Question about Peugeot Cars & Trucks

Open Question

Main relay peugeot expert

Uder bonnet

Posted by Anonymous on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

c1apton15
  • 3400 Answers

SOURCE: Main beam and dip not

More than likely the dimmer switch has gone bad. The lever you use to flip between hi/low beams will need to be replaced.

Posted on Feb 21, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Headlights on my 307 come on after car is locked


faulty relay i suspect here try swopping them around under the bonnet in the power distribution box if i remember rightly .failing which renew the stalk control switch ,the return spring inside the switch could be weak ,often happens same as the peugeot

Jan 27, 2013 | 2001 Peugeot 307

3 Answers

Expert van 2lhdi 2005 very poor starting in cold weather had glow plugs and relay fitted still no better. i only do 3000 a year and mainly short jouneys less the 5 miles. new battery last year. it does...


Firstly fit a manual overide to the heater plugs .relay -push button type switch -wire -connectors ,run a wire direct from battery to relay ,other side to heater plug relay output so it feeds all the heaters ,push button inside cab with a 12v feed from ignition switch running to relay then other side of relay to earth ,leave vehicle on charge often on trickle charge where possible ,also on a full tank of diesel put in a litre of petrol to stop diesel waxing up ,nice old rug or blanket over engine and it will first time every time ,only use the petrol when weather below minus 5c though ,great vehicles these peugeots but i do like my ford transit

Dec 19, 2010 | Peugeot 604 Cars & Trucks

1 Answer

Dont know how to open the bonnet on Peugeot 104


The lever to open the bonnet is not on driver side but on passenger side (depends on the model). From passernger side open the door and then look on the side-wall (where the door ends and foot-wall starts) underneath the dashboard/glove-box for a lever to open the bonnet.

Jan 09, 2010 | 1991 Peugeot 405

2 Answers

Where is bonnet catch situated on citreon dispatch


its at the very bottom of the dash line most are orange but I had the peugeot expert ( same van reall) and it was black on the passenger side right under the glove box part, I have seen them on both sides of these vehicles so just look along the very very bottom of the dash. its only small though about 4 inches long and 1 inch wide.

Jan 08, 2010 | 1991 Peugeot 405

1 Answer

Peugeot speedo mileage counter and speedo dont


Had this problem on mine & the main dealer were stumped. Eventually found it myself after a lot of pocking about.Have a look at the wiring loom in the engine compartment. Looking under the bonnet look closely on the right hand side of the engine above the gearbox where the wiring loom passes from the rear of the engine over a metal bracket/support to the front. The loom has a tendancy to rub against the bracket and eventually damage the cables within. You will have to remove the air filter canistor & a few air hoses to get to the bracket. Good luck!

Oct 06, 2009 | 1991 Peugeot 405

1 Answer

2005 peugeot expert 2.0 hdi turns off?


Sounds like a flakey connector - try hunting down all the connectors you can find under the bonnet. Separate them, spray with WD40 and reconnect. Start at the engine management computer (silver block with fins on and lots of wires coming out). Take great care not to bend pins.

Jun 08, 2009 | 2006 Peugeot 505

2 Answers

Peugeot 406 windscreen washer fuse were is it


yes 10A fuse under bonnet next to battery causing no wash cycle but wipers as normal. Probably due to frozen pump in cold weather. Just done mine.

Jan 11, 2009 | Peugeot Liberte Cars & Trucks

1 Answer

Peugeot 405 1993 diesel estate


the alarm control unit is fitted under the drivers seat can be accessed from the rear foot well by putting seat fully forward .unscrew the two nuts holding the cover the relays are inside the unit.

this unit interfaces will tell the fuel stop solenoid to release (by applying 12 volts)

the fuel stop solinoid is on the main diesel pump under the bonnet - the exac location on the pump will depend on the make - but it should be cylindrical and have one wire connected to it - (i dont think peugeot were using multi wired coded soleniods in 93)

obivously if your car has the keypad immobilser you will know where this is - if it is the remote alarm immobilser the reciever is in the over head consol near the interior front light

Jan 07, 2009 | 1983 Peugeot 504

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Wahs Team

Level 2 Expert

205 Answers

yadayada
yadayada

Level 3 Expert

75005 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...