Question about 2004 Chevrolet Impala

1 Answer

04 impala rear defroster quit working

Checked window connection plugs ok

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,990 Answers

There is a Fuse for this either in the Panel inside the Car or inside theFuse Relay Box under the Hood. Let me know if you need more Help! Please Rate my Response, I need all the Help I can get! Thanks!

Posted on Jan 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The rear wiper on my 2004 GMC Yukon quit working and about two weeks later the rear defrost quit working too. I have checked the fuses and they are ok. Any suggestions?


Same as with all vehicle issues

Check the fuses

Then get out the Wiring Diagrams & get familiar with the
system & pick a test point, or start taking things apart, to get
to the motor or your test points,the most logical part to
have possibly failed

No one can do that for you or tell you what the problems are

Always need a vehicle to test

Apr 08, 2014 | 2004 GMC Yukon

1 Answer

2007 impala rear defroster not working


Using an ohm meter go to the grid on the window and first press one lead on the left strip that runs down the window and the other lead on the right strip that runs down the window and check for continuity. If you get a reading use a magnifier and study all the horizontal lines running from end to end. Chances are something scratched the window or during the summer, heat shrank the lines. If you find a cut or scratch, using the ohm meter put one lead on one side of the break and the other lead on the other side of the break If you get continuity then there's your sign.... I mean your problem You can buy a liquid to fix it with.

Feb 22, 2013 | 2007 Chevrolet Impala

1 Answer

Rear Defroster not working-getting some volts


You should have battery voltage at one side of the grids and it should decrease as you run a meter probe across the grind due to the resistance of the grid strips.

Oct 09, 2012 | 2009 Chevrolet Impala LS

1 Answer

1993 honda s/w rear window defrost quit working


Do you have 12 volts to the rear window grid at the grid connector, check and make sure it is attached to the window, it is the single biggest reason for failure.

Feb 20, 2012 | Honda Accord Cars & Trucks

1 Answer

My rear defroster quit working in my 97 Grand AM


first of all see if there is any power from switch to rear window. if there is power to rear window, then the heater grid may be bad. if no power from switch, first check the fuse for rear window defroster. if fuse is ok, then replace switch, if no ower is going out of it.

Feb 14, 2010 | 2000 Chevrolet Malibu

2 Answers

Where is relay and fuse for rear window defrost


Where is relay and fuse for rear window defrost

Nov 29, 2009 | 2000 Chevrolet Impala

2 Answers

2005 impala. Rear window defroster is not working


they have a fuse and a rely make sure the wire end is on the conector on the window

Oct 01, 2009 | 2006 Chevrolet Impala

3 Answers

2004 Impala rear window defroster not working


I have a 2001 impala so this may or may not help but the rear defog relay is on the passenger side dash next to the door Also the rear defog breaker is in the same place.

Aug 31, 2009 | 2004 Chevrolet Impala

2 Answers

Rear window defroster not working Questions about the rear window defroster. I have about 4 lines, a gap and then the rest of the defroster. Top part does not work. I was told that this was an antenna....


The top part is the antenna. If the whole thing doesn't work ck this out.

My defroster quit too. I found a wire burned in the connector that is found under the fuse box that is located inside the car on the passenger side kick panel.
You have to remove the entire kick panel to access the large white connector not just the fuse door. The panel just unsnaps as you lift up and out. Start from the panel seam beside the passenger seat and lift up and back. You'll also have to unsnap the carpet there too.
You'll see the white connector that has a lot of wires on it. If you'll unsnap the connector you'll see the burned wire. It will be thicker than the others and purple. Just cut the purple wire on both sides of the connector and splice them together with a piece of wire the same gauge and it will work fine.

Jan 07, 2009 | 2008 Chevrolet Impala

Not finding what you are looking for?
2004 Chevrolet Impala Logo

295 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...