only work as you get closer to the car. When a battery is replaced, the transmitter must be re-synchronized with the Keyless control unit. To synchronize, press the lock or unlock button 6 times.
Programming: 4 codes may be programmed.
Sit in driver's seat and unlock all doors. Open and close the driver's door
Turn the ignition key from LOCK to ON position 10 times within 15 seconds. Be sure to stop at both lock and on. The horn will HONK once to indicate transmitter programming mode is activated. Leave key in LOCK position and don't remove it from ignition.
You now have 45 seconds to complete the programming as below.
Open and close driver's door again.
Push either lock or unlock button on the remote you want to program. The horn will honk 2 times when successful.
To continue and program other remotes at the same time: open and close the driver's door and push lock or unlock on the remote. The driver's door must be opened and closed between each remote you want to program.
Done programming? remove the key from the ignition and the horn will honk 3 times.
DELETE old codes? Reprogram 4 times, it will overwrite old codes.
Alarm Security System: optional on all models. When locked there is one chirp (can be turned off, see above), the turn signals will flash and the red 'security' light will start to flash once every 2 seconds except for STi which flashes twice every 2 seconds.
There will be 5 chirps if a door, hood, and trunk or gate is not fully closed
You can also arm the system by using the power lock button on the driver or passenger door as you get out of the car and then closing the door behind you.
Disarm the system: push unlock for 2 seconds
Lost remote, alarm activated? When you can't use a remote to turn off the system: open the door with a key or try to start the car and the horn will start to honk. Turn the key on-off 3 times within 5 seconds and the alarm will go off and you can start the car. It's simple!
VALET mode: To set valet mode or just to disable the security alarm system: 1. unlock all doors 2. physically open the driver's door 3. hold the UNLOCK button on remote for 2+ seconds. The red 'security' light will then flash 2 times a second until the car is turned on.
System has been Tripped (except for STi): if you unlock the door with the remote and it chirps the signal light flash 4 times, the system has been triggered;
Identification mode: To find out what happened and why the system was triggered:
Open and drivers door, leave it open. Turn ignition key from LOCK to ON 2 times and then leave in LOCK position.
Tripped code: 1 security light flash: a door has been opened, 3 flashes when the impact sensor was triggered, 4 flashes when the ignition was messed with or battery disconnected

Nov 19, 2009 | 2007 Subaru Forester 2.5X L.L. Bean...

1 Answer

Automatic door locks / 2001 Chevy Suburban


Your book should give you program options for the door locks If your fob wont work either you got a relay for the door lock bad it is located in the fuse panel push the door lock button and find the one that is clicking

Apr 11, 2009 | 2001 Chevrolet Suburban

1 Answer

How do I reset the oil change light in a 2008 Chevy Suburban


Try this: turn the key to the RUN position (don't start it), press the accelerator to the floor 3 times within 5 seconds. The oil life light should flash twice, indicating that it's been reset.

If you have steering wheel controls, you can navigate to where it says Oil Life and then hold the arrow down, that should also reset the oil life.

Mar 30, 2009 | 2008 Chevrolet Suburban

2 Answers

I have a 2006 G6 and the remote starter recently stopped working. The remote will lock and unlock the doors but when I hit the lock and then starter button on the remote the lights will just flash and you...


you can only start the car starter three time before pcm disables the function must start agin with key to get working. also may have diabled car starter by dic comands on radio also if you have engine light on will not operate car starter due to light.

Jan 02, 2009 | 2005 Pontiac G6

4 Answers

Remote starter does not work but will unlock and lock doors.


I have a 2003 sierra and my remote starter would not work, it would lock and unlock only, checked out this site found the solution, tried it and in two seconds i solved the problem, Just press the lock button and the start button and viola it works again, thanks for all your help , GGGreat site glad i found it John

Dec 08, 2008 | 2005 Pontiac G6

Not finding what you are looking for?
2008 Chevrolet Suburban LTZ Logo

Related Topics:

163 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...