Question about 1994 Jeep Grand Cherokee
If it is a 4.0 strait six cylinder this is a common problem on them.Mine was located just below the oil filter and is pretty easy to fix.Plan it on your next oil change and it is even easier to change out.Oh just so you know your 4.0 liter engines do make a little bit of noise but are pretty much bulletproof if you just do regular maintence on them.Next time you start it put your ear down by the driver side hood hinge.You will find some tapping noise there it is part of the evap system.If it had no oil pressure you would know it rite away.
Posted on Jan 19, 2013
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
the sensor is located right above the oil filter, careful they crack very easily...but are really easy to replace...
Posted on Dec 03, 2008
SOURCE: oil pressure gage at zero
I have the same problem,an erratic reading on the oil pressure gauge.I have been in touch with Chrysler Jeep (USA) and this is a common problem.The oil pressure sensor needs to be replaced this is on the oil pump by the oil filter.I changed mine and no more problems.
Posted on Apr 05, 2009
You need to first determine if the problem is with spark or fuel system. Check for spark at plugs, same at coil. You can spray carb cleaner into the throttle body while cranking the engine and see if it starts. If it does, then the problem is in the fuel system.You can use a digital multi meter to do individual component tests as listed in haynes or chiltons manuals and to check voltages where necessary. Check all the fuses inside and outside as well as fuel and auto shut down relay. Most common failure is the crank position sensor, but if you replace it without testing likely it won't be that. When you turn the key, you should be able to hear the fuel pump running. Wish I could give you more but I don't have enough info and testing is far better than guessing!!
Posted on Oct 03, 2009
Testimonial: "Thank you for your helpful advice!"
low or no oil pressure bad-- knock can be damage from no oil rod knock, wrist pin, piston or spun bearing-or oil pump damaged in oil pan
Posted on Oct 31, 2009
Tips for a great answer:
Jan 23, 2016 | 1994 Jeep Grand Cherokee
Apr 11, 2013 | Cars & Trucks
Mar 24, 2013 | 1994 Jeep Grand Cherokee
Feb 25, 2018 | 1994 Jeep Grand Cherokee
Aug 15, 2010 | 1994 Jeep Grand Cherokee
Jul 14, 2010 | 1999 Jeep Grand Cherokee
Aug 12, 2009 | 1996 Jeep Grand Cherokee
Feb 07, 2009 | 1994 Jeep Grand Cherokee
Jun 13, 2008 | 1994 Jeep Grand Cherokee
185 people viewed this question
Usually answered in minutes!