Question about 1999 Chevrolet Tahoe

1 Answer

Starter was stolen and wires were cut and I just need to know how

Just need to know how to re-connect the wires

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 40 Answers

What type of vehicle?

Posted on Jan 25, 2009

  • jadestephen Jan 25, 2009

    sorry misread the title, didnt see the vehicle type.



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Negative battery terminal

normally there is only one earth wire on a battery as all units earth through this wire to the negative terminal. I would not bother trying to reconnect the cut wires as this will lead to problems further on. Go to a wrecker that handles you model vehicle and get the positive terminal wiring loom and replace all the cut wires . Leave the negative terminal off while you are doing this.

May 03, 2014 | 2000 Ford Focus

1 Answer

Stolen keys-no key fob-last locked with fob-need alarm RIPPED out-HELP

Try disconnecting the battery and then try again.

Jul 06, 2012 | Cars & Trucks

1 Answer

1987 Mercury Sable won't turn over. Think we got a bit wire-cutting happy. What wiring is needed for it to turn over? Solenoid and battery are good. Is there a free wiring diagram available?

I don't know if there is a free wiring diagram available, but to turn the engine over you will need to purchase or build a bumper switch. A bumper switch can be easy to build and relatively inexpensive. Get two gator clips and a bumper type toggle switch. Connect about three foot of wire to each side of the switch, this will create a broken circuit. Locate the ignition wire which is on the starter, since there has already been a lot of damage to your wiring, one more cut won't hurt. Clip this wire and skin it back and connect one gator clip and then connect the other gator clip to a hot battery, this will create a complete circuit. Switch the car on and push the button, it should turn the car over if the starter good. If the starter doesn't turn over then that may be your whole problem.

Jul 22, 2010 | 1987 Mercury Sable

1 Answer

Dicribe what fuse to diable the enging to start i need to nowasap

If you are looking for a method of preventing the vehicle from being stolen, a better approach is to cut off the ignition supply to the engine management unit or ECU.. Use a circuit diagram of the ECU wiring to determine the ignition feed or feeds and then use a relay to interrupt those feeds. You can switch the relay using a hidden switch or through a vehicle alarm or anti theft device. Disconnecting the starter can be defeated under the hood by shorting the starter solenoid but cutting the power to the ECU cannot easily be bypassed. One word of warning though, DO NOT cut any wires unless you are 100% certain that the wires you are cutting are the correct ones because you can cause the ECU to set fault codes in its memory which can seriously affect the driveability of the vehicle. If you have any doubts, consult a qualified person..

May 21, 2010 | 2006 Ford Ranger

2 Answers

My car was stolen and some one cut all the wires

reconnect the wires buy buying but connectors and connect the wire to each color coded wire. match up green to green black to black black with green stripe to black with green stripe. You can go to to look at the wiring codes, cost $24.00 for one year for your car. if your not able to use a pair of wire crimps then you may wat to take it to a shop.

Aug 30, 2009 | 2001 Ford Mustang

4 Answers

Battery is dying with in 5 min. sitting or running? what could cause this. starter was changed out and is new same for battery. after market stereo was installed and was stolen from dash.?

if it dies while it's still running it probably needs a new alternator. you might also remove the radio fuse to see if maby the thief grounded something out.

Aug 14, 2009 | 1997 Ford Expedition

2 Answers

1993 Ford Explorer battery was stolen and they cut all the cables

which wires ? the ones connected to the battery? or the wiring harness? if it's the battery cables then the large wire is the positive side normally red and the negative side is black and is half the size of the positive wire. The battery will have a + and a - on it so you know that the positive wire is + the larger wire and the smaller is black.

Mar 28, 2009 | 1993 Ford Explorer Limited

1 Answer

Aftermarket alarm removed and yellow wire not connected

The yellow wire is the starter wire. When the alarm was instaled this wire was cut. The other end should be close by. Just conect them back together, and she should start.

Nov 17, 2008 | 1995 Dodge Dakota

2 Answers

Oxygen sensor wiring diagram

My 97 cherokee catalytic converter was stolen, oxygen sensor wires cut. the replacement is black, grey and white. the jeepicon1.png is different color. i need help knowing which wires get connected to which.

Jun 24, 2008 | 1997 Jeep Grand Cherokee

Not finding what you are looking for?
1999 Chevrolet Tahoe Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides