Question about 2003 Isuzu Ascender

1 Answer

Where is the drain plug on 03 Isuzu Ascender from transmission fluid?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Isuzu Master
  • 14,337 Answers

Under transmission is the pan with a screw in it,just remove screw to drain.

Posted on Jan 19, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75817 Answers

SOURCE: Transmission fluid

DEXRON VI, SAME AS A GM PRODUCT.

Posted on Dec 19, 2008

  • 1 Answer

SOURCE: how do I check the transmission fluid of my 98 Isuzu trooper ?

In fact, you can. The large transmission pan has two plugs in the bottom. The higher one is a fill plug. The lower one is a drain plug. The proper procedure for checking the level is: A) Drive vehicle until transmission reaches operating temperature (go for a 30 min drive). B) Park vehicle and apply emergency brake, run gear selector through all gears (engine running, pausing 5 sec.'s in each gear) from Park, down, and back to Park (very important to be in park when checking level). C) Immediately remove the upper fill plug and check level with your finger, it should be just up to the hole, fill as necessary. NOTE: If more than a dribble of fluid drains out when you first open the fill plug then it was overfilled or the procedure was not followed. Use a catch pan under the hole just in case. Filling of the fluid is by means of a small pump and hose, commonly found at auto parts stores.

Posted on Feb 18, 2009

SOURCE: I have an 2006 isuzu ascender. I had an oil change

Could be an axle seal on the trans. Could also be power steering fluid from a worn hose.

Posted on Mar 11, 2010

BCAS1298
  • 3092 Answers

SOURCE: How to check transmission fluid on my 2000 Isuzu

Transmission fluid level get's check from the transmission pan. there is two drain plug's on the transmission pan, the lower one is to drain fluid and the up most one on the pan is to check level, with engine running remove the up most plug if transmission fluid start to come out it's ok.

Posted on May 21, 2010

duane_wong
  • 6826 Answers

SOURCE: 1997 Isuzu Rodeo- What tool/pump is needed to add trans fluid

what size engine?

Usually you just fill with a funnel, unless it is at an awkward position.

Posted on Jul 12, 2010

Testimonial: "Thanks we will try it again."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 isuzu ascender 3.ol oil in water


Blown head gasket, or bad radiator letting transmission fluid in. Check the transmission fluid. Pink?

Aug 06, 2016 | Isuzu Cars & Trucks

1 Answer

How do you change the transmssion fluid on a 2004 isuzu ascender


raise vehicle evenly undo pan bolts on trans (get correct fluid from auto store and service kit before) let drain and remove old filter (making sure drain tray is big enough to hold over 15 litres of trans fluid ) clean every thing spotlessly leavin no trace of lint or contamination in or on pan or trans . replace new filter and pan gasket , fill to the desired manufactures requirements. run thru all gears and check level if possible for correct level , if not possible what the manufactures requirements are. hope that works out well for you

Sep 04, 2014 | 2004 Isuzu Ascender

1 Answer

How do we check the transmission fluid in our Isuzu Rodeo?


Best time to check your transmission fluid is....let it sit over night so it has time to cool down. In the morning start it up...Let it run for about 6 or 7....To warm up transmission fluid temp.
your transmission fluid temp should be about 100 to 125. you have to craw under your rodeo to your transmission plug...not your drain plug.....Take your plug out, If fluid drips, More then likely you don't need fluid....but use your fluid tube to add a little in...If it start to run back out, Your fluid level is good.

Jun 02, 2014 | 2000 Isuzu Rodeo

1 Answer

Winding out in 3rd gear


a good trans filter and fluid change might help

Sep 23, 2012 | 2005 Isuzu Ascender

1 Answer

How can I add (top-up) transmission fluid into my 2005 isuzu ascender?


Most of these don't have a tranny filler tube. You have to go from underneath the tranny. You should then see two plugs with a square in it that fits 1/2" ratchet.
The top or upper plug is the fill hole. The fluid level in the tranny needs to be up as high as the bottom of that hole. You should be able to stick your finger in the filler hole and fill the fluid right at the hole.

Nov 10, 2010 | 2005 Isuzu Ascender

2 Answers

How can i put transmission oil in a izuzu trooper


At transmission pan, there will be two drain plugs, the up most drain plug is where you fill it and check level, to check level, with engine running and in park, unscrew up most plug on transmission pan, if fluid come's out, level is good, if no fluid come's out need to add transmission fluid in that drain plug.

Jul 22, 2010 | 1999 Isuzu Trooper

1 Answer

Can't find the fill or check transmission location on 1996 isuzu trooper 3.2 v6 engine. where is it located? no isuzu mechanic in our area


It's check at the transmission pan, there is two drain plugs, the lower one is to drain transmission fluid, the higher one is to check level, with engine running and in park remove up most drain plug if fluid start to come out level is ok, if no fluid coming out will need to add some till it start to come out.

May 27, 2010 | 1996 Isuzu Trooper

1 Answer

How to check transmission fluid on my 2000 Isuzu


Transmission fluid level get's check from the transmission pan. there is two drain plug's on the transmission pan, the lower one is to drain fluid and the up most one on the pan is to check level, with engine running remove the up most plug if transmission fluid start to come out it's ok.

May 21, 2010 | 2000 Isuzu Trooper

1 Answer

How to change oil transmission isuzu rodeo 2003


There are two drain plugs on the bottom of the pan. remove the lower one to drain the trans fluid. To refill, use a pump and pump the fluid into the upper drain plug until it seeps out and re-install the plug, similar to refilling a manual trans.
Once this is done, Start the vehicle and run it for about 3 minutes, shifting through all gears (do not drive vehicle Remove the upper drain plug and let any excess fluid drain out. Done. This is as per Mitchell OnDemand.

Jul 12, 2008 | 2000 Isuzu Rodeo

Not finding what you are looking for?
2003 Isuzu Ascender Logo

Related Topics:

107 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...