Question about 2005 Chevrolet TrailBlazer

Open Question

How to replace license plate bulb 2005 Chevy Trailblazer

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 75 Answers

SOURCE: how to change bulb on drivers side low beam head light

My niece has a jimmy, they should be the same. The inside should be the high beam, the outside the low, DO NOT TOUCH THE GLASS ON NEW BULBS! Oil will cook on them and pop them! Both come off the same way. Take off the big rubber thing. They are soft but over hard plastic. Just pull them off. If you have trouble, you can flip the little wire clips that hold the headlight housing in place, this will give you room to see the rubber caps enough to figure them out better. The bulb assembly rotates CCW counter clockwise, and should slip out easily. Take the wires and plug off. it should be obvious how it pulls off. Snap the new bulb into the wires without touching the glass part. Gently replace in backwards order as you removed it. Put the rubber caps on, they keep water off the bulbs. It will break them!

The passenger side was harder for me. I had to take the air cleaner off, the whole cover and filter.You should be able to see or feel the same type caps, The low beam outside, High beam inside. The same 2 wire clips are there to release the housing. Everything pretty much goes the same, other than the air cleaner has to be removed and replaced. And make sure the rubber cap is replaced! Good Luck and good motoring!

Posted on Dec 19, 2008

  • 28 Answers

SOURCE: 2002 CHEVY TRAILBLAZER LICENSE PLATE LIGHTS(2)

there is none, will have to replace lights, should came on with running or parking lights.

Posted on Feb 22, 2009

  • 1027 Answers

SOURCE: license plate light replacement

The license plate lights are in the ledge above the license plate. 2 screws keep the lens cover in place. Remove the screws, and the cover comes off. Just pull the lamp out (wedge base) and replace.

Posted on Apr 18, 2009

  • 1 Answer

SOURCE: replacing license plate lights on Chevy Trailblazer

I just had the same problem. I took the cover off, saw the white bulb base, twisted it to take it out, but it popped back inside the door. I got it out, but it wouldn't pull through, so I twisted it back in place and went to Autozone to get new bulb. Once I saw the new bulb, it was obvious, just the bulb itself pulls out. There's so little room to work, I couldn't get it with just my fingers - - maybe rubber gloves would have worked, but I used pliers, lightly, wiggled it a little and it popped right out. I had a similar issue once with the taillight bulb and had to break the bulb and then grip the remaining filament wires with pliers to get it out, so that was my backup plan, just in case.

Hope this helps others.

Posted on Apr 19, 2009

  • 1 Answer

SOURCE: license plate bulb needs replacing

Remove license plate. Unscrew the screws on the underside of the bumper. Slide the lights back toward the trunk and then down through the opening. Unscrew bulb and replace with a new one.

Reverse steps to reinstall the lights.

Posted on Feb 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Plate light does not work, but lights are good and sockets seem good


check bulb the number plate light runs on the same circuit as the side lights so if they are working its got to be a bad earth on the plate light

Jan 24, 2016 | Cars & Trucks

1 Answer

How to replace license plate light bulb for 2002 chevy trailblazer


Hello, If you look on the inside panel of the tailgate you'll see the lamp lens held in by 2 screws. Remove the 2 screws and then remove the lamp lens. Remove the bulb from the lens and install new bulb. Be sure to clean new bulb with clean cloth or paper towel to be sure there isn't any oil from your skin on the bulb. Replace lens assembly into tailgate. Reinstall 2 screws. Hope this helps. Good luck and God bless.

Jun 03, 2015 | Cars & Trucks

1 Answer

My 2005 chevy tahoe 5.3 license plate light went out i replaced bulbs problem still there what is the fuse labeled for that circuit?


Check the brake bulb socket for short , clean replace bulbs , check connector to rear licence plate lights . Also trailer harness for short , all on same fuse circuit .

Jan 23, 2013 | 2000 Chevrolet Blazer

1 Answer

Would like to know the part # for a license plate bulb on my 2004 chevy trailblazer


  • Part Number:BP17177
  • Manufacturer:WAGNER LIGHTING
  • Weight:1lbs.
price: $1.08

Any napa, autozone, or parts plus should have tons of these in stock, I hope that helps.

Dec 05, 2010 | 2004 Chevrolet TrailBlazer

1 Answer

How do i change the license plate bulb on a 2004 tb ls


here is the instructions on how to replace license plate bulbs.

Remove the 2 screws that retain the license lamp lens to the liftgate.

  • Remove the license lamp lens from the liftgate.
  • Remove the bulb (1) from the socket.


  • 8e7cf48.gifaba90ae.gif

    Oct 11, 2010 | 2004 Chevrolet TrailBlazer

    1 Answer

    I'm trying to replace the rear license plate bulbs on my 2005 chevy equinox. Anyone with any knowledge on this for me would be greatly appreciated.


    sometimes the bulb lens has two screws if not pull rear door or gate panel and bingo right there in the center panel twist plug and pull.

    Jun 29, 2009 | 2005 Chevrolet Equinox

    2 Answers

    Replacing license plate lights on Chevy Trailblazer


    I just had the same problem. I took the cover off, saw the white bulb base, twisted it to take it out, but it popped back inside the door. I got it out, but it wouldn't pull through, so I twisted it back in place and went to Autozone to get new bulb. Once I saw the new bulb, it was obvious, just the bulb itself pulls out. There's so little room to work, I couldn't get it with just my fingers - - maybe rubber gloves would have worked, but I used pliers, lightly, wiggled it a little and it popped right out. I had a similar issue once with the taillight bulb and had to break the bulb and then grip the remaining filament wires with pliers to get it out, so that was my backup plan, just in case.

    Hope this helps others.

    Apr 14, 2009 | 2002 Chevrolet TrailBlazer

    1 Answer

    License plate light replacement


    The license plate lights are in the ledge above the license plate. 2 screws keep the lens cover in place. Remove the screws, and the cover comes off. Just pull the lamp out (wedge base) and replace.

    Apr 13, 2009 | 2002 Chevrolet TrailBlazer

    1 Answer

    2002 CHEVY TRAILBLAZER LICENSE PLATE LIGHTS(2)


    there is none, will have to replace lights, should came on with running or parking lights.

    Feb 22, 2009 | 2002 Chevrolet TrailBlazer

    1 Answer

    Replacing license light bulbs on 2002 Chevy Trailblazer - How to?


    Just pull bulbs straight out be careful not to beak bulb

    Feb 18, 2009 | 2002 Chevrolet TrailBlazer

    Not finding what you are looking for?
    2005 Chevrolet TrailBlazer Logo

    Related Topics:

    71 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chevrolet Experts

    yadayada
    yadayada

    Level 3 Expert

    75807 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22133 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8172 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...