Question about 2007 Chevrolet Silverado 1500 2WD

Open Question

Replace windshield washer reservoir on 2007 Chevy Silverado

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 5 Answers

SOURCE: Windshield washer fluid will not pump

the windshield washer pump might be bad. It should be located somewhere on the reservoir

Posted on Nov 27, 2008

  • 39 Answers

SOURCE: I need to refill my rear windsheild washer fluid on my 00 suburba

if i am not mistaken it uses the same reservoir as your windshield washers. if its not working it may be plugged or malfunctioning.

Posted on Mar 13, 2009

  • 205 Answers

SOURCE: Rear windshield washer motor works, but no fluid comes out

Rear washer may have it's own reservoir . Can you hear a pump humming when you activate the washer? Look in the under flooor compartment

Posted on Mar 22, 2009

  • 10 Answers

SOURCE: need to know how to replace the windshield wiper motor

First remove the wiper arms.Then remove the screws that hold the black plastic grill, you will see the motor.You will need then to disconnect the wiper arm transmission linkage from the motor, then remove the three bolts holding the motor on, dont't forget to disconnect the electrical connector from the motor.Install in reverse order.Good luck.

Posted on Jul 21, 2009

GasparMacari
  • 166 Answers

SOURCE: Replace 2001 silverado 1500 4x4 windshield washer fluid reservoir

the only solution acording to the manual is to replace the reservoir... not much to say about that, u do have the option to patch it...be careful with the product u use to glue that patch.
take care

Posted on Aug 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where can I purchase fuse #45 for my chevrolet equinox lt 2007 in richmond, va


It sounds as if the windshield washer pump, located at the base of the windshield washer fluid reservoir, has lost it's seal. When this occurs, washer fluid seeps into the pump and shorts it out. I advise that you remove the pump to confirm this before replacing the fuse. A replacement wind washer pump and fuse can be found at your dealer, local auto parts store or the internet (Rockauto.com has always been a great source for quality parts at a very competitive price and I use them all the time). Hope this helps.

Mar 15, 2014 | 2007 Chevrolet Chevrolet Equinox LT

1 Answer

Replace 2007 accent washer fluid reservoir


if same as 2004 Accent, then remove right front wheel, slide underneath, and start wrenching. should be 2-3 bolts

Jan 30, 2013 | 2007 Hyundai Accent GS Hatchback

1 Answer

How to change the windshield wiper fluid bottle on 2001 chevy silverado or how to stop leaking of fluid without changing the bottle. Is there a product to plug up a leak?


Hello, I know of no product capable of a long lasting repair. You might be able to seal it on the outside with some sort of epoxy but a better fix would be to replace it with a new reservoir bottle. To remove it you need to unbolt that skinny brace above the battery and remove the battery and unbolt the top bolts of the washer reservoir. CAUTION, if you have the THEFTLOCK radio be sure to disable it before removing the battery cables. Set the parking brake and chock the rear wheels. Loosen the lug nuts on the driver's side wheel just enough to break them loose and jack up the driver's side and place a jack stand on a solid part of the frame, remove the driver's side wheel. Remove the inner wheel liner to give you access to the bottom reservoir bolts and pump, disconnect the electrical connector and unbolt the pump motor and washer reservoir, then slide it down and out, being careful of the small tube that carries the fluid to the wipers. Installation is the reverse, good luck and if you have any other questions don't hesitate to send a comment.

Mar 09, 2010 | 2001 Chevrolet Silverado 1500

2 Answers

I have a 2005 Chevy Equinox and my windshield washer fluid does not work. The reservoir is full and the wipers wipe, but no fluid comes out. nothing is leaking under the car either. what else can i check...


u will need to pull the washer fluid tank out and check to see if the tank motor that pumps the fluid is getting 12 volts when the washer switch is pushed, if it is the pump will need to be replaced, if it isn't then the washer switch is defective, this switch is part of the turn signal switch.

Aug 24, 2009 | Chevrolet Equinox Cars & Trucks

2 Answers

Replace 2001 silverado 1500 4x4 windshield washer fluid reservoir


the only solution acording to the manual is to replace the reservoir... not much to say about that, u do have the option to patch it...be careful with the product u use to glue that patch.
take care

Aug 21, 2009 | 2001 Chevrolet Silverado 1500

1 Answer

Rear windshield washer motor works, but no fluid comes out


Rear washer may have it's own reservoir . Can you hear a pump humming when you activate the washer? Look in the under flooor compartment

Mar 22, 2009 | 1997 Chevrolet Suburban

1 Answer

I need to refill my rear windsheild washer fluid on my 00 suburba


if i am not mistaken it uses the same reservoir as your windshield washers. if its not working it may be plugged or malfunctioning.

Mar 13, 2009 | 2003 Chevrolet Suburban 1500

2 Answers

Wiper fluid level sensor replacement


Reservoir —Windshield Wiper

Removal
  1. Remove the RH wheel; refer to Section 204-04 .
  1. Position RH splash shield aside.
    1. Remove six screws.
    1. Remove three pin-type retainers.
    1. Position RH splash shield aside.
  1. NOTE: Windshield washer fluid should be collected in a container after the windshield washer hoses are disconnected.
    Disconnect the electrical connector and washer hoses.
  1. Remove the upper reservoir bolt.
  1. Remove the windshield washer reservoir.
    • Loosen the two lower reservoir bolts.
------------------------------------------------------------------------------------

Jan 15, 2009 | 2000 Mercury Villager

1 Answer

Have a 2007 chevy silverado and the windshield wipers lite won't change. I feel the reserved tank up. still displays washer is low. How do i fix?


Disconnect the wiring harness at the pump reservoir and check for faulty wiring, if not, then suspect faulty sensor/pump switch.

Jan 02, 2009 | 2007 Chevrolet Silverado 2500HD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

174 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...