Question about 1989 Jeep Cherokee

1 Answer

How do I replace the hydrolic lifters on the rear hatch door 89 j

How do they come off ?

Posted by on

  • billm1943 Jan 26, 2009

    This is in reference to the shocks that hold open the rear door on my 1989 jeep cheerokie sport. How to replace them?

  • Jeff Ellis
    Jeff Ellis May 11, 2010

    need more info dont put it in the heading... on the rear of what

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 6,982 Answers

You will find a small wire clip on each end ball. remove the clips while someone (or a broomstick) holds the gate open. You reverse the process to replace them.

Posted on Jan 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you open the back door (no manual)


Rear hatch is locked or unlocked with a key. (if equipped) • To open the rear hatch, insert the key into the lock, turn it to the unlock position and pull up the rear hatch by pressing the handle (DOOR). You can also lock/unlock the latch (but not release it) with the central door lock system. • If unlocked, the rear hatch can be opened by pressing the handle (DOOR) and pulling the hatch up. • To close the rear hatch, lower and push down the rear hatch firmly. Make sure that the rear hatch is securely latched.

Apr 12, 2016 | 2009 Kia Sportage

1 Answer

Replace rear turn signal bulb


which side?
the car came with an operators guide.
if lost buy one,
its covers this.
so does the FSM. which is free online .

on my 97 ,
  1. open the rear door hatch. fully.
  2. you then look at the LENSE plastic red cover.
  3. on the inboard side see tiny screws, that are hidden hatch closed.
  4. you remove those....
  5. it comes off and the bulb sockets are twist locked in.
  6. you pull them. and the twist lock the bulbs out.
or the FSM
page 8B 4
100% free to look anytime.
http://www.acksfaq.com/96-FSM-v1-8b-pdf.htm

all 89-98 are same way.

Jan 08, 2014 | 1997 Suzuki Sidekick

1 Answer

Excessive noise from camshaft after head reconditioning and correct adjustment both standard setting and allowing for head being shaved - to no effect on a daihatsu charade 1991 G100


if its upper noise eg folowers and lifters if they are hydrolic lifters where these replaced are the cams ok if they are manually ajustable tappets these can be ajusted unless the following are goosed again the cams are pitted or mishapen will need new cam shaft the lifter rods are worn or week valve springs
but if they are hydrolic will have to be replaced inc cam shaft hope this makes sence ivan

Oct 01, 2012 | 1990 Daihatsu Charade

1 Answer

My hatch button is broken, How do I get my hatch


only way is to replace the switch or remove the door panel on the hatch to get to the latch

May 19, 2010 | 1989 Jeep Cherokee

1 Answer

Handle on rear hatch door broke off.how can i open hatch door until i can get a new handle?


you don't. take it into a Hyndai Dealership and have the handle repaired/replaced. The rear hatch panel/cover has to be removed (from inside the vehicle) to access the hatch latch and open the door.. from that point the handle can be replaced/repaired.

May 24, 2009 | 2003 Hyundai Santa Fe

1 Answer

Electronic lock on rear hatch of 2002 ford escape will not open


the unlock or popper for the door needs to be replaced. the door should work with a key.

Apr 09, 2009 | 2002 Ford Escape

1 Answer

Hydrolic lifters making a taping noise


First thing to do is change oil and filter. Hopefully it has not done this long and has hard faced the shims. Good luck and have a good day.

Apr 05, 2009 | 1995 Subaru Legacy

1 Answer

Minivan rear door


you can replace the two struts that aid in supporting the hatchback door. You can get these at any auto parts stores they are relatively inexpensive.

Jun 30, 2008 | 2005 Honda Odyssey

1 Answer

Hydrolic Valve Lifters.(Vanos) Replacing


Hi

The lifters can be cleaned by getting the engine nice and hot and then adding an engine flush to the oil and leaving the engine running at a high tickover for about 15 to 20 minutes, and then giving the car an oil and filter change.

Are you sure its the tappets and not the timing chain?

Regards

Geordie

Jun 13, 2008 | 1997 BMW 328

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

112 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...