Question about 2007 Dodge Ram Truck
How to remove head rest
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
That works fine on a relatively new vehicle but one that has run in salt etc you'll save a lot of time if you remove the steering knuckle completey by separating lower ball joint and outer tie rod end ball joint and bring the whole steering knuckle to a bench to separate the hub/bearing. Soak everything with penetrant, loosen the bolts a few turns and try hitting right on the bolt heads. I also made a very sharp wedge from a chisel and rammed it hard on the other side to seoarate the hub. It will finally come apart then you'll see all the **** that was binding it due to an alumininum knuckle re-acting with a steel hub. Clean the hole and grease everything and fit new bearings
Posted on Feb 15, 2009
The combination fuel filter and fuel pressure regulator is used on all engines. It is located on the top of the fuel pump module. A separate frame mounted fuel filter is not used with any engine.
Both fuel filters (at bottom of fuel pump module and within fuel pressure regulator) are designed for extended service. They do not require normal scheduled maintenance.
Posted on Mar 22, 2009
you must undo the three pully bolts turn the pully so it slips behind the mounting flange , then you should be able to wiggle it out , if it still hangs on frame you a long pry bar and push between frame and crankshaft bolt just hard enough to move engine slightly, this will definitly work and repeat to install. PS use a little RTV silicon to hold seal on new pump.
Posted on Mar 23, 2010
On the upper grill side of the headlight assy. there
should be 1 or 2 push pins that hold the seal on the
headlight assy to the front of the fender. Also check
for a guide/push pin on the inner top of the assy on
the outer fender side. That should be all there is to
hold the headlight in place. Hope this helps.
Posted on Apr 10, 2010
on your rear bumper or just above it there should be an access hole that you can stick the jack handles through ,then you should be able to lower the tire, its like a winch unwinding
Posted on Sep 26, 2010
Tips for a great answer:
Mar 23, 2016 | Cars & Trucks
Mar 14, 2015 | 2007 Ford Fusion
Apr 13, 2014 | 2007 Dodge Nitro R/T New Cars
Sep 19, 2012 | 2010 Dodge Grand Caravan
Jul 02, 2010 | 1997 Chevrolet Cavalier
Jun 26, 2010 | 2005 Dodge Neon
Dec 27, 2009 | 2007 Ford Expedition Eddie Bauer EL
47 people viewed this question
Usually answered in minutes!