Question about 1995 Jeep Grand Cherokee

1 Answer

How to remove oil pan on grand cherokee 5.2 4wd

Will not come out between tranny and front drivr axel

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Slighty jack the motor up and get a little more clearance

Posted on Feb 20, 2013


3 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 196 Answers

SOURCE: oil pump replacement

all you really have to do is drop the exhaust headers in order to get the oil pan out, are you sure it is the pump though, experience sayd the pressure switch is far more likely to cause a lack of oil pressure that the actual pump.

Posted on Mar 20, 2010

  • 46 Answers

SOURCE: Front drive shaft on Jeep Grand Cherokee

yes but make sure you don't in gauge the front axle

Posted on May 19, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Oil leak out of front left axel from the dif, on a jeep grand cherokee.

axle seal is bad take it to a dealer need special tools to do this

Sep 24, 2013 | 1995 Jeep Grand Cherokee

1 Answer

How much to fix rear main seal

The straight 6 is a 2 piece rear main.
Pulling the oil pan is in order.
But the V-8 is one piece,the tranny has to be removed.

Jan 31, 2013 | 2000 Jeep Grand Cherokee

1 Answer

How to replace cv axels in 1986 pontiac grand am 3.0 litre

much easier to do this on a lift. You have to break the lower ball joint loose (and in some cars the tie rod end too), remove the axel nut, pry the a-frame down with a big pry bar between the aframe and car frame or inner fender skirt. While one person prys a-frame, the other person pulls the hub away from the car to clear the lower ball joint. Pull the axle out of the hub first, then straight out of the tranny. Use a drip pan under the tranny in case it leaks a little. Push the new axle straight into the tranny until it clicks in. put the other end into the hub and have someone pry the a-frame down again while you get the hub back into the ball joint. button her back up...

Sep 04, 2010 | 1986 Pontiac Grand Am

1 Answer

How do I remove 1997 Jeep Cherokee Sport oil pan? I drove both front wheels onto ramps and the oil pan was too tight between the transmission and front suspension to pry out. Is there a way to get it out...

The only way to get that oil pan out is to either lift the engine up, lower the front axle down, or remove the transmission and flex-plate. Sorry, I do not mean to be a buzz kill but I would not want to see you waste any more of your time either.

Jun 10, 2010 | 1997 Jeep Grand Cherokee

1 Answer

I have a95 jeep grand cherokee with all time 4 wheel drive when i make sharp turns i get a popping sound in front end

have the universal joint's checked on the drive shaft's ans the cv joint's on the axel's also check the transfer case oil

Jun 04, 2010 | 1995 Jeep Grand Cherokee

1 Answer

I cannot find my oil pan. I have a 2005 jeep

jeeps are good for having skid plates to protect the under belly of the engine removing it should let you see the oil pan

Feb 24, 2010 | 2005 Jeep Grand Cherokee

1 Answer

How do I drop the oil pan on my 2001 Grand Cherokee Laredo 4.7 engine.

Hi, you will have to remove the exhaust first and then drain the engine oil and remove the bolts around the oil pan, then remove it

Nov 09, 2009 | 2001 Jeep Grand Cherokee

2 Answers

93 Jeep Grand Cherokee only revs when put in gear.

Three ways to check:
first: check if the shift cable is in position, cick down cable too..
-next: check if the torque converter is connected to the engine.
- remove the oil pan from the auto trans and check if the oil filter is in place. If you look to the right front side of the tranny, you see a lid with a coil spring in it. check if the spring is ok.
- if tranny is open, check for metal pieces or clutch material in the oil pan and the filter unit. If you find more than usual, replace the transmission.

Oct 18, 2009 | 1993 Jeep Grand Cherokee

1 Answer

Oil smell in cab

Get under there and look to see where oil is escaping. Oil, like everything else runs downward. Therefore it may be coming from the top of the engine. If you have a 4.0, the valve covers are plastic and tend to leak a bit... Generally you can gently (or you will break them off) tighten the v/c fasteners and eliminate most if not all of the seepage. If it continues, replace the gasket. There is only one seal between trans and engine, called a rear main seal. It is better left alone. It's a big job and best done by a shop.

Dec 30, 2008 | 1999 Jeep Grand Cherokee

Not finding what you are looking for?
1995 Jeep Grand Cherokee Logo

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides