Question about Chevrolet Camaro
Replaced pump and fuse still does not work dont know what to do
This circuit grounds in the steering column by the switch that activates it..did you test the pumpitself? if not you can with a jumper to the motor on the washer tank..see if the pump works use a battery charger so you dont burn up wires..unless you are comfortable that way..good luck..
Posted on Jan 19, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
are you getting power to pump ? are the hoses blocked check by removing hose joints in differet places, try direct wire to pump
Posted on Jan 20, 2009
I think that on the fuse pannel it should say which fuse goes to what. If the fuse is still good, try making sure the connections are tight. If they are replace the pump.
Posted on Jan 31, 2009
SOURCE: Rear window washer not working.
it could a blockage at the spayer outside .take a safety pin and poke in the small hole outside.
to check the button remove,it from the dash take a
12volt tester check to make sure you have poweon one side
Posted on Apr 12, 2009
SOURCE: problem with windows and radio
I had the same trouble. It began as an intermittent problem, then began to be more frequent and longer in duration. Due to suggestions elsewhere on this site, I took out the BCM from under the dash behind the glove compartment, and one of the relay's feet had faulty soldering connecting it to the BCM (Body Control Module) board inside. I heated up the solder and added some more solder to the connexion, and now the problem is gone. I think they must have had a bad batch of BCMs run through the factory back about ten or so years ago, because this problem appears to be common. Be very careful you don't accidentally add too much solder because it might short out some other circuit on the circuit board and fry some other equipment. Hope this helps.
Posted on Jun 24, 2009
Sounds like pump alright Unbolt tank from car and pump should be screwed to bottom of tank Another way is fit a universal inline washer pump Up to you whether you want to keep your car original
Posted on Oct 22, 2009
Tips for a great answer:
Aug 31, 2015 | 2008 Mazda Tribute 3.0
Jul 30, 2011 | 2000 Kia Sportage
Jun 10, 2011 | 2008 Saab 9-3
Feb 14, 2011 | 2006 Nissan Sentra
Dec 01, 2010 | 1999 Jeep Cherokee
Sep 24, 2010 | 1992 Mercedes-Benz E-Class
Apr 08, 2017 | 1997 Pontiac Grand Am
Sep 21, 2009 | 1992 Mercury Sable
Jun 27, 2009 | 1986 BMW 3 Series
107 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: