Question about 2003 Ford Taurus
It was running good then parked it turned it off later tried to turn on and just didnt move it has oil and car turns on just dont move
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
first check drive axels , since you replaced front springs on struts i assume. it is possible that one of the axels popped out. next if thats ok check fluid level in trans with eng OFF should show over full make a srcribe mark on the stick. then START the eng it should go down to full or just below depends if trans is full or a little low . if level does not drop approx.1/2 in or so then have a transmission shop check for bad splines in torque convertor, that is a comon problem in that car, year and milage do not play a roll a large roll in parts failure in trans any more. not like it use-to.
Posted on Aug 28, 2008
The gear selector is locked until the system detects the brake pedal is being pressed, the brake circuit then sends a signal to the shifter release solenoid to pull a pin back and let you shift out of park, this is a safety feature required by federal law, U need to have someone see if the brake lights go on when you press the pedal, if they don't check the switch at the top of the brake pedal, if the brake lights work then the little solenoid is defective.
Posted on Oct 15, 2008
SOURCE: Won't shift out of park
check to make sure you have brake lights when trying to shift if not check the brake lamp switch if it is ok you might need a shift interlock solenoid
Posted on Nov 22, 2008
loosen up the linkage at the transmission a little,click the linkage i click on the transmission(shift it manually to reverse),put the gear selector in the car in reverse,then tighten the linkage.see if that helps.
Posted on Apr 26, 2009
Tips for a great answer:
Jan 18, 2016 | Ford Cars & Trucks
May 07, 2017 | 2001 Ford Taurus
May 28, 2012 | 2005 Ford Taurus
May 18, 2012 | 1997 Ford Taurus
Jun 28, 2011 | 2003 Ford Taurus
Jan 26, 2010 | 2001 Ford Taurus
Jan 04, 2010 | 2003 Pontiac Aztek
Nov 28, 2009 | 1995 Ford Mustang
42 people viewed this question
Usually answered in minutes!