Question about 2008 Dodge Grand Caravan

Open Question

Drove slippery road now esp bas light on

Now esp bas light stay on

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2006 dodge magnum shutterd on the hwy, esp bas light came on with

Dodge has a bulletin for this but it must set a code. The valve keepers have an updated design , also there have been some problems with lifters. Dodge will not do this under warranty unless they can reproduce the problem. I have this happen intermittantly
over 3 times a week. Dlr won't touch it!!!

Posted on Jul 01, 2009

Ad
  • 99 Answers

SOURCE: 2005 magnum esp/bas and engine light on

you need to see what the eng lite for if there is a trans codes usually the pcm wont let the speed go over 40 stays in safe mode untill you fix the problem or change the sensor,for the esp you need to chage the esp sensor and recalibrate by the dealer

Posted on Jul 21, 2009

tneubauer
  • 437 Answers

SOURCE: my esp/bas light and the red airbag and abs lights

ESP = Electronic Stability Program
BAS = Brake Assist System

Posted on Jan 13, 2010

kapishtech
  • 2272 Answers

SOURCE: the ESP/BAS light keeps coming

Have you unhooked your battery for something? You might try making sure the stability control's steering sensor is correct...

Basically, start the car turn the wheel all the way left to the stop, all the way right, then back to center. This lets the stability control know where "center" is.
Try this:
1) Disconnect your battery, wait 1 minute & just turn on the lights for a second as to remove any residual current from the computer.The lights will not come on but still turn ON.
2) Re-connect the battery, this should have cleared all of the lights except for the ESP\BAS light.
3) Start the car, center the wheels, turn all the way to the left then all the way to the right. This should clear the ESP\BAS light.
------- If still the same problem then the esp/bas module needs to be checked and reprogrammed by the dealer to turn it off. Thanks. Keep updated for any more query. You can rate this solution and show your appreciation

Posted on Sep 04, 2010

tunde007
  • 2382 Answers

SOURCE: ESP/BAS warning light on. went

Hi, these systems are all linked together. Most commonly, one of the wheel speed sensors is not reading or is reading incorrectly. This can also occur on slippery surfaces where one or more wheel slides enough to cause the sensor to drop the signal, but not enough to meet criteria for an abs or esp episode. If the light comes back every time you turn on the ignition, there is a deeper problem.
The system has detected a fault in the electronic stability program - brake assist system. You have an electrical connection at the rear wheels secured to the inside of the brake area and are viewable from under the vehicle. It is a small wire harness running to each wheel. Grab the connector and wiggle it around, and make sure they are tight. Due to the connector being mounted low to the ground, sometimes they become dirty or corroded, not making contact. Do this on both sides and see if the lights turn off.

If the light does not turn off, you have to replace dynamics sensor, which is mounted UNDERNEATH the center console in the car. There is a "lost communication to dynamics sensor" and "low voltage to dynamics sensor supply"..

Posted on Feb 13, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My esp/bas light stays on


the operators manual is clear on that, did you read that first?
it says "get the car serviced" clearly
if you work on cars, do you? thne we scan the systems with the scan tool first. to see if there are complex hard errors.
like the ABS sensors, (not bas) sensor dead. (ops a road hazard hit it and broke the wire there, dang.
then if no hard failures.
first is not ESP (that be last dead last)
the first is , the brake must work perfect if not , the ABS can not
work correctly with bad brakes.
so check fuses.
scan ABS for errors
then do a full brake inspection, takes me 2 hours. but my guess,
youve never done brakes, right,, your self?
not even a full inspection?
  1. leaks? (fluid)
  2. pads worn out?
  3. caliper pistons not sticking
  4. rotors not cracked, or wrecked, surfaces.
  5. caliper guide pins not seized. (they float free?)
  6. emg, brake not sticking on partially?
  7. wrong sized tires on car (or just one , omg)
  8. ABS sensor parts damaged at axles ends.?
  9. bad wheel bearing, seizing or loose.
etc... etc.... and more.

Feb 05, 2015 | 2006 Jeep Grand Cherokee

2 Answers

Why has the ESP and BAS lights come on in my 2006 Jeep Liberty?


