Question about 2000 Ford Windstar

1 Answer

2000 Ford Windstae Air Filter Replacement

How do I remove and replace the air filter on a 2000 Ford Windstar?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 840 Answers

The iar filter is abox about 12 inches long and 6 inches wide and is uynder the hood in engine compartment there should be clasps just pop them oof and replace

Posted on Jan 25, 2009

  • Marc Podeszek Jan 27, 2009

    Please rate my response. Thank you !

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Windstar is "chugging"


Ok Check Your Tranny For Fluids And Check Your Spark Wires too For Breaks And fuel Filter wood Not Hurt too and the fuel regulator As well And don,t forget heater resistor for your heat problem,s or your Fuse to give heat and Last Check the blower for moving replace it then and then check cabin filter to make the Air Better too and don,t for get the switch last to make it come on Ok Thank,s

Jan 07, 2014 | 2001 Ford Windstar

1 Answer

WHERE IS THE INSIDE CABIN AIR FILTER ON 2008 FORD EDGE LIMITED


The cabin air filter is located behind the glove box. Open it then empty all contents. Grab both sides inside the box and push them inward. The glove box will then drop out further. On the left side is a catch cable. Slide that down and pull it out. The box should then just pull out. The cover for the filter is rectangular and gray or black color. On the left side push the tab toward the passenger door and pull toward you. You will either find nothing or a screen. Discard the screen and insert the new filter.
2011 Ford Edge cabin air filter removal and replacement

Feb 02, 2013 | 2008 Ford Edge SEL

1 Answer

Can it be anything other then the air filter


Need more details is the engine light on? Check for vacuum leaks, idle air control motor, clean the mass air flow sensor and throttle body.

May 22, 2012 | 2000 Ford Windstar

1 Answer

I need to find where the MAF wire plug harness is in my 2003 Ford Windstar to be able to clean the Mass Air Flow sensor. Where would I find that?


What? Why are you looking for wires?

Just unplug them,remove the sensor and
spray with CRC MAF Cleaner

Every MAF Sensor on any vehicle, has to be
in the ducting between the air filter housing
and the throttle body

Only one sensor and one set of wires on the
air intake ducts,your pal the MAF

Dec 04, 2010 | 2000 Ford Windstar

1 Answer

Changing cab filter in 200 ford f150


If you are talking about the cabin air filter, this filters the outside air for the HVAC.
Hastings Filter (#AF1057) shows one for the 97-03 MY trucks.

Remove the screws that hold the horizontal filter housing cover from behind the glove box (no need to open the glove box);

Pull the cabin filter straight down (sits vertical behind the glove box inside the housing).

Install replacement and reattach the cover.

Sep 18, 2010 | 2000 Ford F150 Flareside SuperCab

1 Answer

My 2003 ford windstar has bad hesitation during exceleration, feels like transmission not shifting properly . once up to speed its ok


drain your transmission,and while you have the pan off,replace the transmission filter. refill to level specs. also replace the air filter and pcv valve.

May 01, 2010 | 2003 Ford Windstar

1 Answer

1998 Ford Windstar 3.8L ScanTool says that Bank 1 is lean


if your getting oil in the air filter area, you have a leaking intake gasket or a leaking head gasket, run a compression test on it,
if the compression is where it should be on all cylinders then its a leaking intake gasket!!!

Mar 04, 2010 | 1998 Ford Windstar

2 Answers

MY 98 FORD WINDSTAR STALLS WHEN I IDLE OR COMING TO A STOP I'VE CHANGED AIR FLOW SENSOR, AIR FILTER, SPARK PLUGS, AND FUEL FILTER ANY IDEAS?


I'd be looking at removing IAC valve, and cleaning it out with throttle body spray cleaner, and checking mounting gasket as well. Usually some success with cleaning it & spray ports it came out of, but if not you may need to replace it.

Oct 12, 2009 | 1998 Ford Windstar

2 Answers

Have a 2000 Ford Ranger SuperCab, 4.0 4x4 AirConditioner isnt blowing air. Compressor seems as if it is coming on and working properly. Airconditioning unit inside truck sounds Normal (ie: turn fan on,...


I had a problem with my 2000 ranger when I bought it. Air was coming out of defroster vents. Check for a vacuum hose that may be off under the hood. It uses vacuum to open the vents.

Aug 01, 2009 | 2000 Ford Ranger SuperCab

1 Answer

Oil leaking into the air filter?


a bad pcv valve causes oil in the air filter housing the hose runs to the pcv valve

Apr 11, 2009 | 2000 Ford Windstar

Not finding what you are looking for?
2000 Ford Windstar Logo

Related Topics:

102 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...