Question about 2000 GMC Jimmy

Open Question

How to replace door latch on driver door 2000 gmc jimmy

Latch broken

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 274 Answers

SOURCE: Drivers Side Door Handle

You need to take inside door panel off This just clips on but there are screws in armrest and inside door handle look for any other small square covers that may hide screws Lift panel up Make sure window is up Disconnect wiring from panel and you can now get at door handle linkage and bolts

Posted on Jul 10, 2009

  • 1 Answer

SOURCE: 2000 GMC Jimmy won't start

i had the same problem and replaced the fuel pressure regulator. Cost about $45 at advance auto store or about $90 at napa auto stores. Once i replace that my truck started right yup and runs like a champ

Posted on Jul 13, 2009

  • 34 Answers

SOURCE: how do you replace a fuel pressure regulator on a

it is located inside the manifold,

Posted on Jan 05, 2010

  • 593 Answers

SOURCE: 1998 GMC Jimmy hood release cable broken

Remove the cable from the latch and any hold downs or clamps. Push the rubber gromet through the fire wall into the car. Remove the handel assy. and pull
the cable assy.out through the fire wall. Now, if the
gromet can be removed. You can decide if you wan't
to put it back from under the dash, or under the hood.
Whatever is easiest for you, but if it can't, it has to go
back from under the dash. Hope this helps.
Good luck.

Posted on Jan 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I open the hatchback from inside(or outside) in my 2000 GMC Jimmy if its broken and won't open from the outside?


you will need to remove inside door panel and find rod from handle to latch and pull it and push door

Feb 21, 2015 | 2000 GMC Jimmy

1 Answer

In my GmC S-15 Jimmy the dome light and courtesy lights stay on when car is off and doors are shut help me fix this


Your door switch is made into the door latch, you might try spraying WD-40 into the drivers door latch and work the latch open and closed. You will probably end up having a new latch installed though.

Apr 23, 2013 | 1997 GMC Yukon

1 Answer

2000 gmc jimmy driver's window stop working but all others work


with key on door open, hold switch in down position and rap door panel with rubber mallet...if it works, need motor, if not, check switch for power

Mar 01, 2013 | 2000 GMC Jimmy

1 Answer

2000 gmc jimmy drivers window doesn't work but all others work


With key on door open, hold switch in down position and rap door panel with rubber mallet...if it works, need motor, if not, check switch for power out to motor

Mar 01, 2013 | 2000 GMC Jimmy

2 Answers

Driver door wont close- latch on door is jammed


The claw on the latch is probably just latched without the striker being in it. Try holding one of the door handles in the open position and use your finger to rotate the latch to the open position then release the handle and see if it will shut. Hope that helps

Feb 02, 2011 | 2000 GMC Jimmy

1 Answer

2000 GMC Jimmy 2wd My back window will not open.I neeed to get into the door to find out what latch part needs replaced.I cannot drop the tail gate until I get the door panel off. Howw do I get the panel...


If you go on the inside of the door see if there are any screws or a place where you can pry off the inside of the tailgate there should be a carpet type material in there you have to go behind it to get at the latch or try and fiddle with it on each sides of the gate.

Jan 02, 2011 | 2000 GMC Jimmy

1 Answer

2000 gmc passanger door wont close. the latch is stuck. how do i unstick it so that the door will close again?


Hold the outside handle up and then press on the latch that is stuck in locked position..it should open

Oct 08, 2010 | 2000 GMC Jimmy

2 Answers

Driver side door does not close. Latch broken and door sits down below catch on body of car.


may need new hinges on door and body of vehicle, if so it is about 600 -700 to replace , may be able to get new bushing and pins , without replacing hinges

Sep 09, 2010 | 1998 GMC Jimmy

1 Answer

I have an 89' GMC Jimmy and the driver's and passenger door will not close. It won't even pull to. What should I do?


Sounds like the latch is in the closed position. does it bounce back open? Its like a hook latch, pull the door handle to open it and at same time pull the latch out. And it should move out and leave it open for the pin to go into it.

May 11, 2010 | 1989 GMC S-15 Jimmy

Not finding what you are looking for?
2000 GMC Jimmy Logo

Related Topics:

104 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...