Question about Cars & Trucks

Open Question

Need to change brake fuse for a holden vectra 1997. Don't have a diagrm cover on the fuse box so don't know which one it is.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

landstar377
  • 66 Answers

SOURCE: Both headlights out on 1997

There is a fuse box under the hood on the passenger side remove the cover and the #10 fuse is for the headlamps. Look on under side of cover for fuse #s.

Posted on May 19, 2011

TerryTown
  • 292 Answers

SOURCE: I don't have a cover for my fuse box and need to

Thanks for the inquiry.
zeppelinx12_4.jpg






Fuse Numbers and Locations:
EXPLORER FUSE PANEL Fuse Position Rating Circuit Protected 1 10 Amp Power Mirrors/Antenna 2 10 Amp Air Bag/Blower Relay 3 15 Amp Parking Lamps 4 15 Amp Left Headlamp 5 10 Amp On Board Diagnostic II System 6 15 Amp HO2S Sensors 7 10 Amp Illumination Switches 8 15 Amp Right Headlamp/Fog Lamp System 9 10 Amp EATC Mem./Seat Mem./Mess. Ctr./Cell. Phone 10 10 Amp EATC Sys./Rear Blower/Spd. Control/GEM Sys./Brake Interlock/OH Console Adapt. Susp. 11 10 Amp Warning Lamps 12 10 Amp Front and Rear Washers 13 15 Amp PCM Sys./Stoplamps/4WD/
ABS/Spd. Control/Trailer Tow 14 10 Amp Anti-Lock System 15 15 Amp Air Bag System/Alternator 16 30 Amp Front Wiper 17 30 Amp Cigar Lighter 18 15 Amp A/C System 19 25 Amp Ignition Coil/PCM System 20 10 Amp Radio/Power Ant./GEM Sys./Anti-Theft/Cell. Phone 21 15 Amp Hazard Lamps 22 15 Amp Turn Signals 23 15 Amp Rear Wiper System 24 15 Amp Starter Relay/Anti-Theft 25 10 Amp Speedometer/GEM System 26 15 Amp A4LDE Trans/DRL Sys./Backup Lamps/4WD/Rear Defroster 27 15 Amp Under Hood LP/Map Lights/Glove Box Lamp/Dome Lamp/Visor Lamps/Accessory Delay/DR Switch Illum./4x4 System 28 10 Amp Memory Seat/GEM System 29 15 Amp Audio System 30 - Not Used 31 10 Amp Aux. Blower System 32 10 Amp Heated Mirrors/Heated Backlite 33 20 Amp High Beam Lamps 34 10 Amp Audio System/Power Antenna 35 - Not Used 36 - Not Used
Hope this helps helps. Please keep us updated and remember to rate this answer.
Kind regards,
TF

Posted on Jun 05, 2011

SOURCE: car did not come with

Owners Manual

Buy online Helm.Com

Posted on Jun 09, 2011

jturcotte
  • 7709 Answers

SOURCE: Hello, I have a 1997

Hi, that fuse is under the hood. You can see diagrams of both panels in the owner's manual. Get a free download here if you don't have one:
https://www.fleet.ford.com/maintenance/owners_manuals/default.asp

Posted on Jul 13, 2011

ZJLimited
  • 17970 Answers

SOURCE: Need the fuse box diagram for a 1997 Ford Crown Vic

Check position 2, in the passenger fuse box, 30AMP that controled the Wiper Control Module and Windshield Wiper Motor.

Feel free to contact us here or in the Services Profile (under Ford Manuals).

Hope this helps; also keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using Fixya, and have a nice day.

Posted on Nov 22, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Holden vectra


The clutch master cylinder will be the cylinder next to the brake master cylinder The reservoir may be on to of it or it may be connected to the brake master cylinder as later cars share the reservoir. Follow the line down to the bell housing and you will see the slave cylinder . The bleed nipple is on the top

Jan 04, 2014 | Cars & Trucks

1 Answer

Holden Vectra ZC 2005- 3.2 v6 5 SPEED AUTO eg: rough shifting and jumpy when accelarating or applying brakes ! Has anybody good a possible explantion as to why it's Happening ?


The main problem I think is : bad brake pad ,the brake pad are too thick, and power brake booster may have more vacuum pressure, should rechange a right one , also ,clutch disc may be the problem for its thickness.
you can visit our website to join us , you may buy new brake parts like brake caliper , brake booster , brake disc ,pad from us : http://www.fiverhope.com

Apr 22, 2013 | Cars & Trucks

1 Answer

Dash board lights on w reg vauxhall vectra have gone out


Just open the fuse box and look for the blown one. If you look at the fuses, you will see a shiny bit in a small gap on the top of them. The one you are looking for will not have this shiny bit. First make sure the Dashboard Dimmer has not been turned all the way down. Your car may not have this as you don't mention the model.

Nov 18, 2012 | Cars & Trucks

1 Answer

The ligths is going out and the fuse box don't have the plastic cover to show diagram,so I don't know which one is for the lights


Go to Autozone.com site and register your vehicle for a free fusebox layout and wiring diagrams.

Nov 03, 2012 | 1997 Ford Escort

1 Answer

Timing belt diagrams 2003 holden 'vectra 3.2ltr


We do not have these diagrams, suggest you buy a service manual, try eBay for a used one.

Apr 30, 2012 | Holden Vectra Cars & Trucks

1 Answer

I have no brake lights in my '97 dodge caravan le but i have taillights


Have yoiu changed/checled the lightbulbs? (In other words,do your turn signal lights work? If the front turn signal lights work, but the rear don't, then turn on your four (4) way flashers. If the rear lights still don't work, then all the bulbs are bad. It is rare for all the bulbs to be burnt out at the same time, but it does happen.

If the turn signal/four way flasher lights work, then you probably have a bad brake light switch. However, first check your owner's manual to make certain there is not a separate fuse for these lights. If there is, then swap the fuse for the brake lights for another fuse (or relay) of the same size/amperage. (Facing the hood, the power relay box is located on the right side (usually) under the hood.)

The fuse box is located under the dash, on the driver's side of the car. Usually there is a plastic cover that has to be removed to access the underside of the dash, and then there is a plastic cover that has to be removed to access the fuse box. If you don't have an owner's manual, nprmally the fuses and power relays are normally marked on the plastic covers your remove ot access the fuses and power relays.

If the fuses/relays are good, then you have a bad brake light switch. This is located on a bracket just above the brake pedal. When you push the pedal down, the switch makes contact. Disconnect the plug to the switch, and jump across the plug contacts (not the switch) with a small piece of wire, or if a piece of insulated wire is unavailable, you can use a paperclip, you won't get schocked, just make certain that the paperclip does not come in contact with a ground while you have it plugged in to the plug for the brake light switch.

If the lights stil dont work, check for power to the plug for the brake light switch. If you have power to the plug, the turn signals and four-way flashers work, then my guess would be that you have a broken power wire (probably iside the steering column, or a bad turn signal switch. If the brake lights work whe nyou jump out the brake light switch, then the brake light switch is defective.

Oct 16, 2011 | 1997 Dodge Caravan

1 Answer

Hello, I have a 1997 mustang and the fuse box cover is missing under the dash......I need to replace the cig. lighter fuse and don't know which one.Thx Ross


Hi, that fuse is under the hood. You can see diagrams of both panels in the owner's manual. Get a free download here if you don't have one:
https://www.fleet.ford.com/maintenance/owners_manuals/default.asp

Jul 11, 2011 | Ford Mustang Cars & Trucks

1 Answer

Both headlights out on 1997 Jeep Wrangler. Don't see a fuse in the box in the dashboard indicating headlamps. Looked in the engine compartment, but don't know which fuse to check.


There is a fuse box under the hood on the passenger side remove the cover and the #10 fuse is for the headlamps. Look on under side of cover for fuse #s.

May 19, 2011 | 1997 Jeep Wrangler

2 Answers

Replace timing belt Holden vectra 2.2ltre.i need to know how to set up the marks


timing cover has marks on it,line it up with pulley,remove pulley and cover,check to see if any marks on camshaft.un do tensioner.to be sure make your own marks

Jan 01, 2010 | 1999 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

1,366 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...