Question about 1988 Plymouth Sundance

1 Answer

88 Plymouth Sundance

Sounds like it's the MAP sensor that's causing the problem. Where do I find this piece, and can it be fixed or does it need to be replaced.

Thanks again....you've been very helpful

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 49 Answers

I don't have a manual for the 1988 Plymouth Sundance, but I'll see what I can find.  You would replace it.  If you/your daughter plan to keep the car for a whle (and you plan to be her mechanic), I would recommend purchasing a Haynes manual for it.  As soon as my vehicles' warrantees expire, I buy the manuals. The MAP (Manifold Absolute Pressure) sensor is usually connect to the air duct near the intake manifold.  Looks like for your car they run from $40-$70, depending on your engine size and turbo or not.  Good luck!

Posted on Jan 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What code 44 on a plymouth sundance 1991


Generally speaking, code 12 means the battery has been disconnected at some point in time.
Code 44 means the battery temp sensor circuit is out of normal range, too high or too low.

Oct 03, 2012 | 1988 Plymouth Sundance

1 Answer

Were is the M A F SENSOR PLYMOUTH 93 SUNDANCE


chrysler does not use a MAF sensor on any of there engines. They use a MAP sensor (mass air pressure). What engine to you have?

Jul 26, 2012 | 1993 Plymouth Sundance

1 Answer

Code 51 on a Plymouth sun dance. How do I fix it?


Code 51 = Oxygen sensor stuck in lean mixture mode. ( this will often cause engine to run rich due to oxygen sensor telling engine controller that it is running lean, thus send more fuel) This may be caused by M.A.P. sensor as well, so check vacuum lines and clean connections on MAP sensor first. It should be one of 2 things, Fault from MAP sensor, or faulty oxygen sensor.

Nov 01, 2010 | 1990 Plymouth Sundance

1 Answer

Where and how the o2 sensor goes on a 1994 plymouth sundance


Oxygen sensor is going to be on your exhaust somewhere between the exhaust manifold and right before it goes into the catalytic converter. Some of them screw in

Oct 10, 2009 | 1994 Plymouth Sundance

1 Answer

I need all the engine diagnostic codes for a 94 plymouth sundance


11 Timing belt2.gif skipped 1 tooth or more from initial learned value, Intermittent loss of either camshaft or crankshaft position sensor, No crank reference signal detected during engine cranking
12 Direct battery input to PCM/ECM was disconnected within the last 50 key-on cycles (normal)
13 No change in MAP from start to run
14 MAP sensor voltage too low
15 No vehicle speed sensor signal
17 Closed loop temp not reached or engine cold too long
21 02s sensor problem (oxygen sensor), upstream or down stream
22 Engine coolant temp sensor out of range
23 Intake air temp sensor out of range
24 Throttle Position sensor out of range
25 Idle air control motor circuits, target idle not reached (+/- 200),vacuum leak found
27 Injector control circuit
31 Evap purge flow monitor failure or evap solenoid circuit
32 EGR system failure
33 A/C clutch relay circuit
34 Speed control Solenoid circuits
35 Rad Fan control relay circuit
37 Torque converter clutch solenoid CKT or park/neutral switch failure
41 Generator field not switching properly
42 Fuel pump relay control ckt, Auto shutdown relay control ckt, No ASD relay output voltage at PCM, Fuel level sending unit volts out of range, Fuel level unit No change over miles
43 Multiple/ single cylinder misfire
44 Battery temp sensor volts out of range
46 Charging system voltage too low
51 Fuel system lean
52 Fuel system rich
53 Internal control failure
54 No Cam signal at PCM
55 End of error messages (If you get this only, no errors were found)
62 PCM failure SRI mile not stored
63 PCM Failure EEPROM write denied
64 Catalytic Converter Efficiency Failure
65 Power steering switch failur

Jul 08, 2009 | 1994 Plymouth Sundance

1 Answer

93 Sundance stutters and jerks on acceleration


It hooks up to the diagnostic port by the battery. But it sounds like you need plug wires.

Jun 11, 2009 | 1993 Plymouth Sundance

1 Answer

Replacing the heater core on a '88 Plymouth Sundance?


Behind the dash. You will have to pull the whole dash assembly. It looks like a little radiator.

Mar 28, 2009 | 1988 Plymouth Sundance

1 Answer

'88 Sundance wiper arms disconnect


I have located a chilton manual CD online that I am will have in two days. Just hope it doesn't rain between now and then.

Dec 01, 2008 | 1988 Plymouth Sundance

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

177 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...