Question about Toyota Corolla

1 Answer

I have Toyota corolla fielder 2007 model with start push button, the remote fail to lock / unlock the doors, how should i reprogram it to faunction as before?

The failure happened after my son lock and unlock about 5 or 6 times in a minute.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 183 Answers

Put new batterys in the remote

Posted on Jan 18, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

bad_dog1
  • 104 Answers

SOURCE: drivers door power lock wont work.

Either the wring going to that motor or the motor itself is bad.

Posted on Mar 09, 2009

alzhane
  • 1 Answer

SOURCE: Need to reprogram door locks for 2004 Toyota Camry

I recently replaced the battery on my 2004 Toyota Camry. When I installed new battery the door locks will not stay unlocked once opened with remote. How do I reprogram?

Posted on Apr 07, 2009

  • 9 Answers

SOURCE: remote starter does not work but will unlock and lock doors.

depending on your alarm which it sounds like a viper model maybe? on my 02 you have to incorporate a factory alarm bypass module in order to be able to start the truck, they run about 100.00 bucks and have to be profssionally installed. The truck wont start because the computer isnt recieving the proper starting sequence due to the factory alarm

Posted on Jul 02, 2009

  • 163 Answers

SOURCE: my toyota 2007 yaris 4dr sedan keyless entry not working

they may need to recode your pad see dealer

Posted on Dec 30, 2009

  • 1 Answer

SOURCE: the power door locks will unlock only, not lock.

I am looking for the same problem. The power door lock work only on to unlock. When I try to lock the doors I hear only a cliking three time but the doors doesn't unlock

Posted on Feb 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Son has a 2005 Hynda Sonata used and every time he fills up with gas,The car won't start for about 5 minutes. Why is this happening?


run the fault codes and check for canister venting problems ,possible purge valve /solenoid failure.

Sep 11, 2014 | 2005 Hyundai Sonata

1 Answer

I have Toyota corolla fielder 2007 model with start push button, i lost the remote, how do i contact the manufacture to get another copy made for me, or the cost of changing the whole system and install a...


Rather than the manufacturer, a authorized dealership can help you out.
This happens more than you would think.
The dealership will have the equipment to match the remote to the vehicle.

Aug 03, 2013 | Toyota Corolla Cars & Trucks

1 Answer

How to program my new control remote to my Honda passport 2000


Try this please!
'98 - '02 Isuzu Rodeo and Trooper and Honda Passport(with factory keyless entry) Instructions for programming. 1. Get in car and make sure all doors are unlocked. 2. Open driver's door and leave open. 3. Put key in ignition. 4. Turn key to 'on position' (dash lights on, but do not start) and back to 'off position' 3 times in 5 seconds or less. (you must turn the key very fast) 5. Close and open driver's door 2 times in 5 seconds or less. 6. Turn key to 'on position' and back to 'off position' 5 times in 5 seconds or less. (turn key very fast) 7. Close and open driver's door the doors should lock and unlock twice after this happens push the lock or unlock button on the remote, doors will lock and unlock. Push the lock or unlock button a second time and doors will lock and unlock again. You are finished! The above sequence erases all previous codes and adds the new code as #1. If you are adding a second remote, you should follow the same sequence with the exception of step 6; instead of turning the key to the 'on position' and back to the 'off position' 5 times in 5 seconds or less, do it 3 times in 5 seconds or less and then continue to step 7. ***Remember to turn the key to the on and off position very fast. This works! Follow directions EXACTLY. I had to try 3-4 times before getting it to work. I failed to go exactly by the instructions the first few times.

Jan 03, 2013 | Cars & Trucks

2 Answers

2004 suburban doors randomly lock and unlock while driving


There are two relays that control the locks. One controls locking, the other unlocking. One of those could be defective. Replace one. If that corrects the problemyou are good to go. Do not discard the old relay yet. If the problem persists replace the other existing relay with the old on you just removed. I believe the lock relay actually works through the unlock relay or vice versa.

May 21, 2012 | 2004 Chevrolet Suburban

1 Answer

Trailblazer dor locks


try this procedure, close all doors, insert key into ignition switch,press and hold door unlock switch,turn ignition switch from on to off twice, release door unlock switch,doors will lock then unlock to confirm programming mode.now simultaneously press and hold the lock and unlock buttons of the first remote transmitter after approximately 15 seconds doors will lock then unlock to confirm remote transmitter programming. if all fails to work take vechicle to dealership, they will have to use diagnostic equipment to reprogram remote.

Feb 12, 2012 | Cars & Trucks

1 Answer

Replaced batery in key fob and now there is no connection between fob and security system...I can lock and unlock doors with the key and I can start car ...fob doesn't work; does not lock or unlock...


reprogram the remote transmitter. first leave driver door open all other doors closed,key removed from the ignition switch. insert key into the ignition switch,then remove it.press lock and unlock on the vechicle door lock control switch at 1 second intervals 5 times. close and repoen drivers door.press lock and unlock on the vechicle lock control switch at 1 second intervals 5 times. insert key into ignition switch. switch ignition on and off twice to program a remote transmitter code whilst erasing the original codes or three timre to check how many remote transmitters are currently registered.remove key from the ignition switch.system should now lock and unlock.twice to indicate programming mode or one to four times,slowly to indicate number of remote transmitters registered.for the solara press and hold lock and unlock remote buttons together, press lock remote button for a second period of 1 second. system should now lock and unlock vechicle.once to confirm, twice to indicate registration has failed.if required repeat button procedure to program remaining remote transmitters.note to exit programming mode close drivers door or insert ignition key.maximum of 4 remote transmitters can be programmed.if akk failed let dealership reprogram remote transmitters.

May 18, 2011 | 1999 Toyota Camry Solara

1 Answer

I was waiting inside our 2011 Toyota Sienna for my husband to return. Without me doing anything, the car locked and unlocked 14 times in total. I grabbed my tablet when this all started and kept a record...


I would contact a dealer locally and see if they can check the system for fault codes . many times when we have key fobs in our pockets they get activated just walking from the buttons getting depressed by other things in the same pocket .
Cell phones even make what some refer to as B U T T calls .

Mar 16, 2017 | Toyota Sienna Cars & Trucks

1 Answer

I have a 2007 Toyota Corolla type S. My problem is that when I press the unlock button on my remote the doors unlock and the lights flash however when you open the door the alarm sounds. It has been...


This sounds like a bad alarm module, the doors unlock but the alarm doesnt shut down, so it wont let you start it because its not shutting down, the light flash and door unlock put starter disable and horn stay active, most good alarms have liftime module warranties, if you take it back to who installed it and ask them or if it was already in the car when you bought it then you will need to disable or replace it. hope this helps, also to disable it just trun key on then open a open try key off and within 10 sec push the button under the dash its a small red button this will put it in vallet mode.

Nov 10, 2010 | 2003 Toyota Corolla

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

206 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...