On my 1991 Toyota Camry, the automatic seat belt harness does not retract properly?? Here is the Scenario: When sitting in the drivers seat with the seat belt harness in its secure mode (against chest) works normal. Once stopped and ignition off and key removed, the seat belt harness will only retract when the door is just cracked open , if the door is opened farther it stops retracting, if you close the door it will start to retract again. I ohm'ed out all of the wires in the door...that I could get to and they all have good continuity, even when the door is move to closed position. Question: What switches the seat belt to retract? Where is the switch? Pasanger side works normal
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
You'd need to pickup the need parts at the junkyard. You'll need the "A" to "B" pillar trim, lower "B" pillar trim, front seat belts and seatbelt giude from a 1995 SC1 or SC2.
The treaded hole in the frame of the car where the track of the automatic seatbelt assembly attaches is in a slightly different place than the three point system. Its not a problem though. You just need to drill a 3/4" hole slightly above the existing hole in the trim panel. The existing hole is hidden by the seatbelt and not noticable at all.
Everything else pretty much bolts or snaps into place.
I've done this swap on several 1991-1994 Saturn S-Series.
I had a problem on a 91 Civic DX where the drivers auto seat belt
wouldnt move and the beeper would not stop.Had a blown seat belt
fuse.Replaced the fuse no more problem. The Seat belt fuses are located
under the red cover that covers the positive battery terminal. On mine
the fuse closest to the font of the car was for the drivers side auto
seat belt the one closest to the windshield is for the passager seat
belt. They are green and rated at 30A.
The front seatblet retractor springs have weakened. Unfortunatly, there are no "user serviceable parts" on them. They would have to be replaced. How many miles is on it? If you have low mileage, the Toyota Customer Experience Center may provide you some assistance, as the belt replacements are quite expensive. I'd call the CEC and explain your dilemma. Here is the number: 1-800-331-4331
if i were you i would try to make the ones from either the mark 3 supra or try the es250.. im trying to get it to work with the supra but i think your best bet is from the lexus es250. they share the same chassis obviously so most parts are interchangeable.