Question about Toyota 4Runner
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Diagram is unnecessry.
Pull both front wheels
Work one at a time leaving the other for reference
Find the retention spring ... its a paperclip thickness wire spring... dislodge center retention loop and undo from both ends which engage brake pad retention rods.
Pull the rods out
Pull the old pads out... laying everything on the ground
Use scrap wooden wedges to pry between the rotor and the caliper ...inside and out until the calipers are fully withdrawn. Use the new pads to measure if they are far enough back.
Note... the brake fluid will have dropped in the master cylinder over many months of wear... do not fill it. When the calipers are pushed back they will fill the reservoir again... one wheel at a time.
Be sure to identify the correct pad based on what you took out and what is on the other side (if you screwed up the layout)
Make sure to take the old antisqueek backing plate from the old pad and place it on the new pad. They don't use lubricant on these anymore.
Replace the pads... the retention rods... then the retention spring
Do the other side
Then progressively step on the brake peddle until full tension is felt
Check the master cylinder reservoir... probably needs no additional fluid.
New pads will register in existing ridges in each disc in no time at all.
You should check the discs to see if they need to be replaced during this operation...using some calipers
Posted on Mar 25, 2009
There is a heater core bypass pipe that runs from the block (under the manifold) to the bacl of theengine where you will see a flat rectangular "sheet metal" thing with a pipe coming out of it. The a rubber hose connects. You need to pull the top air plenums and intake to get to it. The p[ipe flange bolts to the block with silicone rtv as a sealant.
Posted on Nov 27, 2009
Tips for a great answer:
Mar 19, 2016 | 2004 Toyota 4Runner
Jun 18, 2010 | 2004 Toyota 4Runner
Feb 28, 2018 | 2004 Toyota 4Runner
Nov 09, 2009 | 1998 Toyota 4Runner
Oct 10, 2009 | 1996 Toyota 4Runner
Oct 01, 2009 | 2004 Toyota 4Runner
Apr 13, 2009 | 2004 Toyota 4Runner
Mar 10, 2009 | 2004 Toyota 4Runner
May 26, 2018 | 2006 Toyota Corolla
21 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: