Question about 2009 Buick Enclave

Open Question

Heated seat switch doesn't stay on - 2009 Buick Enclave

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 f250 heated seat lights stay on all the time?


It is likely that the heating grid in the seat is defective.

Oct 13, 2016 | 2004 Ford F-250 Super Duty

1 Answer

A/C STAYS AT 70 DEGREES / EVERYTHING TEST OUT GREAT ?ANY IDEAS ?


check the pressure sensor switch is the clutch cycling is the heat door staying open

May 20, 2013 | 2005 Mini Cooper

1 Answer

Where are relays for heated seats in 2004 monte carlo ss


Hi jkelley, I'm glad to help!

Usually in most cases when the heated seats quit working its the heated seat element that you sit on under the padding. Here's what I want you to do: Turn the key on then push the heated seat on button and see if it lights up. This is a quick test but not always an accurate test because the switch could still be working but the LED Light could be bad. BUT, in most cases this is a good test. If it lights up then its safe to say that its mostly likely the ELEMENT that's bad. Most of the time if you'll raise the seat cover you'll see that the element is burnt. Hope this helps and have an awesome day.

Mar 15, 2013 | Cars & Trucks

1 Answer

Heated seat doesn't heat


did you check the fuse box? you may have a missing fuse that you didnt realize that was missing.

Dec 26, 2012 | 2004 Volkswagen Passat

1 Answer

Drivers seat 2000 outback


So here is a diagram of the seat circuitry for your car. Since every other function works except the forward/backward slide function, that leaves basically the forward/backward slide motor, the seat switch, and/or the wiring. If you can verify that the wiring under the seat is in good condition without obstructions, chaffed wires, and/or wires pulled too tight, then it's safe to say it's down to just the motor and/or the switch. Sometimes if the passengers front seat has the same switch, you can plug it in to the drivers' side connector and see what works and what doesn't. If the seat works fine with the other switch, then that's all it needs, if not then it will need a motor. If the other seat doesn't have a switch then you can find them at wrecking yards, or just supply power and ground to the motor in question to see if it works. If it does, then you know you kneed a switch and if not then a motor.
I hope this info helps!~subyguru~
82066173

Nov 14, 2011 | 2000 Subaru Outback

1 Answer

2004 GMC Envoy driver's side heated seat quit


I have the same problem except the back of mine works but the bottom doesn't. Passenger side is fine. Let me know what you find out if you could.

Aug 26, 2011 | 2004 GMC Envoy

1 Answer

How can I find out what has gone wrong with my headed seat? On/off switch lights, but seat doesn't get warm. This first began with the seat getting too warms at times, now nothing. Thank you in...


The most common problem with these heated seats and all heated seats is the actual heater grid in the seat... it is basically like a heating pad that you have in your house except thinner and smaller, these grids usually will shot out causing the syptom that you stated the seat will seem to get really hot and then just quit working all together if you disconnect the connector for the heater grid and it has power and ground than the grid is bad the connector is usually a two pin connector under the seat.... What ever you do do not unplug any Yellow connectors as they are for the air bag system... If you need more information let me know i will be happy to help

May 24, 2011 | 2003 Hyundai Santa Fe

1 Answer

The driver's side heated seat won't turn off on my 2003 Mecury Moutaineer. Also, how do I change my cabin filter?


Your vhicle build date is on a blue sticker on the driver door or door frame. If not there, check other doors.
The heated seat Module is under the seat. You can unplug the connector on it or the heated seat switch to shut it off. I supect the module is bad. get one used from car-parts.com. The cabin air filter is under the leaf screen at the base of the windshield. Remove wiper arms and leaf screen for access. Please rate, thanks. Principles of Operation - Heated Seats - Vehicles Built 03/2002 Onward
NOTE: Two heated seat modules are used, one for vehicles built up to 03/2002 and one for vehicles built 03/2002 onward. The modules are not interchangeable.
The driver and passenger heated seats share a common battery and ignition feed. A shared ground source supplies the heated seat control switches. When the heated seat control switch is pressed with the ignition switch in RUN or START, a momentary ground signal is sent to the heated seat module. The heated seat module then supplies power to the heating element circuit. The cushion element and seat backrest element are wired in series and powered by the same output. The heated seat module also will ground the separate indicator circuit at the dual automatic temperature control (DATC) module display panel to indicate an ON state. The heated seat module will remain on until the heated seat control switch is pressed and a momentary voltage signal is received, or until 10 minutes expire. If the ignition source is removed from the module, the heated seat module will enter an OFF state and will not return to ON until the switch is once again pressed with the ignition switch in RUN. The heated seat module is designed to heat the seat to 37.5?C (99.5?F) and maintain the temperature until time-out or switched off. This temperature is maintained by the heated seat module monitoring the temperature sensor located in the seat cushion element, and adjusting the current flow to the heating elements.
--------------------------------------------------------------------------------------------------------------------------------

May 22, 2011 | 2003 Mercury Mountaineer

2 Answers

Heated seats in 2007 Lincoln MKX not working. I puch the button to turn them on and they light up for a second then go off. What would be the cause and solution. If it was a major problem would effect...


Help anybody?
I have a 2010 Lincoln MKX with heated and cooled front seats. However, when I try to turn them on (85% of the time) they don't work. Primarily when it's cold the heated seats won't stay on... The light turns on for a fast count of 1-5 and then turns off. This has happened since the car was new and I've had it into the dealer 4 times to have it fixed (with no resolve). In their defense they suggest it's fixed each time because they test the heated seats when the vehicle is warm in the shop. Unfortunately, this is nearly the only time it stays on.
I would love to recommend a suggested fix to the dealer as they don't seem to be able to repair it... Any ideas???

Mar 14, 2011 | 2007 Lincoln MKX AWD

2 Answers

2001 Montana heated seats not working Fuses good. Panel switches light up... no heat


check for power at connection under seat. If you have power, heated seat grid in the seat itself has burned out.

Dec 15, 2008 | Pontiac Montana Cars & Trucks

Not finding what you are looking for?
2009 Buick Enclave Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...