Doesn't seen like anything, until you road test with
scan tool & look at data

Aug 09, 2014 | 2006 Jeep Liberty

1 Answer

Esp driving


location not stated, or road conditions. nor if in 4low , nor if the ESP switch is off or on. Ask Suzuki for help (lol) or any ASE shop.

it's not magic, it can not give traction , if none.
on ice slow down. (esp can do that too. slow you,brake you and even
shift gears in the transmission)

are you in 4wd? or high 4Low, esp is inactive. (or limited)
read the operators guide. (if lost, get one now)
read the page on driving on ice.
chapters 5,6,7.
have you had any off these conditions , related to ESP, this a
is the ESP light acting wrong, or CEL check engine light running?
are all dash lamps (warning) showing correctly per the opr. guide?
ESP & ABS are vary complex, (not magic)


quote from the servise manual. (car battery dead or disconnected?)
ESP control module
When ESP control module is removed / installed, do
not use impact wrenches which generate shock or
impact to avoid damaging sensors in ESP control
module.
Note that Calibrate word here..!
When any of the following operation is done, calibrate
steering angle sensor, G sensor and master cylinder
pressure sensor (in ESP control module) referring to
"Sensor Calibration in Section 4F
- When battery or dome fuse is removed. (
a low battery or weak)
- When steering angle sensor is replaced.
- When ESP control module is removed.
- When yaw rate / G sensor assembly is removed.



read this, it covers this system well,

http://www.wkjeeps.com/wk_esp.htm

read page 7-2 here (the do not drive words)
http://www.autodealertools.com/quickQuote/manuals/2007/Grand%20Vitara.pdf

this car has no center differential. (read limits there of)
are you using chains on the tires?
oper guide page 4-6 , read that yet?

If the vehicle speed is greater thanapproximately 30 km/h (19 mph), the ESP systems (other than ABS) will turn
on automatically and the light will go out.
When the transfer switch (if equipped) is
turned to the "4L LOCK" position, the

ESP systems (other than ABS) will be canceled automatically. The light will come on and stay on.
• If the ESP systems operate continu-ously such as when driving on slippery roads, the traction control functions of the ESP systems may be canceled temporarily to avoid overheating the brake pads, and the light will come on. After a short period of time, the ESP.

(this latter cut out happens, with wild driving)

Dec 05, 2013 | 2007 Suzuki Grand Vitara 4WD

1 Answer

I have an 06 Dodge Magnum. ESP/BAS light


Whenever this warning or any other stays on in the dash it id indicating that the systems control module has detected a fault, it then disables the system as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Sep 19, 2012 | 2006 Dodge Magnum

1 Answer

What does esp bas mean and the slippery when wet symbol displays on the dash board?


This light comes on when the computer sees the wheels spin, for example if a wheel spins faster than another this light will come on , this is to tell you its slippery out, if this light stays on then there may be a problem with the system and a scan tool is needed to see what the problem is, the computer will store codes listing what part of the system has failed and it will turn the system off because its not working correctly.also some cars have a switch where you can turn the system off yourself, the dash would then say esp/bas off but if it just stays on then you have a problem with the system, if it turns on and goes back off then its okay. good day.

May 22, 2011 | Dodge Durango Cars & Trucks

2 Answers

BAS/ ESP light on the dash bord stays on all time the car engine is running


The BAS stands for Brake Assist System, don't remember what ESP stands for.
But the first thing to do is make sure the brake lights go on when you hit the pedal.
If not, then replace the brake light switch above the pedal.
If that is not it, it could be many things, such as a bad lateral acceleration switch.

Feb 03, 2011 | 2001 Mercedes-Benz E-Class

2 Answers

ESP/BAS WARNING LIGHT COMES ON AND STAYS ON SOME TIMES. HOW DO I KNOW IF THE ESP IS WORKING


If the ESP light is on, the system is not functioning. have your dealer look at and replace your Brake Light Switch

Dec 06, 2009 | 2006 Jeep Grand Cherokee

2 Answers

VW Jetta ESP issue


unless there is a ESP button (some cars have this feature, yours does not) no u can't turn it off. Have the system scanned by the dealer for trouble codes to help isolate the problem

May 29, 2009 | 2003 Volkswagen Jetta TDI

Not finding what you are looking for?
2008 Dodge Grand Caravan Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...