Question about Chevrolet Silverado 1500

1 Answer

99 chevy silverado 4x4 makes noise while turnig in 4 wheel drive

Only does it in 4 wheel whole turning

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Front axle needs replacing. Joints worn. Is it a poping noise?

Posted on Jan 19, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
keemo68
  • 1263 Answers

SOURCE: 99 nissan pathfinder 4 wheel drive once put into 4 wheel drive popping noise underneath the vehicle

that sounds like a bad universal joint on the transfer case to the front axle. have that checked out

Posted on Oct 01, 2008

  • 6982 Answers

SOURCE: 99 Silverado 4-wheel drive not engaging

It does not seem that sufficient diagnosis was done. No, you cant give a specific diagnosis like that without tearing unit down. It's likely that they told you the most common failure and left it at that. Likely there is a problem with your unit...I think this becomes more of a trust issue than a mechanical one. A second opinion from an independent reputable shop may help but either way, you need to have it fixed. In not using it much, it makes me wonder how it got worn.
good luck

Posted on Mar 19, 2009

  • 1 Answer

SOURCE: Rear end in 1999 chevy 1500 binds on turns

well i had the same problem everyone told me the clutches in the rearend were sticking making it stick in positive traction (only your passanger side rear wheel pulls unless you start spinning then a type of clutch engages the other side so you have traction then when you stop spinning it disengages it should never be engaged if your on pavment) now you can do what i did listen to everyone when they tell you its normal or you can take it to someone with experience now and save yourself some money cause it will start popping then it will get some viberation then next it will break the clutches and when that happens you will have to replace the pinion,ring,and the spider gears as well as the clutches.make sure you have pleanty oil in rearend if you dont add the limited slip conditioner it might free clutches up but if i had it to do over id put it in the shop or stop driving it before i broke something hope this helped

Posted on Mar 30, 2009

  • 7 Answers

SOURCE: 2004 chevy silverado 1500 4 wheel drive wont work..

try selecting from nutreul or less then 3km

Posted on Feb 20, 2010

  • 396 Answers

SOURCE: 1999 chevy silverado service 4 wheel drive light

I had a similar problem with the Service 4 Wheel Drive light which came on intermittently then became more consistent in the message center display. It would go into 4 wheel drive if the message center did not display the Service 4 Wheel Drive message in the message center, but not when the message was displayed. I found the transfer case switch module in the dash was defective, and it has been working with no other problems for three years.

Posted on Jul 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My 2002 chevy silverado 4x4 will not disengage from 4 wheel lo to 4x4 hi, 2 wheel drive or 4x4 auto. I tried while driving forward , backwards and sitting. The 4x4 activates by push button. Any...


The issue is usually loaded gears. The secret is to try circles, one way and then the other. This preload is why 4x4 is supposed to be used on loose surfaces....The gears will disengauge after they unload.

Feb 23, 2011 | 2002 Chevrolet Silverado 1500

1 Answer

My 99 chevy silverado 4x4 doesnt work switch indicator lights dont light up ive changed the switch any ideas


can not get the lights to come on or go into four wheel drive bought new four wheel drive switch for dash but didnt help

Dec 12, 2010 | 1999 Chevrolet Silverado 1500

1 Answer

4x4 quit working


Jack up the rear wheels and put it on jack stands. Have someone get in it and put it in 4wd and drive. Release the brake. Rear wheels are spinning only right. Don't get under it but look under it and see if the front driveshaft is spinning. If the shaft is spinning but the wheels aren't it is likely a bad front axle actuator. If the front shaft isn't spinning it is a transfercase problem.

Jul 18, 2010 | 1999 Chevrolet Silverado 1500

2 Answers

2004 chevy silverado 1500 4 wheel drive wont work..


try selecting from nutreul or less then 3km

Feb 02, 2010 | 2003 GMC Sierra

2 Answers

2000 Chevy Silverado 1500 4 wheel drive makes a scraping noise when turning


check the cv axles for wear such as torn rubber boots, when in 4 wd the noise should be even worse

Sep 15, 2009 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

99 Silverado 4-wheel drive not engaging


It does not seem that sufficient diagnosis was done. No, you cant give a specific diagnosis like that without tearing unit down. It's likely that they told you the most common failure and left it at that. Likely there is a problem with your unit...I think this becomes more of a trust issue than a mechanical one. A second opinion from an independent reputable shop may help but either way, you need to have it fixed. In not using it much, it makes me wonder how it got worn.
good luck

Mar 19, 2009 | 1999 Chevrolet Silverado 1500

2 Answers

Rear end in 1999 chevy 1500 binds on turns


well i had the same problem everyone told me the clutches in the rearend were sticking making it stick in positive traction (only your passanger side rear wheel pulls unless you start spinning then a type of clutch engages the other side so you have traction then when you stop spinning it disengages it should never be engaged if your on pavment) now you can do what i did listen to everyone when they tell you its normal or you can take it to someone with experience now and save yourself some money cause it will start popping then it will get some viberation then next it will break the clutches and when that happens you will have to replace the pinion,ring,and the spider gears as well as the clutches.make sure you have pleanty oil in rearend if you dont add the limited slip conditioner it might free clutches up but if i had it to do over id put it in the shop or stop driving it before i broke something hope this helped

Mar 10, 2009 | 1999 Chevrolet Silverado 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...