Question about 2001 Jeep Grand Cherokee
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Fuse # 20, located in the Junction Block (interior, drivers side). This is a ten amp fuse.
Read the information at the above site. The TSB (technical service bulletin) may be of interest to you.
Posted on Nov 20, 2008
the reason it getting hot when stopped is the fan relay is out thus not turning the cooling fan on,this is a time consuming job,the relay is located on the passenger side tip of the frame behind the headlight,the grill,headlights,bumper,and tip of the front fender has to be loosened up to get to it.
The relay is about 70.00 or so,the engine cools down when you drive as you are forcing air through the radiator to cool it down,as for the heater issue probably caused by boiling the anti freeze out ,
To make sure the engine is ok do a compression check to verify the headgasket and heads are ok,as for smelling the sweet smell which is antifreeze probably due to overheating and pushing the fluid out of the cap or tank.
Posted on Dec 30, 2008
Generally this condition is the result of coolant loss, or failed thermostat. If coolant goes below cylinder head level, or thermostat remains closed,heat will stop working. Do not drive with this condition as excessive heat buildup in cylinder head can and will do serious damage to heads and or head gasket.
Find out where leak is and correct it. Change thermostat as it may also be damaged. Check for excessive steam from tailpipe or miss in engine, as these symptoms indicate a cylinder head problem.
Posted on Jan 03, 2009
You need to remove all the skrews from the door. Normaly there is one in the handle of the door, one behind the in door lach handel and one under the bump out for the arm rest on the door. Than you need to take a flat head skrew driver slowly priying the panel off. There are plastic clips on the backside of the panel it is ok if you brake a few.
Posted on May 01, 2009
try the water pump - first - make sure the radiator is really full - take the cap off cold and fill - if it looks full - start and run 8 minutes or so - then fill it up - look at ur fan belt - is it tight - tight is about how much pressure u use to make a firm hand shake with little movement - any movement over about an inch is loose - when the jeep warms up the belt can slip and not even make a noise - - new materials don't always squeal. - then be sure ur water pump is ok - they go slowing - the fins wear down - one more thing is the radiator - u don't say how many miles or what maintenance schedules you have or not so that's it for now
Posted on Dec 26, 2009
Tips for a great answer:
Feb 09, 2015 | 2001 Jeep Grand Cherokee
Jan 16, 2014 | 2001 Jeep Grand Cherokee
Aug 21, 2011 | 2000 Jeep Grand Cherokee
Jan 02, 2011 | 2001 Jeep Grand Cherokee
Nov 20, 2010 | 2001 Jeep Grand Cherokee
Oct 21, 2010 | 2001 Jeep Grand Cherokee
Dec 14, 2009 | 2001 Jeep Grand Cherokee
Dec 07, 2009 | 2001 Jeep Grand Cherokee
Oct 08, 2009 | 2001 Jeep Grand Cherokee
Aug 04, 2009 | 2001 Jeep Grand Cherokee
73 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: