Question about 1998 Ford F150 Regular Cab

Open Question

How to remove cowl on 1998 F150 - 1998 Ford F150 Regular Cab

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove the wiper cowl unit from a 1998 chev pu 1500


On most, remove the screws at the forward edge (sometimes hidden by rubber cowl seal), remove wipper arms, lift cowl and slide towards the front to release the rear edge, done!

Feb 27, 2015 | Chevrolet 1500 Cars & Trucks

1 Answer

How do you get the cowl removed to replace windshield wiper motor 1998 Buick Skylark


find and remove all screws. Remove rubber trim from engine compartment. Take wiper arms off and the cowl should come off

Feb 05, 2011 | 1998 Buick Skylark

1 Answer

Location of ecm on f150 2001


Powertrain Control Module (PCM) Removal and Installation
  1. Disconnect the battery ground cable.
  1. Disconnect the powertrain control module (PCM) electrical connector.
bb45a1b.gif


Remove the right front door scuff plate.
bb7fcba.gif


  • Remove the right cowl side trim panel.

  • 33976d7.gif

  • Remove the clip and remove the PCM.

  • 6269f6f.gif

  • To install, reverse the removal procedure


  • Hope this helps ya.. :-)
  • Jul 21, 2010 | 2001 Ford F150 Styleside SuperCrew

    1 Answer

    1998 F150 wipers wiggle but wont move


    more than likely the arm popped of the wiper transmission you will need to remove both wiper arms and the wiper cowl to inspect

    Jan 30, 2010 | 1998 Ford F150 Regular Cab

    1 Answer

    Wipers don't move but you can hear motor


    remove the window lower trim molding

    remove the 5 screws to remove the cowl

    you may need to partially close hood to remove the cowl.

    Remove wiper motor cover if nessasary.

    Dec 26, 2009 | 1988 Ford F 150

    1 Answer

    Cabin air filter


    it;s under the cowl vent panel.

    Cowl Top Vent Panel Removal
    1. Remove the windshield wiper pivot arm (17526) . Refer to Section 01-16 for the removal procedure.
    1. Remove the front door weatherstrip (20530) to access the windshield outside side moulding screws.
    b981661.gif
    1. Remove the five windshield outside side moulding screws and the windshield outside side moulding (03136) .





    1. Pull the windshield outside moulding (03144) from the windshield glass (03100) .
    1. Remove the three Phillips-head screws from the cowl top vent panel (022A68) .


    9bc8ed6.gif

    1. Remove the three plastic screws by turning them 90 degrees to unlock.





    1. Remove the six pushpins from the front edge of the cowl top vent panel .
    1. Lift up on the cowl top vent panel and disconnect the windshield washer hose (17A605) at the Y-connector.





    1. Remove the cowl top vent panel .

    Mar 15, 2009 | 1998 Mercury Villager

    1 Answer

    My left windshield wiper on 1998 ford f150 has stopped working. The rignt one still works.


    Check the wiper armature, sometimes the pins come loose that connect both sides to the wiper motor, the armature should be located under the cowl at the firewall, you will see the metal arm assemblies under it, just check to see if one of them came loose. Hope this helps.

    Mar 10, 2009 | 1998 Ford F150 Regular Cab

    1 Answer

    1998 f150 ford wipe linkage


    I had a similar problem the plastic in front of the windshield is the cowl. to remove it I had to pop plastic cover over nuts holding wiper arms. remove them then remove all the screws and two plastic pop retainers and a rubber strip and a number of slide on clips to remove the two piece cowl then remove the electrical plug on the motor and three hex head screws holding the assembly in place (if you extend the linkage toward passenger side it will be easier to remove the assembly) you can get
    replacement bushings on line at www.rockauto.com I couldn't find them locally here but did find them
    on line . the ones I got are wiper linkage bushings help part no 49451 they are difficult to remove so I cut the worn ones off then used a proper sized socket and c clamp to install the new ones
    bigbobpa

    Jan 09, 2009 | 1998 Ford F150 Regular Cab

    1 Answer

    Windshield wiper arm on passenger side won't move.


    It will not be the motor, it will be the linkage or the wiper is slipping on the shaft, the lingkage is accsessible under the cowl, Hope this solves your problem and Merry Christmas

    Dec 22, 2008 | 1998 Ford F150 Regular Cab

    Not finding what you are looking for?
    1998 Ford F150 Regular Cab Logo

    Related Topics:

    30 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Ford Experts

    yadayada
    yadayada

    Level 3 Expert

    76649 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22219 Answers

    fordexpert

    Level 3 Expert

    5537 Answers

    Are you a Ford Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...