Question about Cars & Trucks
There's lots of hidden screws in the door. Go to autozone.com. Register with them. Then you can get online instructions on how to replace motor. Punch in door window motor. Link will come up. test, repair, replace. You'll get the instructions online.
Posted on Jan 19, 2013
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
1, Disconnect the able from negative terminal of the battery.
2. Pry the courtesy light from the door trim and disconnect the wire connector..
3. Remove all door trim panel retaining screws and door pull armrest assemblies.
4. Remove the door switch panel and the control switch panel and the control switch assembly.
5. On models with memory seats/mirrors, use small-flat bladed pry tool to remove and disconnect the wire.
6. Grasp the trim panel lift up and pull out to detach it from the door. Disconnect the inner door handle lock rod from the handle. Unplug any electrical connectors remaining and remove the door panel.
7. To install, connect the wire harness connectors and place the panel in position in the door. Press the trim panel down into place until the hooks are seated.
8. Install the armrest/door pulls, the courtesy light and the window switch'
9. Reconnect the battery
Also. You will need star pattern drivers to remove the window and motor from your door. If you have all the equipment it should only take you 1 hour.
Posted on Jan 15, 2009
The door switches are built in the latches on each of the doors, they are pron to sticking, leaving the security module to beleive the door is open.
The simple fix is to spray a generous amount of WD40 on, in, and around the door latches, then opening and closing the door a few times. I would start with the passenger door as`this is likely the culprit. do the rest of the latches as a prevenitive measure.
Hope this is of some help.
Posted on Apr 20, 2009
There should be a switch in the door frame which the door pushes in when it is closed. Sounds like it's loose or pushed back into the frame.
Posted on May 04, 2009
You probably have a bad door switch that is located in the door latch.If the vehicle tells you which door is ajar I would try a good penetrating oil first and if not replace that door latch.It will take a bit of working the latch before it will start to work if thats all it is so have some patients with it.
Posted on Feb 12, 2010
Tips for a great answer:
Jul 04, 2016 | Lincoln Cars & Trucks
Jul 11, 2009 | 2004 Lincoln Navigator
Dec 29, 2015 | Hyundai Motor 2003 Elantra
Apr 07, 2014 | 2004 Lincoln Navigator
Feb 14, 2012 | 2003 Lincoln Navigator
Sep 26, 2017 | 2001 Lincoln Navigator
Jul 11, 2011 | 2001 Lincoln LS
May 06, 2010 | 2001 Lincoln Navigator
May 25, 2009 | 2003 Lincoln Navigator
May 24, 2009 | 2003 Lincoln Navigator
Jun 24, 2018 | Dodge Cars & Trucks
30 people viewed this question
Usually answered in minutes!