Question about Cars & Trucks

Open Question

Remove stereo from 1996 hyundai excel ls

Replacing the stereo and need to get the dash surround off so I can remove old one and insert new one

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Hyundai Excel LS clutch needs adjusting

hola, buenas noches soy de Ecuador-Guayaquil y tengo un Hyundai Excel LS y quisiera conseguir el manual de piezas y partes, si lo tienes conversemos, lo necesito.
mi email es migtorresp@gmail.com

saludos
miguel torres p.

Posted on Feb 15, 2009

  • 10 Answers

SOURCE: Removing Stereo from Nissan Terrano II

I THINK YOU WILL FIND THER IS 4 SCREWS HOLDING IT IN THERE IS ON MINE * *
* *

Posted on Apr 17, 2009

ghost4548
  • 776 Answers

SOURCE: hyundai excel 1996 automatic will engage reverse

It appears you have a Forward Clutch FAILURE. Replace the trans after you get it diagnosed and verified by a professional technician. By the way, do you have a Check Engine light? If so, what is the diagnostic code? The dealership can scan the system and find any codes which may have been stored in the TCM (Transmission Control Module). If there were any 'Incorrect Gear Ratio" codes, it's most probably the trans itself.

Posted on May 28, 2009

ghost4548
  • 776 Answers

SOURCE: hyundai getz radio

Here's a pic

5781d0b.jpg
Pops out, then remove 4 screws which mount the audio & instrument panel.7be2186.jpg

Posted on Jun 05, 2009

c17hydro
  • 2984 Answers

SOURCE: I have a 1993 Toyota Previa and need to change the

Removal & Installation

  1. Disconnect the negative battery cable. Wait at least 90 seconds on models equipped with an airbag.
  2. Remove the assist grips on either door.
  3. Catrefully remove the garnishes on the door pillars.
130a225.jpg Pry the panel on the side of the dash with a tapped ended screwdriver

  1. Pull the rear edge of the side defroster nozzle upward and remove it.
  2. Remove the steering wheel.
  3. Unscrew and separate the steering column covers.
  4. If necessary, remove the door scuff panels.
  5. Remove the two screws and extract the side panel.
  6. If necessary, remove the hood release lever. Unscrew the lever and pull if forward to remove.
  7. On the cluster finish lower panel remove the two small covers and remove the 5 screws retaining the panel.
  8. Five bolts retain the knee panel, loosen and remove them.
  9. Push up the release lock at the center on the lower side of the cluster finish center upper panel.
bcca214.jpg
Lift up the center upper panel to access the J/B and R/B No. 1

Posted on Oct 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you take of the dash paneling to install a new aftermarket cd player?


  • Disconnect the negative battery cable from the Jeep Cherokee battery with the 10 mm wrench.
  • 2 Remove the five screws on the top edge of the dash panel with a Phillips-head screwdriver.
  • 3 Pry the trim panels surrounding the climate control knobs away from the dashboard with the trim panel removal tool.
  • 4 Remove the trim panel that surrounds the headlamp switches (located to the left of the steering column) with a trim panel removal tool.
  • 5 Remove the two screws behind the trim panel that surrounds the headlamp controls with a Phillips-head screwdriver.
  • 6 Pull the dash panel that surrounds the stereo and covers the instrument panel of the Cherokee, away from the dashboard by hand.
  • 7 Remove the two screws from the stereo mounting bracket. One screw is on the bottom left corner, the other screw is on the top right corner. Each screw can be removed with the 10 mm socket and drive.
  • 8 Pull the factory stereo from the stereo mounting dock.
  • 9 Disconnect the stereo wiring from the back of the factory unit.
  • 10 Connect the Jeep Cherokee factory stereo wiring to a wiring harness adapter. Connect the wiring harness adapter leads to an aftermarket stereo. Slide the aftermarket stereo into the stereo mounting bracket and replaced two screws at the opposite corners with the 10 mm socket and drive.
  • 11 Replace dash panel that stretches across the top of the steering column.
  • 12 Replace the two screws at the top of the headlamp control switch. Replace the trim panel around the headlamp switch.
  • 13 Replace the trim panel that surrounds the climate control knobs.
  • 14 Replace the five screws on the top edge of the dashboard with a Phillips-head screwdriver.
  • 15 Replace the negative battery cable over the negative battery terminal and tighten the cable to the negative lead post with the 10 mm wrench



  • Dec 24, 2010 | 2006 Jeep Grand Cherokee

    1 Answer

    I have c-class 200K 2001, classic, i would to change radio to new one to have DVD/MP3/GPS and bluetooth ....what i have to do


    its not to hard if you have basic skills or better you must remove the old stereo from car which can mean certain parts of the dash will have to come out usually the surround around the stereo you may also need a special tool to get the old stereo out of the dash then you will have to find a wire diagram off the factory stereo so you can wire the factory speakers up to your head unit also you will need to mount the new stereo to the dash which is simple a mount frame should be in the new head unit box

    Oct 05, 2010 | 2001 Mercedes-Benz C-Class

    3 Answers

    Cltuch 97 excel


    dont listen to them, easiest way is: remove air intake box(3 nuts)
    remove nuts surrounding the outer gearbox(about 6) and then remove the gearbox mounts
    lower the gearbox and move slightly to the drivers-side. best to put a block or jack under it. then take the fly-wheel off(marking where it sits against the clutch kit)
    and then pull the clutch plate off, making sure all fingers are not bent. i picked up a full clutch kit 2nd hand for 25$

    Nov 14, 2009 | 1990 Hyundai Excel

    2 Answers

    How to remove 2001 hyndai sonata audio system


    Instructions
    Things You'll Need:
    • Screwdrivers
    • Wiring harness adaptor
    • Hyundai radio adaptor kit
    1. Open the coin holder and remove the two screws at the front. Pry the trim from around the gearshift lever and unhook the power wire to the cigarette lighter.
    2. Locate and remove the two screws from the bottom of the radio trim panel. Look for the screws, attached to a rod, below the glove box. Unhook the cable from the rod and pull the rod free.
    3. Place the shifter into "D" and slide the radio trim panel away from the dash. Locate the four screws at the front and sides of the stereo and remove them.
    4. Pull the stereo out of the Hyundai Sonata dash and disconnect the wires from the back of the unit. Connect the wiring harness adaptor to the original harness.
    5. Slide the new head unit into the Hyundai radio adaptor kit. Attach the wiring harness adaptor and antenna wire to the back of the new head unit and push the entire assembly into the dash.
    6. Secure the stereo in place with the four front and side screws and turn it on. Verify all of the speakers and features are working. Reattach the radio trim panel, insert the rod back into cable assembly and secure the trim around the gear shift.

    In here you can find tips about remove radio...
    - Hyundai Car Stereo removal
    - Stereo Removal Hyundai (buy)

    I really hope help you with this (remember rated this help). Good luck.

    Oct 01, 2009 | 2001 Hyundai Sonata

    1 Answer

    Taking out the stock radio in my 96 hyundai excel


    You must first remove the faceplate bezel surrounding the radio.
    You need to gently pry the cover off the fake switch on either top side.
    Then remove the ashtray to access the two bottom screws.
    once removed there should be the screws visible for the radio mount.

    Sep 14, 2009 | 1994 Hyundai Excel

    1 Answer

    Brake lights not working when brake pedal is


    Replace the brake switch located on the brake pedal shaft under your dash. Should fix your problem.

    Jun 10, 2009 | 1996 Hyundai Accent

    1 Answer

    I need to remove the dash fascia


    if you have a pocket on top of the dash take it off should have few phillips screws to remove. then just pull the plastic surround trim off. you will have to pull pretty hard especially if its new. then the radio will come it there are 4 screws holding it in.

    Mar 30, 2009 | 2008 Hyundai Elantra

    1 Answer

    Need to replace the radio/cd player in my 2001 elantra


    on the hyundai you will usaually see four small holes two either side of the radio unit itself. if you take 4 allen keys/hex keys and insert all at the same time making sure to keep them very straight the stereo unit shuld then be free to pull out. you will then find that it has a universal plug on the back of it and you should be able to plug and play with that. if wrong size/type of plug then buy a convertor from motor discount store.

    Feb 25, 2009 | 2001 Hyundai Elantra

    1 Answer

    Hyundai Excel LS clutch needs adjusting


    hola, buenas noches soy de Ecuador-Guayaquil y tengo un Hyundai Excel LS y quisiera conseguir el manual de piezas y partes, si lo tienes conversemos, lo necesito.
    mi email es migtorresp@gmail.com

    saludos
    miguel torres p.

    Feb 03, 2009 | 1994 Hyundai Excel

    1 Answer

    Need to replace computer but cant find it


    dealer only as it needs resetting and programme

    Nov 26, 2008 | 1994 Hyundai Excel

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    52 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Cars & Trucks Experts

    yadayada
    yadayada

    Level 3 Expert

    75807 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22133 Answers

    Randy Ohler

    Level 3 Expert

    14585 Answers

    Are you a Car and Truck Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...