Question about 2006 Chevrolet Uplander

1 Answer

Control panel say starter disabled then stalls out

Then it will not rev past 3500 rpms and stalls

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 274 Answers

You probably have some loose wiring on your starter,if you do and need to tighten them,disconnect your ground battery post first or youl have sparking going on

Posted on Jan 19, 2013

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 53 Answers

SOURCE: 1996 3.8 Camero stalls

It has a restrictor on the RPMs so you don't blow out your engine!

Posted on Nov 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Daewoo leganza wont rev past 2800 rpm idles fine just wont rev past 2800 ?


In park, this could be normal. ECU does this. around 2800 to 3500 RPMs. If driving, have the codes read. No codes , could be a clogged fuel filter, bad fuel pump(have the pressure checked), or clogged catalytic converter/s. With no codes, something is restricted..

Jun 10, 2016 | 2001 Daewoo Leganza

1 Answer

I have 96 honda accord ex 4 cylinder vtec engine the engine will no Rev past 3500 rpms


maybe a sensor? cam position or flywheel? assume b series? my cars d series theres a chip in the distributer that fails though u may be onsparkless ign.get a fault code reader

May 23, 2015 | 1996 Honda Accord

1 Answer

1996 chevy truck wont rev past 3500 rpms


does your motor have a govner on it also sounds like bad plugs or coil packs

May 15, 2012 | Cars & Trucks

1 Answer

Running flat up to 3500rpm


What do you mean by "running flat" up till 3500 rpms?
You mean you have no power and can only rev up to 3500 rpms?
Could be a few things:
1.Your CAT is toast time for a new one.
2.Your Engine is toast time for a new one.
3.Check your coils and replace them along with spark plugs.

1.To check your CAT, you might want to dealer to do that. They will have to replace it under emissions laws.
2.Lack of power is when your 8 goes into limp mode due to bad apex seal(s). IE: blown apex seal(s).
3.Sometimes bad coils and or spark plugs will not allow the car to idle or rev past a certain point with out throwing a CEL light or flashing it on your HUD.

Mar 06, 2010 | 2005 Mazda RX-8

1 Answer

Ticking in motor, then stops for about a month, then starts ticking again. oil changed. in nuetral it wont rev past 3500 rpm


It wont rev past 3500 in driving?
The governer on these is set to NOT allow a higher rev when car is stopped and not in gear.
Try to change oil viscosity or filter manufacturer.Some filter manufactures put in a bypass valve that kicks in too early.

Jul 11, 2009 | 2004 Mercury Mountaineer

2 Answers

Mazda stalls


I have a 1997 626 2.0L 5speed when im driven it like rev limits cuts out around 3500-4000rpm, and when i rev it up and past 4000rpm it stalls, anyone have a idea whats wrong??? thanks i just replaced the crank sensor and egr and still. good power put cuts out

Jul 03, 2009 | 1997 Mazda 626

1 Answer

200 Pontiac Grand Am over 3500 RPM loss of power


on almost all gm cars after 96 the engines were governed to not free rev over 4000rpm. when in gear and power braking the rpms stay lower cause of the load on engine. when reving above 3500 rpms the computer cuts back the timing and fuel to reduce engine damage if left to free rev. hop that helps.

Apr 26, 2009 | Pontiac Grand Am Cars & Trucks

1 Answer

1990 1.5l wont rev past 3500rpm's


Honestly I wish I could offer you more info, if it revs now that eliminates the convertor, only I can figure is when you got it to rev you were "blowing the soot out" LOL I hope I have helped you some if so please rate me accordingly.

Dec 16, 2008 | 1990 Honda Civic

2 Answers

1996 3.8 Camero stalls


check your fuel pump. or fuel filter it needs one or the other thanks hope that helps you out I am sure it will

Jun 23, 2008 | 1996 Chevrolet Camaro

Not finding what you are looking for?
2006 Chevrolet Uplander Logo

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...