Question about Cars & Trucks

Open Question

Byron sx14 door chime - stops working

Works for only a short time

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: my door bell chime chimes all the time even if all

Pull the chime out.

Posted on May 26, 2010

  • 367 Answers

SOURCE: The radio stopped working on

The key reminder and back up sensors on these cars are by both a computer behind the rear seat back and the radio itself, these two things communicate with eachirher through what is called a dash integration module. Concurrency your stereo isn't working, the popping sounds and that your battery is being drained, the first most likely cause is that the radio itself or the wiring going to it has a short or is otherwise damaged. The electrical systems in your car is extremely complex, I would strongly suggest taking it to a dealer or a shop that is experienced with your model and/or has access to factory repair manuals.

Posted on Mar 12, 2011

afarri
  • 1386 Answers

SOURCE: 2005 Ford Freestar Limited Van. Driver's

Hello and welcome to FixYa!

The door sensor surely is worn out. It's the little button that the door hits when shut close. If it's worn out it may trigger that it's open even if it's closed that's why the chime goes on. I strongly suggest that you replace the door sensor to resolve the problem.

Try putting some padding too on the slide door so that when the door hits the sensor it will be pushed. That is if you like the idea and not spending for the door sensor.

Hope this helps and thank you for using FixYa! Have a good one!

Posted on Jun 20, 2011

  • 219 Answers

SOURCE: open door chimes and keys left in in car chimes

Door left open chime is operated by your interior light switch. It is located in a few places on different vehicles. Often in the door jam at the front or low down on the pillar at the rear of the door. You will notice a little black rubber boot and when you push it it goes in and out. That is your interior light switch.

Posted on Oct 04, 2011

SOURCE: where is the fuse for the door ajar chime in a

Water intrusion causes f150's fuse boxes to corrupt. This is porbably your problem. Mine does the same thing, if you disconnect the fuse to the chime, you will lose your windshield wipers as well.. Check and see if your windshield wipers turn on even with no key in the ignition. Soon your fuses will start blowing left and right. You prbably need a new fuse box. Don't let anyone talk you into replacing it with a used one. My mechanic has replaced it with a used one 5 times to no avail. They were all bad. Afetr paying him almost $300 he refuses to work on it anymore. Even though it still isn't fixed. I even offered to pay the difference for a new fuse box. I have basically been screwed out of $300. So take my advise just pay the $400 for a new one from Ford to save yourself a headache.

Posted on Aug 06, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Got in my 09 Impala after work & no display or sound from my radio. Went to the gas station stopped opened the door no door chime? I have no clue what the problem is, the dash indicators work?


It seems to me you should check your fuses, they burn all the time. There inside your car most of the times under or near the steering wheel somewhere in that erea

Sep 23, 2016 | 2009 Chevrolet Impala

1 Answer

How to disconnect the chiming noise and make it stop?


If you take out the chime unit the dome light will not work again. Replace the chime unit

Mar 23, 2015 | 1992 Pontiac Bonneville

1 Answer

Reset passlock code


Is your Impala a 2000, 2001, or 2002? This seems to be a common problem in those model years...much like its predecessor the GM VATS (Vehicle Anti-Theft System). While the VATS had a permanent (albeit unapproved) solution, no suck workaround appears to be available for the Passlock system. Some websites offer a correction "module" that looks to be a hit-or-miss solution. I did find the following procedure on a forum, and it seems to be reliable. Here goes:
If your car has been sitting while you were at work or home or in the store, and you are coming out to leave, follow steps 1-6.

If you just had the SECURITY SYSTEM lock you out of the ignition system, you will have to wait the 10 minutes for it to reset and allow the ignition control module to interact with the system. Once the 10 minutes have passed from the ACTIVE SECURITY STATUS, follow steps 1-6. Do not try to shortcut this as it wont work.

If it is raining, you can close your door, just not all the way. Close it all the way and open the door latch without pushing the door open. This will keep you dry.

+++++STEPS+++++ 1.) OPEN YOUR DRIVERS DOOR AND SIT DOWN. 2.) PLACE KEY IN IGNITION, WAIT FOR CHIME. (3 seconds is what I usually wait) 3.) TURN IGNITION 1 CLICK RIGHT (TO THE ACC POSITION) AND STOP! Do not continue to ON and START yet. WAIT ATLEAST 5 SECONDS 4.) AFTER 5 seconds has passed, TURN KEY TO ON and STOP, DO NOT CONTINUE TO START YET! 5.) WAIT AND WATCH. With your drivers door open, here is what you will see and hear = Your notification will signal DOOR ADJAR, then the BATTERY light, then the SECURITY light, during which you will hear the chime sound as if you just started the car. 6.) AFTER YOU SEE THE SECURITY light switch back to DOOR ADJAR or Battery, and after the CHIME has stopped, you can turn the key to start and voila!

It has worked every time for me and 5 of my friends. This whole process takes about 20-30 seconds, but it sure as hell beats 30 minutes, as GM refuses to compensate my time lost to their vehicle\'s design flaws.

RECAP: 1.) Open driver door, sit down 2.) Insert key in ignition, wait for chime 3.) Once chime starts wait 3 seconds 4.) Turn key to ACC position WAIT atleast 5 seconds 5.) After 5 seconds turn key to the ON postion and wait for the security light to switch back to Battery or DOOR adjar, and the chime to stop (Do not try to START if the chime is still sounding) 6.) Once chime stops and Security light has passed, You may now complete the turn to START and it will start.

Note: This is not a permanent workaround, but it will buy you some time, I can almost guarantee it will work for most if not all people, almost all the time.



Oct 11, 2013 | Chevrolet Impala Cars & Trucks

1 Answer

BYRON DOOR CHIME NOT WORKING


Go to the manufacturer here:

http://www.chbyron.com/

Jan 21, 2013 | Cars & Trucks

1 Answer

Inside chime stays on a has killed my battery. I will only stop when I disconnect the battery terminal, but once I put the key in the ignition it stays on after I remove the key.


2 things to check, first ,, check the door switches, if one is shorted or stuck,, that chime will never ******* and will drive you insane !! if they all check out ok,, your going to have to get the ignition checked, its not fully shutting off ,, removing the chime won't correct this problem, and I imagine that unhooking the battery is quite a pain to do each time, I wish you good Luck with this problem,, let me know what you find works

Aug 29, 2011 | 1993 Mazda MPV

2 Answers

Door ajar warning is chime all the time


Most likely you have a bad door switch or a broken wire.

Does the intrument panel show which door is supposedly open?

If not, I'd start by looking at the door(s) opened most frequently and work my way around. Driver's door would seem like most likely culrpit, but could also be a door kids open a lot.

Also, if the display does not tell you which door, could it be the trunk?

Aug 05, 2009 | 1996 Dodge Stratus

1 Answer

Need programming instructions for RKE for 2000 Mazda 626


2000 Mazda 626
Note: Make SURE the battery is new.
Instructions for programming ONE keyless remote fob.
1. Open the driver’s door & leave open.
2. Insert the key in the ignition.
3. Turn the key to the on and off position 3 times.
4. Remove the key from the ignition.
5. After door open chime stops, press the door open button 3 times.
6. After chime, press any fob key twice.
7. After second chime, press any fob key twice again.
8. After third chime, press any fob key twice again.
9. Press the door open button once.
10. The car should give another acknowledgement chime.
11. Test key fob.
This DOES work. I just programmed mine successfully today, three hours ago.

Sep 03, 2008 | 2000 Mazda 626

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...