Question about 1998 Pontiac Bonneville

Open Question

Codes to reset a security system for a 1997 pontiac bonneville

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

MrScary66613
  • 1990 Answers

SOURCE: serpentine belt for 1997 pontiac bonneville sse w/ supercharger

http://www.mvreader.com/multiview/dayco/catalogSearch.php?autoCatalogSearch=1&make=PONTIAC&model=BONNEVILLE&year=1997&year_from=&year_to=&engine=All&l=n

This should help. Please Rate My Response! Thanks!

Posted on Feb 04, 2009

motor1258
  • 6674 Answers

SOURCE: need diagram how to install serpitine belt on 1997 pontiac bonneville se 3800

8th digit of your vin# needed. Is it an "L", "C" or "K" ?

Posted on May 26, 2009

vickygomar
  • 460 Answers

SOURCE: looking for fuel filter location on my 97 pontiac bonneville

It is located under the drivers side floor acessable from under the vehicle. For pics and instructions check out .http://www.pfyc.com/supportfiles/gasfilter/

Your rating is very important to me

Was this helpful?

Posted on May 26, 2009

Molson02536
  • 3854 Answers

SOURCE: How to program a keyless remote for a Pontiac

NOTE: You must have the correct part number on the remote for it to work. The part number you need is 15732803.
Transmitter programming per the GM manual:
Before entering the programming mode, verify the possession of all the transmitters you will be using on the vehicle. Once you program the transmitter, the memory erases the other transmitters. You may program up to 4 transmitters.

  1. Turn OFF the ignition switch
  2. Usa a fused jumper (3 amp is sufficient) and connect terminal 8 (back/white wire) to terminal 4 (black wire)
  3. Close all the doors
  4. Turn ON the ignition switch / the doors will lock
  5. Press and hold the following buttons on one of the transmitters for 30 seconds: lock and unlock
  6. After a 30 second delay, the doors will lock and unlock Important: 
    DO NOT turn OFF the ignition . If the switch is turned OFF the first transmitter becomes inoperative.
  7. In order to program extra transmitters repeat Step 5
  8. Disconnect the fused jumper wire from the data link connector
  9.  Turn off ignition
  10. Verify functions of all programmed transmitters.

This should work for the 1997 and 1999 Bonneville's. Good Luck. Keep me posted, be glad to answerer any other questions you may have. 

Posted on Aug 11, 2009

ZJLimited
  • 17970 Answers

SOURCE: trying to install serpantine belt for a 1997 pontiac bonneville

1997 PONTIAC BONNEVILLE - V6 3.8L 231ci GAS FI N K
Belt Routing Diagram - Multiple Accessory

a7bf403.jpg


1997 PONTIAC BONNEVILLE - V6 3.8L 231ci GAS FI S 1
Belt Routing Diagram - Idler, Tens. & SC

78c26f4.jpg



1997 PONTIAC BONNEVILLE - V6 3.8L 231ci GAS FI S 1
Belt Routing Diagram - Multiple Accessory

eb261af.jpg


Hope help with this (remember rated this help).

Posted on Mar 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1997 Pontiac Bonneville that is shutting off while I am driving. It eventually starts but it happens over and over. I changed the fuel relay switch but it still happens. what next?


How long since a tune-up? Are there any applicable trouble codes? Some of the national brand auto stores will check codes free. Does it stall at idle or going down the highway?
With extended crank, have a helper crank it while you visually check for spark at the spark plugs. If spark everywhere, use a gage and check proper fuel pressure and check fuel injector pulse.

If injector pulse is missing when problem is ongoing, two things I think of, do you have an rpm signal and security system where applicable. The rpm signal comes from crank sensor. Intermittent problems can be a pain to track. Don't replace anything unless your testing points in that direction.

Nov 06, 2015 | 1997 Pontiac Bonneville

1 Answer

How to reset security and check engine light


You need a scanner or code reader to erase the trouble codes and turn off the check engine light. The security light is usually on because of a problem with the system, usually the chip in the key or the sensor in the lock cylinder.

Jul 06, 2013 | 1999 Pontiac Bonneville

1 Answer

P1870 engine code on a 1997 Pontiac Bonneville


code 1870 is an automatic transmission code"transaxle component slipping" there is a loss of shaft RPM in the transmission, the input shaft is turning faster then the output shaft have the sensors tested if they test ok then you will need a transmission.....sorry

Jun 10, 2011 | 1997 Pontiac Bonneville

1 Answer

Replaced headlight switch car wont start security light flashing before starting removed neg battery cable 97 bonneville


The security system (VATS/PassKey) is having problems, it's typical on those cars. You can find a great write-up here: http://newrockies.ca , it was the only thing that saved my Park Avenue.

Jul 14, 2010 | 1997 Pontiac Bonneville

1 Answer

I need a wiring diagram for a bonneville


1997 Pontiac Bonneville 3.8 liter V-6 VIN "K"

6d0e36e.gif


1997 Pontiac Bonneville 3.8 liter SC V-6 VIN "1"

be86493.gif


Hope help (remember rated this).

Apr 12, 2010 | 1997 Pontiac Bonneville

1 Answer

My security system in my 1992 pontiac bonneville is blinking and my car wont start what can i do, i have a reset key where do i put it


Sounds like your theft modulator has gone bad. The same thing happened on my 94 Deville. Try Disconnecting the positive cable from your battery for 10 minutes to reset the system. If That doesn't work look into replacing the theft modulator.

Aug 31, 2009 | 1992 Pontiac Bonneville

2 Answers

93 Bonneville Won't Start


No,check for spark first. The security code comes off the key itself & never needs servicing. If no spark,there's a load of things to check,but start with the fuses, then engine codes. Should narrow it down a bit.

Jul 22, 2009 | 1993 Pontiac Bonneville

2 Answers

1997 Bonneville 157K, driving and just stalls


sorry to say this, but sounds like the engine might be done, starting to seize up, have someone do an oil sample to see if any metal in the oil

Jun 28, 2009 | 1997 Pontiac Bonneville

1 Answer

1995 Pontiac Bonneville


you have a bad key or bad security relay

Aug 07, 2008 | 1997 Pontiac Bonneville

Not finding what you are looking for?
1998 Pontiac Bonneville Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...