Question about Cars & Trucks

2 Answers

My Chevy surburbon 03 1500 is macking a nose coming from the front left wheel

Posted by on


2 Answers

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.


    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 18 Answers

Possible wheel bearing or brakes

Posted on Jan 19, 2013

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 3,103 Answers

Check for a loose wheel..take the wheel and shake it(while jacked up off the ground) rotate it and look behind it for any loose hardware bad bearings or anything you can see that makes noise or dont look right..repost with findings,, thnx

Posted on Jan 19, 2013


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Have 44k on a 2008 chevy uplander. Front left

I have a 2008 as well.. with 39K and the front right needed replaced.
it was covered under the 100K warranty

Posted on May 04, 2010

  • 13 Answers

SOURCE: squeeling nose from front left wheel

either brake squeal indicating worn out pad or bearings going out. Had bearing go out in a Cav once before and made this hidious noise.

Posted on Jul 13, 2009

  • 42 Answers

SOURCE: In my 2003 Saturn Vue, whenenver I turn the wheel

moz-screenshot.jpgThere is a TSB for your complaint from Saturn: Here's the jist of it.

Condition: Some customers may comment on a squeak or squeal noise coming from the base of the steering column while turning vehicle.
Cause: The squeak or squeal noise may be caused by insufficient lubrication of the intermediate steering shaft-to rubberboot- contact area.
you may be able to get it warrantied through saturn. this is the TSB #

Posted on Jan 07, 2010

  • 2427 Answers

SOURCE: grinding nose left front wheel

If the noise occurs when you press the brake its your disc pads that needs changing. If Its always there all the time when driving,then its your bearing that needs replacing , if it intensify's when turning then its the velocity joints. I'm sure one of those if your problem and i gave the scenarios for each, in any case be sure that one of those needs replacing.If you need more help let me know I'll be happy to help how I can.

Posted on Apr 28, 2011

  • 360 Answers

SOURCE: gringing nose left front wheel.

Is this a front wheel drive car? If so, the noise may well be from a CV joint coming apart. Given the extent of parts you have replaced, not much is left. Also might look to see if something is rubbing on a part of the rotating wheel / hub assembly.

Posted on May 07, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do I change front nearside indicator bulb on 2009 renault megane

Right you are going to need a pair of long nosed pliers and a hacksaw a wheel brace and a jack. For health and safety an axle stand.
Crack the nearside wheel nuts jack the car and place it on an axle stand. Remove the wheel and you will see an access panel on the arch liner remove and with long nose shove your arm to the front of the car and as you put the pliers to the left there is a tab for the indicator bulb using the long nose grab the tab turn anticlockwise a quarter turn and retract the holder and bulb change for a new bulb. the hacksaw is to trim the holder down about 10mm so you can fit the bulb back in as it won't go without being trimmed down.
This is not a joke these are the instructions given by Renault. also for more Renault information here is the web address of the gods.

Dec 20, 2014 | Renault Cars & Trucks

1 Answer

Put new king pins on 2004 Mack vision. Makes a

check to make sure that "U" bolts on front springs are tight ,look at top and bottom for any movement ,check front spring eyelets and rear shackles and center pin (if your leaf springs are misalined ) did you check pitman arm and drag link for movement , have someone jiggle steering wheel (with motor off) moving just the free play in steering wheel while you look under front end and look for any looseness , if you have them pull hard to right and then hard to left watch springs for movement . im a federal inspector so this is a everyday check I do on front ends to check for out of service problems.

Oct 13, 2014 | Cars & Trucks

1 Answer

Very loud whining nose on front end ..

if it is a wheel bearing it should make more noise turning one way or the other,if it doesn't make a difference which way you turn it's not the wheel bearing

Jan 29, 2014 | 2004 Dodge Ram 1500

1 Answer

When a strut is worn,what are symptons? How can one diagnose it? KIA Sephia 1998?..

some times you will get a bouncing in wheel ,nose dive in front end when stopping or hard breaking, did you try jacking up car so wheel is just off ground ,put a bar under tire and lift up observe wheel movement ,then do other wheels , if it is a strut the wheel will move up and down freely , look for fluid leaking around strut body ,5000 miles is not much of a factor things do break.the other is get the front end off the ground both wheels,SAFELY !!!!!! WITH THE CAR SHUT OFF WHEELS BLOCKED, have one person turn wheel while you observe it , look for anything wrong grab the wheel and try to move left to right (a small ) motion observe what happens ,is there wiggle ? with out moving steering wheel. if not sure of any of these ,PLEASE take it to a mechanic .hope this helps good luck. Woody

Apr 19, 2017 | 1998 Kia Sephia

2 Answers

Gringing nose left front wheel. i have replaced the break pads roters calabers springs and struts and hubs still have grinding nose

Is this a front wheel drive car? If so, the noise may well be from a CV joint coming apart. Given the extent of parts you have replaced, not much is left. Also might look to see if something is rubbing on a part of the rotating wheel / hub assembly.

May 07, 2011 | Ford F-150 Cars & Trucks

1 Answer

Front right wheel makes a humming sound when i get up to 30 mph; is this abearing that is out?

noises can be allusive
to confirm shift the weight of the vehicle while driving by making small turns in the steering wheel
if the nose increases when turning left hen yes... the right wheel bearing is bad

yes turning left puts more weight on the right side!

Mar 12, 2010 | 2000 Cadillac DeVille

1 Answer

My hood wont open

use a pair of needle nose pliers and pull the cable to open the assumeing the plastic cable lever snapped or broke off... if that doesnt work, remove the left front wheel and left front fender liner and u will see the cable.. u can pull on that there as well.. first try the needle nose pliers (up to u if need to remove the wheel..i did . i have big hands.

Apr 07, 2009 | 1992 Honda Civic

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides