Question about 2001 Hyundai Trajet

Open Question

Replaced gear change linkage cables trajet,hard to find 5th and reverse

Is there adjustment

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Broken Linkage on a Manual Transmission?

what kind of vehicle is it?

Posted on Dec 15, 2008

ghost4548
  • 776 Answers

SOURCE: TRASMISSION IS GOOD BUT WONT SHIFT INTO REVERSE DUE TO LINKAGE NOT BEING RIGHT

Go to http://www.hmaservice.com/ and register the vehicle (By VIN). Afterward you'lll have access to manuals, wiring diagrams, service bulletins, etc.
Good Luck.

Posted on Jun 02, 2009

ghost4548
  • 776 Answers

SOURCE: gets stuck in first gear

Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.

Posted on Jun 28, 2009

  • 169 Answers

SOURCE: 95 accent hard to shift

Yes. You can adjust the clutch rod inside the car at the clutch pedal. loosen the 12mm jam nut and unscrew the rod 2 turns at a time and test clutch operation each time.Repeat as necessary. dont forget to retighten the jam nut. Good luck! Scott

Posted on Aug 29, 2011

jnjholding
  • 147 Answers

SOURCE: hyundai 1,6 coupe 1998 r reg no 5th or reverse gears

Sounds like a failed synchronizer in the transmission itself. You are looking at rebuilding the transmission, or finding a good used one to swap in.

Posted on Jun 06, 2012

Testimonial: "thankyou very much , "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 diesel trajet, manual gearbox, all gears fine except reverse, hard to select at times, any ideas, please ??


Reverse syncro is going bad. Have lube changed and add Lucas trans fix . Might get lucky

Oct 07, 2015 | 2006 Hyundai Trajet 2.0

1 Answer

Replaced clutch and now won't shift into 1st, 3rd, or 5th gear


if it worked before why a new clutch,,,(context wins, here/??????)
ok, so you the clutch is failing,
you never posted the symtoms, not really
does car start in gear with clutch depresses, or start to move
does car take off in 1st ?
or is it just moving fast issues>????
cant up shift, cant down shift
hard to shift. (blocks)
grinds.

my wild guess, based on no input is the clutch linkage,
was never adjustED
the side kicks (not sport 1.8L) all have
cable clutches, and the 1 inch rule stated here.
i bet you didnt adjust it or the linkage splines are damaged.
or the pedal is cracked , caused by bad cable.
always replace the cable first. is it breaks other things if not.

http://www.fixkick.com/tranny/clutch/clutch-on-kick.html


tell the full story and get ,very accurate tests to do,
and inspections.

Sep 02, 2014 | 1995 Suzuki Sidekick

1 Answer

Gear shifter cable


sounds like a stretched gear shift cable or the linkage on the tranny may need some adjusting i would start with the linkage first jack vehicle up and do a visual while some one goes through the gears make sure to use jack stands so that the power wheels are off the ground.....good luck

Nov 09, 2013 | Nissan 200SX Cars & Trucks

2 Answers

Cannot get 5th and reverse gear. Feels like neutral. 1, 2, 3 and 4 work fine.


the linkage is loose or poping out! check to c if trans is tightend down

Aug 22, 2012 | 1995 Dodge Neon

2 Answers

Need to check linkage in my 04 sxt. all gears work except reverse. how do i check and fix this issue?


The wire of the gear which goes near of the clutch box has the inside guarnition which normally is broken and need to be changed second the clutch must be controlled

Aug 05, 2012 | 2004 Dodge Neon

2 Answers

Gear link or box problem


Sounds like a piece of linkage came loose. If it were an internal tranny problem, doubtful that the stick would be loose. Examine all linkage for something very obvious.

Oct 07, 2009 | 2005 Volkswagen Microbus

1 Answer

5th gear pops out upon accelertion.


no. linkage most likely you need to get adjusted or
one of it is worn out

Apr 19, 2009 | 2002 Ford Escort

1 Answer

Cant find 5th r reverse, transit


recheck for proper cable adjustments 5 -rev

Nov 28, 2008 | 2000 Ford Expedition

2 Answers

Mannual Box, 1990 V6 4runner


you have a linkage problem its either where the shifter is in the floor there is a ball there that wears out and causes this. or its loose at the transmission just pop the hood and visually inspect the transmission and the shifter linkages see if any are not connected. if its connected and tight on the trans then you know you need a new shifter in the car. they are not hard to replace.

Jul 04, 2008 | 1990 Toyota 4Runner

1 Answer

Mannual box problem


change the trans fluid, filter and adjust the linkage.

Jul 04, 2008 | 1990 Toyota 4Runner

Not finding what you are looking for?
2001 Hyundai Trajet Logo

Related Topics:

123 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...