Question about 2002 Toyota Camry

1 Answer

I have a 1997 toyota Corolla and the compressor is not coming on. The blower doesn't work in the low position nor does the a/c switch light come on when you depress the switch. I think it is the blower switch but of course not sure.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 1,596 Answers

Blower Motor Not Working in LOW only Indicates Resistor is Bad Simple Replacement

It Has 4 Wire Plug and is Held in By 2 screws


  1. Remove Glove Compartment Parts
2. Remove Blower Resistor
  1. Disconnect the connector from the blower resistor.
  2. Remove the 2 screws and the blower resistor.
Installation is in the reverse order of removal

Also seems you are correct About the A/C Switch
Another Simple R7R Tape the end of a Smaller Flathead Screwdriver with Electrical tape --to Protect your dash

Remove A/C Switch
Using a screwdriver, pry loose the clips and remove the A/C switch.

REMOVAL HINT: Tape the screwdriver tip before use.

Installation is is the reverse order of removal.

This Should Correct your Problems ///Beyond this is a Simple Recharge of A/c System With Freon R134A// I Truely Hope That this Sends you on your way Pleased with My Advise If so and you Feel Im worthy if a Good Rating then Feel Free to rate me as Fairly as you Feel I Deserve I hope to Represent Properly and I thank you for Your Time Have A Great Day!!!

Posted on Jan 29, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2003 Toyota Corolla AC Blower/Fan will not turn on, I replaced the Blower/Fan a few weeks ago,

A/c compressor works fine and the blower motor works and shutdown right? it is the problem with the blower resistor or with blower motor relay. try to direct the resistor irrespective of the speed. hope the problem may be solved.

Jun 05, 2014 | 2003 Toyota Corolla

1 Answer

03 Corolla A/C will not work. A/C light comes on, engine speeds up, compressor will not run. Tests show no elect to the compressor coil, and, when jumped by a hot wire the coil will not engage the clutch...

It should have a low freon pressure switch.This may be worn or the system has low freon and this switch is over rideing the power the compressor clutch.

Nov 05, 2009 | 2003 Toyota Corolla

1 Answer

2005 Toyota Corolla A/C compressor cycling problem.

Could be low on freon. Or the cycling switch is bad. Hope this helps.

Jun 20, 2009 | 2005 Toyota Corolla

2 Answers

1995 toyota corolla ac not working

if the compressor was locked up the drive belt would come of when u engage the AC compressor, your problem is most likely a low charge

Mar 31, 2009 | 1995 Toyota Corolla

1 Answer

Compressor not coming on

first if the compressor isnt coming on at all .. it has a pressure switch that if it is low on freon it will not kick in .. and if your switch only works in one or two positions it is needing replaced..

Jan 26, 2009 | 2002 Toyota Camry

2 Answers

Replacing heater blower motor

this is not a problem with thw switch or motor. There is a resistor that is mounted inside the dash on the pasenger side that controls the speed of the blwer..these have a tendency to burn up after 10 years or so... replace the resistor, and you will be fine!

Dec 23, 2008 | 1984 Toyota Pickup Deluxe

1 Answer

1997 Toyota corolla - warning noise when lights left on - not working on drivers side!

The ground circuit for the driver side door switch is compromised, or the door switch is bad. Try this: Remove the black rubber cover from the door swich. Using a 10 millimeter wrench or socket, loosen & tighten the switch retention bolt. See if the dome light flickers. If so, the ground on the switch is bad, & just needs cleaned up. If not, remove the switch, and touch the wire behind the switch to the body,or the bolt hole. If the dome light lights, you need a door switch. Your problem is entirely in the door switch/ground/wiring. Hope this helps, and thanks for choosing FixYa.

Oct 27, 2008 | 1997 Toyota Corolla

Not finding what you are looking for?
2002 Toyota Camry Logo

172 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8725 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides