Question about 1998 Chevrolet S-10 Pickup

1 Answer

1995 S10 p/u no heat

I need to know why i have no heat in my 1995 chevy s10 p/u truck,i replaced the thermostat i still have no heat someone said there is a flap inside might need to be open? could someone help me with the problem.thks

Posted by on

  • Anonymous Apr 07, 2009

    i have no heat i put a new thermostat in it and i tryed to get the air pockets out but i can take off the heater hose off of the heater core while it is running and i get a very little water flow from the intake hose and no water flow from the water pump heater hose

  • tapanewkeg May 03, 2009

    I had the same problem, I found the heater core clogged with "mud". I CAREFULLY fulshed water through buth heater core hoses, alternately, until the flow increased, and the muddy water turned clear. Be very careful, too much water pressure from the garden hose can blow the heater core apart!

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 104 Answers

On these trucks if you have lost coolant in any way its very common to get air pockets in the rediculiously long heater hoses going in and out of heater core. when toping off coolant remove one of the hoses and make sure coolant flows out while someone fills radiator or resivor bottle if no radiator fill is avaliable.once coolant comes out quickly put hose back on and tighten clamp. Doing this will allow the coolant to flow through the engine and not create air pockets. START with that. its kinda like a bleed effect.

before doing all this a way to check if thats your problem feel the heater hoses. if they are not as hot as upper or lower radiator hoses when engine is normal temp.then they have air in them. all hoses should be somewhat hot to the touch. NOT WARM

good luck
Michael
ASE certified.

Posted on Feb 09, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1997 Chevy s10 blazer with a 4.3 v6 will a 1998 Chevy s10 blazer 4.3 v6 interchange


they should swap just fine. 1996 and on are interchangeable. 1995 could go either way. 1994 and older are interchangeable.

Apr 23, 2016 | Chevrolet S 10 Cars & Trucks

1 Answer

1998 Chevy S10 heating problem


Sounds like someone put too much radiator leak **** in it or used well water and stoped up the heater core. Take the hoses off the core and try back flushing it thru the heater core. I have found this to work sometimes....good luck.

Mar 11, 2010 | 1998 Chevrolet S-10 Pickup

2 Answers

I have a 2000 s10 pickup 2.2. No heat.


all chevys do that same thing the only thing i can say is put a small temp in the thermostat

Feb 11, 2010 | 2000 Chevrolet S-10

1 Answer

Need diagram of fuel system for 1995 chevy s10


The only way I know of to get the diagram you are looking for is to acquire a "build book". Even dealer service manuals don't have this diagram. I got one from faxonautoliterature for $49 plus shipping. A better bet would be to find a spot on either end of the leak where you can work on it easily and work from there. Hope this helps.

Dec 02, 2009 | 1995 Chevrolet S-10 CA Edition

1 Answer

1994 Chevy S10 Pick-up 4 cylinder, sloshing noise, no heat......is this a heater core problem?


no heat on this old of a vehicle definitly can indicate a heater core problem. sometimes flushing core with a hose can save heater core sometimes it will need replaced. make sure all coolant is properly disposed of if u flush core yourself

Nov 07, 2009 | 1995 Chevrolet S-10 CA Edition

2 Answers

1995 Chevy S10. The transmission (4L60E) has been


HI YOU MAY HAVE A BAD IGNITION SWITCH OR YEST A BAD SHIFT SOLENOID 3-4

Jun 25, 2009 | 1995 Chevrolet S-10 CA Edition

2 Answers

Heater 1998 chevy s10


You need to check your coolant level first. If it is low you have a coolant leak. No hot coolant=No heat

Jun 22, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

S10 Transmission


the front pump is no good replace the trans

Jan 18, 2009 | 1995 Toyota Corolla

1 Answer

2000 chevy s10 bad thermostat


the thermostat is located just above the fan shaft, or ontop of the water pump. at least on the 2.2? and 4.3l engines. Which i think was only available. You may have to remove the plastic Vortec cover to see it.

Jan 10, 2009 | 1997 Chevrolet S-10 Pickup

Not finding what you are looking for?
1998 Chevrolet S-10 Pickup Logo

730 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...